Huawei Technologies PRA-LX3 Smart Phone User Manual Nova lite dual
Huawei Technologies Co.,Ltd Smart Phone Nova lite dual
User Manual
Quick Start Guide
1
For more information
Open
HiCare
to read the user guide and service
information or get help from the online forum.
Go to http://consumer.huawei.com/en/ to download the
user guide for your device and read the FAQ, privacy
policy, and other information.
Go to
Settings
>
About phone
>
Legal information
to
read the legal information.
Please visit http://consumer.huawei.com/en/support/
hotline/ for the most up-to-date contact information for
your country or region.
2
Your phone at a glance
Before you start, let's take a look at your new phone.
•
To turn on your phone, press and hold the power
button until your phone vibrates and the screen turns
on.
•
To turn off your phone, press and hold the power
button, and then touch .
To forcibly restart your phone, press and hold the
power button until your phone vibrates.
.JDSPQIPOF
4QFBLFS
-JHIUTFOTPS
.JDSP64#QPSU
&BSQJFDF
7PMVNFCVUUPO
1PXFSCVUUPO
'SPOUDBNFSB
4UBUVTJOEJDBUPS
)FBETFUKBDL
$BNFSB
'JOHFSQSJOU
TDBOOFS
'MBTI
3
Getting started
Follow the instructions in the following figures to set up
your phone.
• Do not insert or remove a SIM card while your
phone is on.
• Ensure that the SIM card is in the correct position
and keep the card tray level when inserting it into
your phone.
Please exercise caution when using the SIM ejector
pin to avoid hurting your fingers or damaging your
phone. Store your pin in a safe place out of the reach
of children to prevent them from swallowing it or
injuring themselves by accident.
Caution
Insert the SIM card into the correct card slot to
ensure that it can be recognized by the phone.
NJDSP4%
Or
4
Dual card dual standby single pass
Your phone supports only dual card dual standby single
pass, which means you cannot use both SIM cards for
calls or data services simultaneously.
•
When you are on a call using SIM card 1, SIM card 2
cannot be used to make or answer calls. If someone
calls SIM card 2, the caller will hear a voice message
similar to "The subscriber you dialed is out of the
service area" or "The subscriber you dialed cannot be
connected for the moment, please try again later."
The actual message will vary by service provider.
•
When you are using SIM card 1's data service, SIM
card 2's data service will be disabled.
Your phone's single pass feature helps reduce power
consumption and increase your phone's standby time. It
is not related to your service provider's network
conditions.
It may be a good idea to contact your service provider
and subscribe to missed call reminder and related
assistance services to avoid the conflicts mentioned
above.
5
Safety Information
Please read all of the safety information carefully before
using your device to ensure its safe and proper operation
and to learn how to dispose of your device properly.
Viewing the safety and regulatory
information
For more information on safety, touch
Settings
>
About
phone
>
Legal information
>
Safety information
.
For more information on regulation, touch
Settings
>
About phone
>
Authentication info
.
For more information on certification logos, touch
Settings > About phone > Certification logos.
Operation and safety
•
To prevent possible hearing damage, do not listen at
high volume levels for long periods.
•
Using an unapproved or incompatible power
adapter, charger, or battery may damage your
device, shorten its lifespan, or cause a fire, explosion,
or other hazards.
•
Ideal operating temperatures are 0 °C to 35 °C. Ideal
storage temperatures are -20 °C to +45 °C.
•
Pacemaker manufacturers recommend that a
minimum distance of 15 cm be maintained between
a device and a pacemaker to prevent potential
6
interference with the pacemaker. If using a
pacemaker, hold the device on the side opposite the
pacemaker and do not carry the device in your front
pocket.
•
Keep the device and the battery away from excessive
heat and direct sunlight. Do not place them on or in
heating devices, such as microwave ovens, stoves, or
radiators.
•
Observe local laws and regulations while using the
device. To reduce the risk of accidents, do not use
your wireless device while driving.
•
While flying in an aircraft or immediately before
boarding, only use your device according to
instructions provided. Use of a wireless device in an
aircraft may disrupt wireless networks, present a
hazard to aircraft operation, or be illegal.
•
To prevent damage to your device's parts or internal
circuits, do not use it in dusty, smoky, damp, or dirty
environments or near magnetic fields.
•
When charging the device, make sure the power
adapter is plugged into a socket near the devices and
is easily accessible.
•
Unplug the charger from electrical outlets and the
device when not in use.
•
Do not use, store or transport the device where
flammables or explosives are stored (in a gas station,
oil depot, or chemical plant, for example). Using your
device in these environments increases the risk of
explosion or fire.
7
•
Dispose of this device, the battery, and accessories
according to local regulations. They should not be
disposed of in normal household waste. Improper
battery use may lead to fire, explosion, or other
hazards.
•
Use only the following listed AC Adapters/Power
Supplies: HUAWEI: HW-050100E01, HW-
050100U01, HW-050100A01, HW-050100B01,
HW-050200E01, HW-050200U01, HW-050200A01,
HW-050200B01.
EU regulatory conformance
Body worn operation
The device complies with RF specifications when used
near your ear or at a distance of 0.5 cm from your body.
Ensure that the device accessories, such as a device case
and device holster, are not composed of metal
components. Keep the device away from your body to
meet the distance requirement.
PRA-LX2
: The highest SAR value reported for this device
type when tested at the ear is 0.36 W/kg, and when
properly worn on the body is 1.42 W/kg.
Statement
Hereby, Huawei Technologies Co., Ltd. declares that this
device is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC and
2009/125/EC.
The most recent, effective version of the DoC
(declaration of conformity) can be viewed at
http://consumer.huawei.com/certification.
The following marking is included in the product:
8
This device may be operated in all member states of the
EU.
Observe national and local regulations where the device
is used.
This device may be restricted for use, depending on the
local network.
Restrictions in the 2.4 GHz band:
Norway
: This subsection does not apply for the
geographical area within a radius of 20 km from the
centre of Ny-Ålesund.
FCC Regulatory Compliance
Body worn operation
The device complies with RF specifications when used
near your ear or at a distance of 1.5 cm from your body.
Ensure that the device accessories, such as a device case
and device holster, are not composed of metal
components. Keep the device away from your body to
meet the distance requirement.
Certification information (SAR)
This device is also designed to meet the requirements for
exposure to radio waves established by the Federal
Communications Commission (USA).
The SAR limit adopted by the USA is 1.6 W/kg averaged
over one gram of tissue. The highest SAR value reported
to the FCC for this device type complies with this limit.
9
PRA-LX3
:The highest SAR value reported to the FCC for
this device type when using at the ear is 0.89 W/kg, and
when properly worn on the body is 1.34 W/kg, and when
using the Wi-Fi hotspot function is 1.45 W/Kg.
FCC statement
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and
receiver.
--Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
this device must accept any interference received,
10
including interference that may cause undesired
operation.
Caution:
Any changes or modifications to this device not
expressly approved by Huawei Technologies Co., Ltd. for
compliance could void the user's authority to operate the
equipment.
Legal Notice
Trademarks and Permissions
and are trademarks or
registered trademarks of Huawei Technologies Co., Ltd.
Android™ is a trademark of Google Inc.
LTE is a trademark of ETSI.
The
Bluetooth
®
word mark and logos are registered
trademarks owned by
Bluetooth SIG, Inc.
and any use of
such marks by Huawei Technologies Co., Ltd. is under
license.
Wi-Fi
®
, the Wi-Fi CERTIFIED logo, and the Wi-Fi logo are
trademarks of Wi-Fi Alliance.
Privacy Policy
To better understand how we protect your personal
information, please see the privacy policy at http://
consumer.huawei.com/privacy-policy.
11
Copyright © Huawei Technologies Co., Ltd.
2016. All rights reserved.
THIS DOCUMENT IS FOR INFORMATION PURPOSE ONLY,
AND DOES NOT CONSTITUTE ANY KIND OF
WARRANTIES.
All pictures and illustrations in this guide, including
but not limited to the phone color, size, and display
content, are for your reference only. The actual
product may vary. Nothing in this guide constitutes a
warranty of any kind, express or implied.
底边留5mm
Note: Remember the Google account your phone
last logged in to.
During an untrusted factory settings restoration or
microSD card–based update, Google's anti-theft
mechanism requires you to enter the Google account
your phone last logged in to on the startup
navigation screen for identity authentication. Your
phone can properly power on only after the identity
authentication passes.
Model: PRA-LX2
PRA-LX3
31508286_01
Please visit
http://consumer.huawei.com/en/support/hotline for
recent updated hotline and email address in your
country or region.