Humax GFHD100 IP-set top BOX User Manual

Humax Co., Ltd. IP-set top BOX

Contents

User Manual

Download: Humax GFHD100 IP-set top BOX User Manual
Mirror Download [FCC.gov]Humax GFHD100 IP-set top BOX User Manual
Document ID1719456
Application IDgrsIgEcgoGuUF4x73Yw8vA==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeYes
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize43.34kB (541703 bits)
Date Submitted2012-06-05 00:00:00
Date Available2012-12-02 00:00:00
Creation Date2012-03-30 13:52:09
Producing SoftwareiText 2.1.6 by 1T3XT
Document Lastmod2012-06-11 16:11:02
Document TitleUser Manual
Document CreatorDocumill Publishor 6.3.9.1 by Documill (http://www.documill.com/)

TV Box
Important Product Information Guide
© 2012
DRAFT v0.1 - CONFIDENTIAL
3/30/12
This guide contains safety, handling, disposal, recycling and regulatory information.
To avoid injury to people or equipment, carefully read all safety information and
operation instructions contained in this guide before using your device.
Important Safety and Handling Information
Failure to follow these safety instructions could result in fire, electric shock, or other
injury or damage to the device or other property.
LOCATION
●
●
●
●
●
Place the TV Box indoors to avoid exposure to lightning, rain, or sun. Do not place it
near a radiator, a heat register, or an open window.
Maintain at least 4 inches (10 cm) of clearance between the TV Box and any other
appliances susceptible to electromagnetic influences, such as a TV or a VCR. However,
electronic devices that are not affected by electromagnetic influences can be located
closer to the device.
If you place the TV Box on a rack or a bookcase, make sure that there is adequate
ventilation and that you have followed the manufacturer’s instructions for mounting.
Do not place the TV Box on an unstable surface where it can fall. If the TV Box falls, it
can cause serious injury to a person and serious damage to the device.
If you have a Fat TV Box device, be sure it is not subjected to vibration, which could
cause data loss.
VENTILATION
●
●
●
Make sure that the slots on bottom of the TV Box are not blocked. Sufficient airflow
around the device is required for proper operation.
Do not expose the TV Box to an exposed flame.
Operate the device in a location where the temperature is between 0º and 40 C (32º to
104º F).
POWER SUPPLY
●
●
●
●
Operate the TV Box using only the type of power supply specified on the label. If you do
not know the type of power supplied to your home, contact your local power company.
Disconnect the power supply before you start any maintenance or installation
procedures.
The TV Box has no on/off switch. To disconnect the device from power, you must
disconnect the power cord. Make sure the power cord is always easily accessible.
When connecting or disconnecting the TV Box , always hold the plug by its sides. Keep
fingers away from the metal part of the plug.
OVERLOADING
●
Make sure that the wall outlet, extension cord, and adapter have a sufficient power rating
for the TV Box . If not, this can cause an electric fire shock.
CONNECTION TO THE TV
© 2012
DRAFT v0.1 - CONFIDENTIAL
3/30/12
●
Disconnect the power supply before you connect or disconnect the cable from the TV to
avoid causing damage to the TV.
ATTACHMENTS
●
●
Do not use any unsupported attachments, as these may be hazardous or cause damage
to the TV Box .
Do not move the TV Box if another device, such as a TV, computer, or other electronic
device, is connected to it.
WATER, LIQUIDS, WET LOCATIONS
●
●
●
Do not expose the TV Box to rain, liquids, or moisture.
Do not put any objects filled with liquid, such as vase, on the TV Box .
Do not use the TV Box outdoors. It is meant for indoor use only.
LIGHTNING, STORM, OR NOT IN USE
●
During a thunderstorm or when left unattended and unused for long periods of time,
unplug the TV Box from the wall outlet and disconnect the antenna. This prevents
damage to the device from lightning and power surges.
CLEANING
●
●
Disconnect the TV Box from the wall outlet before you clean it.
Use a moist cloth to clean the TV Box . Do not use solvents.
EXTRANEOUS OBJECTS
●
Do not insert anything through the openings in the TV Box , where they can touch
dangerous voltage points or damage parts.
REPLACEMENT OF PARTS
●
When replacement of parts is required, be sure the service technician uses replacement
parts specified by the manufacturer or those that have the same characteristics as the
original part. Unauthorized substitution can result in damage to the TV Box .
Repairing or Modifying the Device
Do not attempt to open the TV Box or disassemble it. Opening the device can
cause electric shock and voids the limited warranty. No user-serviceable parts are
inside.
Service should be provided by an authorized service provider only. If the TV Box has been in
contact with liquids, punctured, or subjected to a severe fall, unplug it and have it checked out
by an authorized service provider before using it.
Handling
The TV Box can be damaged by improper storage or handling. Be careful not to drop the
device when transporting it.
© 2012
DRAFT v0.1 - CONFIDENTIAL
3/30/12
Choking Hazard
The TV Box contains small parts, which could present a choking hazard to small children. Keep
the TV Box and its accessories away from small children.
Connectors and Ports
Never force a connector into a port. Check for obstructions on the port. If the connector and
port do not join with reasonable ease, they probably do not match. Make sure that the connector
matches the port and that you position the connector correctly before inserting it into the port.
Exposure to Radio Frequency Energy
The TV Box contains radio transmitters and receivers. When the device is on, it sends and
receives radio frequency (RF) energy through its antenna. The device is designed, tested1,
and manufactured to comply with the limits for exposure to RF energy set by the Federal
Communications Commission (FCC) of the United States. If you are concerned about exposure
to RF energy, you can further limit your exposure by turning off the Wi-fi and Bluetooth
functions.
This equipment should be installed and operated with a minimum distance of 20 centimeters between
the radiator and your body.
Additional Information
For more information from the FCC about exposure to RF energy, go to www.fcc.gov/oet/
rfsafety. The FCC and the U.S. Food and Drug Administration (FDA) also maintain a consumer
website at www.fda.gov/RadiationEmittingProducts/RadiationEmittingProductsandProcedures/
HomeBusinessandEntertainment/CellPhones/default.htm to address inquiries about the safety
of mobile phones. Please check the website periodically for updates.
For information about the scientific research related to RF energy exposure, see the EMF
Research Database maintained by the World Health Organization at: www.who.int/emf
Regulatory Compliance Information
FCC Compliance Statement
The TV Box complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) The device may not cause harmful interference, and (2) the device must accept
any interference received, including interference that may cause undesired operation. See
instructions if interference to radio or television reception is suspected.
Regulatory
Certification Number
FCC ID: O6ZGFHD100
The device was tested by VENDOR NAME, LOCATION according to measurement standards and procedures specified in FCC
OET Bulletin 65, Supplement C (Edition 01-01) and IEEE P1528.1, April 21 2003.
© 2012
DRAFT v0.1 - CONFIDENTIAL
3/30/12
Note: This equipment has been tested2 and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications and television reception. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
○ Reorient or relocate the receiving antenna.
○ Increase the separation between the equipment and receiver.
○ Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
○ Consult the dealer or an experienced radio/TV technician for help.
Important: Changes or modifications to this product not authorized by vendor could
void the EMC and wireless compliance and negate your authority to operate the device.
The TV Box has demonstrated EMC compliance under conditions that included the use
of compliant peripheral devices and shielded cables between system components. It
is important that you use compliant peripheral devices and shielded cables between
system components to reduce the possibility of causing interference to radios,
televisions, and other electronic devices.
This product was tested for FCC compliance under conditions that include the use of certified
peripheral devices and certified shielded cables and connectors between system components.
You can obtain certified peripheral devices and the proper shielded cables and connectors
through an authorized dealer. For non-certified peripheral devices, contact the manufacturer or
dealer for assistance.
Wireless Radio Use
This TV Box is restricted to indoor use when operating in the 2.35 to 5.25 GHz frequency band.
2 The device was tested by VENDOR NAME, LOCATION according to measurement standards and procedures specified in FCC
OET Bulletin 65, Supplement C (Edition 01-01) and IEEE P1528.1, April 21 2003.
© 2012
DRAFT v0.1 - CONFIDENTIAL
3/30/12
ROHS?
Model
Name
GFHD100
Power Supply
Input Voltage
100-240V ~
Type
50/60Hz, 1.0A
Power Consumption
12V
© 2012
3.34A
DRAFT v0.1 - CONFIDENTIAL
3/30/12

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
XMP Toolkit                     : 3.1-701
Producer                        : iText 2.1.6 by 1T3XT
Creator Tool                    : Documill Publishor 6.3.9.1 by Documill (http://www.documill.com/)
Create Date                     : 2012:03:30 13:52:09-07:00
Modify Date                     : 2012:05:24 18:22:26+09:00
Page Count                      : 6
Creator                         : Documill Publishor 6.3.9.1 by Documill (http://www.documill.com/)
EXIF Metadata provided by EXIF.tools
FCC ID Filing: O6ZGFHD100

Navigation menu