Hytronik Electronics HC428VRF Lighting Control Switch User Manual HC028VRF

Hytronik Electronics Co., Ltd Lighting Control Switch HC028VRF

User Manual

Block A6, Nan’pu Science & Technology Park, Hao’si, Shajing Street, Bao’an District, Shenzhen, P.R.C. 518104T: 86 755 27322200 F: 86 755 27308687 E: info@hytronik.com W: www.hytronik.com HYTRONIK ELECTRONICS CO.,LTDFSK 915MHz Antenna moduleLED indicationDaylight sensorRF antennaInstallation hole1-10VPushDetection areaHold-timeRotary coding switch(TX)Rotary coding switch(RX1)Rotary coding switch(RX2)Stand-by periodStand-by dimming levelBrightness on RF signalDaylight sensorHC428V/RF120~277VAC
3211H+0s10s1min5min10min30minIIIIIIIVVVIVIIVIII2110%20%30%50%IIIIIIIV5s30s
21Disable50Lux10Lux2LuxIIIIIIIVThis sensor is not only a master, but also a slave. It has three rotary switches, TX is for sending RF signal, RX1 and RX2 are Note: the sensor installed on first floor and top floor recieve one RF signal only, RX1/RX2 point to the same channel.forreceiving RF signal from two different groups of masters. Here is an example as below form FYI:Using a screwdriver to adjust the rotary switch on both the master & slave unit, to keep them pointing at the same channel, the grouping is then automatically completed. 16 channels (Max. 16 groups) available for both the master & slave unit.TX RXUsing a screwdriver to point the arrow to the same position on the master unit and slave units.master slaveFloor No.1234TX0123RX11012RX221345345645675676678Useful when sensor function is not needed in special occasion.
YDEMERESUACYDEMERESUACNOITCNUFLAMThe load will not workgnittestsujdAdetcelesgnitteslortnoc-thgiltcerrocnIdaolecalpeRytluafdaoLNOhctiwSFFOhctiwssniaMgnittesenozkcehCenoznoitcetedehtnitnemevomsuounitnoCnosyawlasidaolehTThe load is on without any identifiable movementThe sensor is not mounted for reliably detecting movement Securely mount enclosureMovement occurred, but not identified by the sensor (movement behind wall, movement of small object in immediate lamp vicinity etc.)1.Reduce sensitiviy.2.Check the movement behind walls, avoid facilities such as water pipe, fan, which may mistrigger the sensor. The load will not work despite movement Rapid movements are being suppressed to minimize malfunctioning or the detection radius is too small Check zone setting Note:the light turns on 100% and goes to sensor mode, even when the ambient lux excesses the daylight threshold.FCC NOTE：This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS OR CHANGE TO THIS EQUIPMENT. SUCH MODIFICATIONS OR CHANGE COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

Navigation menu