UserManual
FCCNotice
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception,
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR)
Information
SAR tests are conducted using standard operating positions accepted by the
FCC with the Phone transmitting at its highest certified power level in all tested
frequency bands, although the SAR is determined at the highest certified
power level, the actual SAR level of the phone While operating can be well
below the maximum value, in general, the closer you are to a Wireless base
station antenna, the lower the power output. Before a new model phone is a
available for sale to the public, it must be tested and certified to the FCC that it
does not exceed the exposure limit established by the FCC, Tests for each the
FCC that it does not exceed the exposure limit established by the FCC, Tests
for each required by the FCC. For body worn operation, this model phone has
been tested and meets the FCC RF exposure guidelines when used with an
accessory designated for this product or when used with an accessory that
contains no metal and that positions the handset a minimum of 10 mm from the
body. Non-compliance with the above restrictions may result in violation of RF
exposure guidelines.
The FCC has granted an Equipment Authorization for this model device based
on the compliance of all reported SAR levels with the FCC RF exposure
guidelines.
This device has a FCC ID number: RQQHLT-L55UTM [Model Number: TITAN
LTE] and the specific SAR levels for this device can be found at the following
FCC website: www.fcc.gov/oet/ea/.