Identec Solutions ILR-IPM352UH M352 UHF Module User Manual i PORT M352 UHF FCC Part 15 compliance statement
Identec Solutions AG M352 UHF Module i PORT M352 UHF FCC Part 15 compliance statement
Contents
- 1. Users manual
- 2. Integration instructions
Integration instructions
i-PORT M352 UHF Readers are only authorized with following antenna:
- Omnidirectional antenna: 289070 ILR – half-wave dipole antenna SMA i-CTA868 MH (2dBi) with
Tx Reg value set at 36
- Directional antenna: RFI Model: YBS806-82 (11dBi) with Tx Reg value set at 8
Module Final Product
FCC Part 15 compliance statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Radio Frequency (RF) Exposure Compliance of Radiocommunication for mobile Apparatus:
To satisfy FCC RF Exposure requirements for mobile devices, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during operation. To ensure
compliance, operation at closer than this distance is not recommended. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
Changes or modifications not expressly approved by IDENTEC SOLUTIONS could void the user’s
authority to operate the equipment.
End Product Labeling:
The final end product must be labelled in visible area with the following:
“Contains Transmitter Module FCC ID: OO4-ILR-IPM352UH” or “Contains FCC ID: OO4-ILR-
IPM352UH”
“This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.”
End Product User’s Manual:
The user manual for end users must include the following information in a prominent location
Radio Frequency (RF) Exposure Compliance of Radiocommunication for mobile Apparatus:
To satisfy FCC RF Exposure requirements for mobile devices, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during operation. To ensure
compliance, operation at closer than this distance is not recommended. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
FEK 05. September 2018
IDENTEC SOLUTIONS AG
Millennium Park 2
A-6890 Lustenau / Austria
Tel: +43 (0)5577 87387-0
Fax:+43(0)5577 87387 –15
info@identecsolutions.at
i-PORT M352 UHF Module
MANDATORY INTEGRATION INSTRUCTIONS
This document contains important information how to integrate the i-PORT M352 UHF
module into the final product.