Identiv UTRUST4711F-01 RFID Smartcard Reader User Manual
Identiv, Inc RFID Smartcard Reader Users Manual
Identiv >
Users Manual
uTrust 4711 F – User Manual
Version: 1.0 Page 1 of 4
User Manual
For
uTrust 4711 F
Version 1.0
Author
Sudhan
Version
1.0
Date
8-Nov-2017
uTrust 4711 F – User Manual
Version: 1.0 Page 2 of 4
Document History
Version
Date
Description of Change
Author
1.0
8-Nov-17
Initial version
Sudhan
uTrust 4711 F – User Manual
Version: 1.0 Page 3 of 4
Table of Contents
1 Scope of the document ....................................................................................................... 4
2 Identive uTrust 4711 F reader ............................................................................................. 4
3 Driver Installation in Windows ............................................................................................. 4
4 Communication with Card ................................................................................................... 4
uTrust 4711 F – User Manual
Version: 1.0 Page 4 of 4
1 Scope of the document
The user manual specifies the basic application of the reader by the customer.
2 Identive uTrust 4711 F reader
Identive uTrust 4711 F is a USB based dual interface reader capable of reading ISO7816
Contact smart cards and ISO14443 Contactless cards. The reader connects to a host PC via USB 2.0
Full speed interface.
3 Driver Installation in Windows
Follow the sequence of steps to install the driver
•Plug in the reader to a Windows PC
•The PC prompts for a driver
•Select Microsoft CCID driver and install the driver
•The device enumerates with Identive VID and PID strings
4 Communication with Card
Follow the sequence of steps to communicate with the contact card,
•Plug in the reader to a Windows PC and load the driver
•Launch the PCSCDIAG Utility
•Insert the contact card into the card slot of the reader
•Check the ATR of the card being displayed in the PCSCDIAG Utility
Follow the sequence of steps to communicate with the contactless card,
•Plug in the reader to a Windows PC and load the driver
•Launch the PCSCDIAG utility
•Place a contactless card on top of the reader
•Check the ATR of the card being displayed in the PCSCDIAG Utility.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Information to user
Changes or modifications not expressly approved by Identiv could void the user's authority to operate the equipment.