Ihome Ib12 Users Manual IB_07 31 2013

iB12 to the manual 3a203af3-d2ae-40c1-b109-596210837ec1

2015-01-21

: Ihome Ihome-Ib12-Users-Manual-348493 ihome-ib12-users-manual-348493 ihome pdf

Open the PDF directly: View PDF PDF.
Page Count: 2

CR1625X2
Model: iB12 (Front)
Print color : Black text on white paper
Size of manual: 130W x 220H (mm)
Date: Jul 31, 2013
Model: iB12
Using Your iHome Headphones
The earpieces are marked “L” and “R”. Place the “L” earpiece in your left ear
and the “R” earpiece in your right ear for proper fit and best sound. If the
earpieces are inserted incorrectly they will not fit properly in your ears and the
sound quality will not be satisfactory. For added stability the cables of these ear
buds should be looped over your ears as shown in the following illustration.
NOTE: Your iB12 headphones are supplied with three different size silicon tips
(S-M-L) for maximum comfort and to seal out unwanted noise. The “M”
(medium) size tips were installed at our factory. If you find that the installed tips
are too small or too large for your ears, you may remove them and replace
them with the larger or smaller size accessory tips. To replace the tips simply
pull them off the earpieces. To install different size tips, push them on to the
earpieces and make sure they are fully seated on each earpiece so that they do not come off when you
remove the earpiece from your ear. If one of the tips remains in your ear when you remove the
headphones, remove the tip carefully and avoid pushing it further into your ear canal. Seek medical
assistance if one of the tips becomes lodged in your ear and you are unable to remove it.
Connect the headphone plug to the headphone jack of your music player. Be sure that the plug is fully
inserted into the jack. If the plug is not fully inserted you may only hear sound from one earpiece.
To protect your hearing, always start listening with the volume control of your music source set to a low
level and then gradually increase the volume to a comfortable listening level.
LED Safety Flasher
Your iHome iB12 Ear Buds are supplied with a
LED safety flasher that includes a convenient
belt clip and an integrated cord wrap to keep
your cables tangle free. Remove the battery
pull tab before use.
Press the Mode Button on the front panel to
turn the flasher on and cycle through the 3
operating modes as follows:
First press – LED’s flash rapidly
Second press – LED’s flash slowly
Third press – LED’s ‘On’ continuously
Fourth press – LED’s ‘Off’
Replacing Batteries
Two CR1625 batteries that were installed at our factory should provide sufficient power for up to 96 hours
of continuous operation. When the lighting effect begins to dim or no longer turns ‘On’ you should replace
the batteries as soon as practical.
fitness earbuds
with clip-on LED safety flasher
+ cordwrap
Slide-out
Cord Wrap
Mode
Button
Battery
Compartment
Remove the battery
pull tab before use
To open, unscrew center screw
only and pull out the batteries tray
Install two fresh CR1625 batteries
in the battery tray as shown above
+
LITHIUM BATTREY
CR1625
3V
-
+
+
-
-
-
+
Belt Clip
Press here to open belt clip
Model: iB12 (Back)
Print color : Black text on white paper
Size of manual: 130W x 220H (mm)
Date: Jul 31, 2013
Limited One-Year Warranty Information
iB12-073113-A Printed in China
The LED flasher also includes a convenient integrated cord wrap to
help keep your ear bud cables tangle free. Gently slide the cord
wrap out of the cabinet as shown and wind the ear bud cables
around the cord wrap when not in use.
The LED flasher can be clipped to your belt or clothing to provide
increased visibility while running, jogging, or walking after dark.
IMPORTANT! Listening at high volume for long periods of time can
result in long-term hearing damage. For your safety, do not use
headphones if they would prevent you from hearing warning
sounds, such as while driving a car or motorcycle, riding a bike, etc.
Remember that noise isolation type earphones such as the iB12 are
very effective in blocking outside noise, including warning sounds.
Always be aware of your surroundings and do not use these
earphones in situations that require you to hear warning sounds.
NOTE: In extremely cold or dry air conditions you may notice a
slight ‘tingling’ feeling in your ears when using in-ear headphones.
This is the result of the build-up of static electricity in your body. This
is normal and not an indication of any problem with your
headphones.
iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this
product to be free from defects in workmanship and materials, under normal use and conditions,
for one year of the product from the date of original purchase.
Should this product fail to function in a satisfactory manner, it is best to first return it to the store
where it was originally purchased. Should this fail to resolve the matter and service still be required
by reason of any defect or malfunction during the warranty period, SDI will repair or, at its discretion,
replace this product without charge. This decision is subject to verification of the defect or malfunction
upon delivery of this product to the Factory Service Center authorized by SDI Customer Service.
The product must include proof of purchase, including date of purchase. An out-of-warranty fee for
service will be charged for units that are received without proof of purchase.
Before returning this product for service, please first replace the batteries (if applicable) with fresh
ones, as exhausted or defective batteries are the most common cause of problems encountered.
If service is still required:
1. Call SDI Customer Service at 1-800-288-2792 for Return Authorization and for the address of
the Factory Service Center.
2. Remove the batteries (if applicable) and pack the unit in a well padded, heavy corrugated box.
SDI is not responsible for damage that occurs during shipping to the Factory Service Center.
3. Enclose a photocopy of your sales receipt, credit card statement, or other proof of the date of
purchase, if within the warranty period. Also include your name and address information, a brief
description for why the unit is being returned, and the return authorization number. No unit can
be processed without a return authorization number.
4. Write the return authorization number on the side of the shipping package and send the unit
prepaid and insured to the Factory Service Center address authorized by SDI Customer Service.
Disclaimer of Warranty
NOTE: This warranty is valid only if the product is used for the purpose for which it was designed.
It does not cover (i) products which have been damaged by negligence or willful actions, misuse or
accident, or which have been modified or repaired by unauthorized persons; (ii) cracked or broken
cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CD’s or tape
cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service Center and its
return to the owner.
This warranty is valid only in the United States of America and does not extend to owners of the
product other than to the original purchaser. In no event will SDI or any of its affiliates, contractors,
resellers, their officers, directors, shareholders, members or agents be liable to you or any third party
for any consequential or incidental damages, any lost profits, actual, exemplary or punitive damages.
(Some states do not allow limitations on implied warranties or exclusion of consequential damages,
so these restrictions may not apply to you.) This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
Your acknowledgement and agreement to fully and completely abide by the above mentioned
disclaimer of warranty is contractually binding to you upon your transfer of currency (money order,
cashier's check, or credit card) for purchase of your SDI product.
© 2013 SDI Technologies, Inc. All rights reserved
Questions? Visit www.ihomeaudio.com or call 1-800-288-2792 Toll Free.

Navigation menu