Imation IPUIAB11 USB Car Charger with Bluetooth Hands Free User Manual Product Name

Imation Corp. USB Car Charger with Bluetooth Hands Free Product Name

Updated User Manual

UUUU serserserser MMMM anualanualanualanual1. Buttons and Connections2. Charging with InCharge Auto BT2.1 Charging an iPod / iPad / iPhonei. When you plug the CLA into the 12V in a Car, The Orange LED will turn on, to show that the CLAis being powered.ii. When a USB Device is plugged into the CLA, up to 2.1A of power will be supplied immediately.3. Connecting to Bluetooth3.1 Connecting to InCharge Auto BT via Bluetoothi. Hold down the ʻ Call ʼ button for 2 seconds, this will allow the Bluetooth device to be discovered.ii.The Orange LED will turn off and LED will begin to slowly Flash Blue.iii. Then, the User selects "InCharge Auto BT" from the Bluetooth List on their device. If the devicerequires a pairing code, use "0000".iv. O nce the device has successfully paired, there will be an audible ʻ beep ʼ sent to the stereo and theLED will stop flashing and stay solid blue.v. If the unit is not paired after three minutes, the LED will stop flashing blue and it will become solidorangevi.InCharge Auto BT will remember the device that it is paired with, and link to it each time that InChargeAuto BT is powered on and the device is in range.4.Playing Audio over Bluetooth4.1 Playing wireless Audio over Bluetoothi. The user must have their radio set to AUX and the 3.5mm cable properly connected.ii. Press the ʻ call ʼ button on the 3.5 Jack, this will send a play command to the iPodiii. The music will start playing as quickly as possible.iv. The ʻ call ʼ button can be pressed at anytime to pause or play the audio.
UUUU serserserser MMMM anualanualanualanual5. Receiving a call via Bluetooth5.1 Receiving a call via Bluetoothi. If audio is playing over Bluetooth, the audio volume will dim and the phone will ring over the car stereo.ii. Press the ʻ call ʼ button on the 3.5 Jack to answer a call. The Audio from the call will begin to play overthe car stereo, The Microphone on the 3.5 jack will be the active microphone.iii. If the user answers the call by pressing a button on the phone itself, than the phone call will nottransmit over the Bluetooth for privacy reasons. The User will need to select Bluetooth as the Audio sourceon the Phone.iv. After the conversation is complete, the user can end the call by pressing the ʻ call ʼ button.6. StatementThis device complies with Part 15 of the FCC Rules. Operation is subject to the following twoconditions: (1) this device may not cause harmful interference, and (2) this device must acceptany interference received, including interference that may cause undesired operation.changes or modifications not expressly approved by the party responsible for compliancecould void the user's authority to operate the equipment.NOTE:This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the followingmeasures:-- Reorient or relocate the receiving antenna.-- Increase the separation between the equipment and receiver.-- Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.-- Consult the dealer or an experienced radio/TV technician for help.RF Exposure StatementTo maintain compliance with FCC ’ s RF Exposure guidelines, This equipment should beinstalled and operated with minimum distance between 20cm the radiator your body: Useonly the supplied antenna.This device complies with industry canada licence-exempt RSS standard(s). Operation issuject to the following two conditions:(1) this device may not cause interference, and(2) thisdevice must accept any interference, including interfernce that may cause undesired operationof the device.

Navigation menu