Impinj IPJR1000 Speedway Reader User Manual

Impinj, Inc. Speedway Reader Users Manual

a href="https://usermanual.wiki/Impinj" itemprop="url"> Impinj >

Users Manual

REV 1.0 02-06 www.impinj.comCopyright © 2006, Impinj, Inc. Impinj and Speedway are either registered trademarks or trademarks of Speedway Reader IPJ-R1000 for Gen 2 UHF RFIDPRELIMINARY USER GUIDEOverview The EPCglobal™-certified Speedway™ IPJ-R1000 is a fixed Gen 2 UHF RFID tag reader that provides network connectivity between tag data and enterprise system software. A key element of Impinj's GrandPrix™ RFID system solution, Speedway is the first high-performance reader designed from the ground up to support the EPCglobal Gen 2 standard in its entirety. That includes the accommodation of 640 kbps tag-to-reader data rates, robust performance in dense-reader environments (without the requirement for network synchronization), the elimination of ghost reads, and more. Combined with an extensible architecture that supports seamless integration of field-upgradeable, third party application software, Speedway is the most adaptable reader solution available today. This user guide provides instructions on how to install, configure, operate, and troubleshoot the Speedway reader. It assumes the user is familiar with appropriate networking facilities, the EPCglobal™ Gen 2 specification, and general principles of RFID system management.
Speedway Reader IPJ-R1000 for Gen 2 UHF RFID 2 Federal Communications Commission (FCC) Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna • Increase the separation between the equipment and receiver • Consult the dealer or an qualified radio/TV technician for assistance Note: Changes to this product will void the user's authority to operate per FCC Part 15. Industry Canada (IC) Compliance Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. This device has been designed to operate with the antenna(s) listed in the section entitled, "Connecting the Antenna(s)," and having a maximum gain of 6 dB. Antennas not included in this list or having a gain greater than 6 dB are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication. Note: The term “IC:” before the radio certification number only signifies that Industry of Canada technical specifications were met. Before You Begin Please read this document in its entirety before operating the Speedway reader, as serious personal injury and/or equipment damage may result from improper use. !
Download:
Mirror Download [FCC.gov]
Document ID628547
Application IDMh3ZczF7mEIXNdV9QzEDXw==
Document DescriptionUsers Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize54.04kB (675553 bits)
Date Submitted2006-02-14 00:00:00
Date Available2006-02-14 00:00:00
Creation Date2006-02-09 14:43:34
Producing SoftwareAcrobat Distiller 6.0 (Windows)
Document Lastmod2006-02-09 14:43:34
Document TitleMicrosoft Word - MR_SP_UG_00001_SpeedwayReaderGuide.doc
Document CreatorPScript5.dll Version 5.2
Document Author: JSchroet
FCC ID Filing: TWYIPJR1000

Navigation menu