Infinity Sat 450 Om Users Manual
Infinity Systems Inc. Speaker TOTAL SPEAKER SOLUTIONS 11939681
SAT-450 OM to the manual d324ef97-7299-b794-a514-7b22db428530
2015-01-23
: Infinity Infinity-Sat-450-Om-Users-Manual-342730 infinity-sat-450-om-users-manual-342730 infinity pdf
Open the PDF directly: View PDF 
.
Page Count: 8
| Download | |
| Open PDF In Browser | View PDF |
TOTAL SPEAKER SOLUTIONS SAT-450 Owner’s Guide SAT-450 OWNER’S GUIDE Table of Contents 4 Introduction 4 Placement 5 Wall-Mounting the Satellite 5 Speaker Connections 6 Operation 6 Maintenance and Service 6 Specifications Declaration of Conformity We, Harman Consumer International 2, route de Tours 72500 Chateau-du-Loir France declare in own responsibility that the product described in this owner’s manual is in compliance with technical standards: EN 50081-1:1992 EN 50082-1:1997 Robin Marshall Harman Consumer International Chateau-du-Loir, France 10/03 SAT-450 3 INTRODUCTION Home Theater Infinity Total Solutions™ Infinity Total Solutions continues Infinity’s longstanding commitment to accurate sound reproduction. Our high-quality drivers, precision dividing networks and rigid, well-braced enclosures combine to deliver uncompromised performance in any stereo or multichannel home theater system. In addition, these speakers, except for the powered subwoofer, are magnetically shielded for safe placement adjacent to a television. Unpacking the Speaker If you suspect damage from transit, report it immediately to your dealer. Keep the shipping carton and packing materials for future use. For front-channel use, place one speaker on the left and another on the right, along either side of the television monitor. Since the speakers are magnetically shielded, you can place them without worrying about the field distorting the TV picture. For surround-channel use, place speakers on bookshelves or stands alongside the listening position. Final placement depends on room acoustics, availability of space, and your listening preference (Figures 2 and 3). In 6- or 7-channel configurations, place the rear channel(s) behind the listening position, as shown in Figures 2 and 3. NOTE: An Infinity powered subwoofer will add impact and realism to both music and film soundtracks. Contact your Infinity dealer for recommendations on subwoofer models for your application. Infinity Subwoofer (optional) Left Front Channel PLACEMENT Stereo Right Front Channel Center Channel Before deciding where to place your speakers, survey your room and think about placement, keeping the following points in mind, using Figure 1 as a guide: • For best results, place the speakers 6'– 8' apart. • Position each speaker so that the tweeter is approximately at ear level. • Generally, bass output will increase as the speaker is moved closer to a wall or corner. • Refer to “Home Theater” if you also plan to use the speakers for home theater reproduction. Left Channel Right Channel Couch Left Surround Channel Left Rear Channel Center Rear Channel Right Rear Channel Right Surround Channel Figure 2.This overhead view shows a typical home theater plan. Left/right rear channels are for a 7-channel system. Center rear channel is for a 6-channel system. (optional) Listening Position Right Rear Channel Figure 1.This overhead view shows typical positioning in stereo applications. Left Rear Channel Center Rear Channel Figure 3.This figure shows an alternate layout, which may be more suitable for some rooms. Left/right rear channels are for a 7-channel system. Center rear channel is for a 6-channel system. 4 SAT-450 WALL-MOUNTING THE SATELLITE SPEAKER CONNECTIONS The TSS-450 satellite is designed to be mounted on the wall. There is a wall bracket for each satellite speaker. Each speaker bracket will require (4) 1-1/2," #10 wood screws; each screw should be fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2," #10 screw. Turn Off All Power NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers. Step 1. Mark the positions on the wall where you would like to place the mounting screws. Step 2. Place bracket against wall and fasten four 1-1/2," #10 wood screws through the bracket’s screw holes into the wall. If a wall stud is not available, use an appropriate anchor. First, turn off all audio-system power. Use high-quality speaker wire to make your connections. #18-Gauge speaker wire with polarity coding is recommended. For longer distances, #16-gauge or heavier wire is recommended.The side of the wire with a ridge or other coding is usually considered positive polarity (i.e., +). Also, consult the owner’s manuals that were included with your amplifier or receiver to confirm connection procedures. Observe polarities when making speaker connections, as shown in Figure 5. Connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker. Connect the – (black) terminals in the same way. Important! Do not reverse polarities (i.e., + to – or – to +) when making connections. Doing so will cause poor imaging and diminished bass response. Be certain that positive and negative wire strands are completely isolated to avoid short circuits that may damage your equipment. Step 3. Screw the post of the bracket into the 1/4"-20 threaded insert on the back of the satellite. Adjust the satellite to the desired angle and tighten the knob using the enclosed metal bar. keyhole on the back of the speaker to the screwhead on the wall. Once positioned properly, the speaker should Figure 4. slide down slightly and become secure. Insert Bare End; Release Tab Press Tab and Hold Metal bar – + ® Bracket on wall. Figure 5. Wiring diagram shows polarity connections for one channel of a home theater system. SAT-450 5 OPERATION SPECIFICATIONS Surround Modes SAT-450 When using the system in a Dolby* Digital or DTS® home theater system, make sure all SAT-450 speakers are set to “Small”. Frequency Range: 150Hz – 20,000Hz (±3dB) When using the SAT-450 in a Dolby Pro Logic* home theater system, make sure the receiver’s center channel mode is set to “Normal.” Recommended Amplifier Power Range: 10 – 100 watts Sensitivity: 86dB Some Dolby Digital-equipped receivers/processors offer different setup options for each source or surround mode, e.g., CD-stereo, videotape, Dolby, Pro Logic. In each case, follow your equipment’s instructions to ensure that the subwoofer output is turned on and that the speakers are set to “Small” in each mode. MAINTENANCE AND SERVICE (2.83V @ 1 meter) Nominal Impedance: 8Ω Crossover Frequency: 7000Hz, 24dB/octave Midrange Driver(s): 2-1/2," magnetically shielded High-Frequency Driver: 1/2," magnetically shielded Dimensions (H x W x D): 5" x 3-1/2" x 3-1/2" (127mm x 88mm x 88mm) Weight: 1.2 lb (0.5kg) The satellite enclosure may be cleaned using a soft cloth to remove fingerprints or to wipe off dust. All wiring connections should be inspected and cleaned or remade periodically.The frequency of maintenance depends on the metals involved in the connections, atmospheric conditions, and other factors, but once per year is the minimum. If a problem occurs, make sure that all connections are properly made and clean. If a problem exists in one loudspeaker, reverse the connection wires to the left and right system. If the problem remains in the same speaker, then the fault is with the loudspeaker. If the problem appears in the opposite speaker, the cause is in another component or cable. In the event that your SAT-450 ever needs service, contact your local Infinity dealer or Infinity directly at 516.674.4INF (4463) (USA only) or www.infinitysystems.com for a service center near you. 6 SAT-450 Infinity continually strives to update and improve existing products, as well as create new ones.The specifications and construction details in this and related Infinity publications are therefore subject to change without notice. NOTES © 2003 Harman International Industries, Incorporated Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 516.674.4INF (4463) www.infinitysystems.com * Trademarks of Dolby Laboratories. DTS is a registered trademark of Digital Theater Systems, Inc. Infinity is a registered trademark, and Total Solutions is a trademark, of Harman International Industries, Incorporated.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Create Date : 2003:09:26 18:45:56Z Modify Date : 2003:09:26 14:47:40-04:00 Page Count : 8 Creation Date : 2003:09:26 18:45:56Z Mod Date : 2003:09:26 14:47:40-04:00 Producer : Acrobat Distiller 5.0.5 for Macintosh Author : Lin, Siong Metadata Date : 2003:09:26 14:47:40-04:00 Creator : Lin, Siong Title : SAT-450 OM Has XFA : NoEXIF Metadata provided by EXIF.tools