Ingenico Barcelona I7910 Ingenico I7910 Point of Sale Terminal User Manual I7910 UserMan

Download:
Mirror Download [FCC.gov]
Document ID	701908
Application ID	J1qg/Nj6gAylxIubBVYNqA==
Document Description	UserMan2
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	78.3kB (978699 bits)
Date Submitted	2006-09-07 00:00:00
Date Available	2006-09-07 00:00:00
Creation Date	2006-07-09 09:52:37
Producing Software	AFPL Ghostscript 8.50
Document Lastmod	2006-09-07 13:23:58
Document Title	I7910 UserMan
Document Creator	PDFCreator Version 0.8.1
Document Author:	TBA

3.3 Battery pack charging
 Only use the battery pack supplied with your terminal.
 Remember to switch the terminal off before you handle the battery pack.
Your terminal is supplied with a removable rechargeable lithium-ion battery. This battery
recharges by connecting the terminal to the power supply.
The battery pack must never be manipulated except for changing it or for installing/
uninstalling the SAM or MMC-SD.
When manipulating the battery pack, the terminal must always be disconnected from the
external power supply.

 Before removing the battery pack, first disconnect the power supply.

 Please make sure battery pack is correctly put by switching on the terminal before
connecting it to the power supply.
During long breaks (breakfast, lunch, ) do connect the terminal to the power supply to
ensure a correct charge of the terminal.

 For the battery charge status on the terminal screen, please refer to the application
user’s guide.

 You can carry out up to 200
transactions with a fully charged battery (depends on the
ticket size and transaction duration).
13
Ingenico 7910
3.4 Terminal connections
i7910
Power supply
LinkBox
Connecting to the electric network
 The power supply unit supplied is specially designed for the terminal. Do not use
any other unit.
Connect the terminal to the power supply.
Connect the power supply unit to the electric network.
Disconnecting from the electric network
Disconnect the power supply unit from the electric network.
Power supply
Power supply unit voltage: 11 to 25 V DC; current 0.7A (typ).
Connecting to a LinkBox modem
14
Connect the LinkBox to the terminal.
Connect the LinkBox to the telephone line and/or to another device.
3.5 Installing a SIM card and a multimedia card (MMC)
The SIM card connectors are located in the battery compartment located under the terminal.
 Don’t touch the terminal on battery connectors
Installing the SIM card
Remove the battery,
Unlock the connector by sliding the metallic part in the
direction of the OPEN arrow,
Lift the card housing up,
Insert a SIM card into the housing,
Put the housing back down again,
Lock the connector by sliding the metallic part in the
direction of the LOCK arrow.
OPEN
Removing the SIM card
Follow the installing instructions to remove the SIM card
15
Ingenico 7910
Installing a multimedia card
Open the Sim card connector,
Keep the plastic pressed when
inserting the MMC card,
Removing a multimedia card
16
Press the lateral plastic and push the
MMC to release it from the connector.
Press the lateral plastic,
Close the sim card connector.
3.6 Troubleshooting
The terminal does not turn on
Check that the battery is charged.
There is nothing on the receipt that comes out of the terminal
Check that the roll of paper has been put in the right way (see chapter 2.3 “Changing
the roll of paper”)
The receipt is illegible
Over a period of time, the print quality will deteriorate due to the accumulation of
paper dust on the print head. The print head should be cleaned with the terminal
powered off, using ethanol applied with a lint-free cloth. Ensure that the ethanol has
completely evaporated before switching the terminal back on.
17
Ingenico 7910
4 Recommendations
4.1 Security
Your terminal fulfills the VISA security requirements, as well as high security requirements
from Northern European and Asia-Pacific zone.
In order to ensure that software integrity self-test is performed periodically, it is necessary to
restart (disconnect-reconnect) the terminal at least once per day.
4.2 Safety
As this terminal does not have a power off switch, the disconnecting device is the main
transformer; the power supply plug must therefore be easily accessible.
Safety directives concerning the Lithium batteries
Keep out of the reach of children.
If any elements of the battery are swallowed, the person should consult a doctor or
seek medical assistance immediately.
It is important to comply with the "+" et "–" polarities.
Do not try to reactivate the batteries using a heat source, an electric recharge or any
other means.
Do not throw the batteries into the fire.
Do not dismantle the batteries.
Generally speaking
Ensure that the terminal is seated securely on the base.
There is a danger of explosion if the battery unit or battery has not been replaced
correctly.
Replace the batteries and battery unit with same type elements or similar type
elements recommended by the manufacturer only.
Dispose of used battery units and batteries in compliance with manufacturer
instructions.
Do not throw the batteries and battery unit into the bin; dispose of them in suitable
recycling facilities.
4.3 RF Safety
General
Your terminal uses the GSM standard for cellular technology. GSM is a newer radio
frequency (RF) technology than the current FM technology that has been used for radio
communications for decades. The GSM standard has been established for use in the
European Union and elsewhere.
Your cellular terminal is actually a low power radio transmitter and receiver. It sends out
and receives radio frequency energy. When you use your cellular terminal, the cellular
18
system handling your call controls both radio frequency and the power level of your cellular
terminal.
The device and its antenna(s) must not be collocated or operating with any other antenna or
transmitter except Grant condition. Users are not permitted to modify this transmitter device.
Any unauthorized change made to this device could void your authority to operate this
device.
4.4 General safety
Electronic Device
Most electronic equipment, for example in hospitals and motor vehicles, are shielded from
RF energy. However, RF energy may affect some damaged or improperly shielded
electronic equipment.
Vehicle Electronic Equipment
Check with your vehicle manufacturer's representative to determine if on board electronic
equipment is adequately shielded from RF energy.
Medical Electronic Equipment
Consult the manufacturer of any personal medical devices (such as pacemakers, hearing
aids, etc.) to determine if they are adequately shielded from external RF energy.
Turn your Terminal OFF in health care facilities when any signs in the area instruct you to
do so. Hospitals or health care facilities may be using RF monitoring equipment.
Aircraft
 Warning: Turn your Terminal OFF before boarding any aircraft, use on the ground
only with the crew's permission. Do not use it in the air.
Children
Do not allow children to play with your terminal. Children could hurt themselves or damage
the terminal.
Blasting areas
To avoid interfering with blasting operations, turn your unit OFF when in a "blasting area"
or in areas posted: "turn off two-way Bluetooth technology". Construction crews often use
remote control RF devices to set explosives.
Potentially Explosive Atmospheres
Turn your terminal OFF when in any area with a potentially explosive atmosphere. It is rare,
but your terminal could generate sparks. Sparks in such areas could cause an explosion or
fire resulting in injury or death.
Areas with a potentially explosive atmosphere are often, but not always marked. They
include fuelling areas such as petrol stations, below decks on boats, fuel or chemical transfer
or storage facilities, and areas where the air contains chemicals or particles, such as grain,
dust, or metal powders.
Do not transport or store flammable gas, liquid, or explosives, in the same compartment as
your terminal.
19
Ingenico 7910
Before using your terminal in a vehicle powered by liquefied petroleum gas (such as
propane or butane) ensure that the vehicle complies with the relevant fire and safety
regulations of the country in which the vehicle is to be used.
4.5 WEEE
This symbol on the product or on its packaging means that this product should
not be treated as household waste.
To minimise environmental impacts and the disposal of waste, this product should be
handed over to a separate collection system in order to facilitate recycling and recovery.
For more detailed information, please contact your reseller.
20
5 Index
Battery .................................................. 9
Battery pack charging ......................... 13
Magnetic stripe card ..............................9
Card reading ......................................... 9
Charge level........................................ 13
Connecting to the electric network ..... 14
Connections ........................................ 14
Paper roll .............................................10
Power supply .......................................14
Removing the SIM card.......................15
Installing the SIM card ....................... 15
SIM......................................................15
Smart card .............................................9
21
Ingenico 7910
22
NON CONTRACTUAL DOCUMENT
INGENICO owns exclusive rights on this document.
All diffusion, all copies, all entire or partial production by any process, as long as it is made without the authorization of
INGENICO, the promoter, will be considered as illicit, and will form an infringement, penalized by the clauses L.335-2
and following, of the « Code de la propriété intellectuelle ».
INGENICO keeps the right without notice to modify the characteristics and the functions of this device.
INGENICO is not responsible for any use of this device, which would be non consistent with the present document.
Your contact
192 avenue Charles de Gaulle
92200 Neuilly sur Seine
France
Tel. : +33 (0)1 46 25 82 00 – Fax : +33 (0)1 47
72 56 95
www.ingenico.com
DIV2190C
Ingenico

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Page Count                      : 12
Has XFA                         : No
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:fd60bde2-1daa-4e1c-83c6-aa57ae282d9d
Producer                        : AFPL Ghostscript 8.50
Modify Date                     : 2006:09:07 13:23:58+02:00
Create Date                     : 2006:07:09 09:52:37+02:00
Creator Tool                    : PDFCreator Version 0.8.1
Metadata Date                   : 2006:09:07 13:23:58+02:00
Document ID                     : uuid:3406e2ef-a38f-4430-a88b-cd1cdb408b1d
Format                          : application/pdf
Title                           : I7910 UserMan
Creator                         : TBA
Author                          : TBA

EXIF Metadata provided by EXIF.tools