Inseego NVWMC551S Cellular/ PCS CDMA and 700 MHz LTE USB Modem User Manual Notices

Download:
Mirror Download [FCC.gov]
Document ID	1618960
Application ID	0T6+giHynasHwgEoehJcUA==
Document Description	Modular Integration Guide
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	22.05kB (275653 bits)
Date Submitted	2012-01-11 00:00:00
Date Available	2012-02-25 00:00:00
Creation Date	2017-11-02 08:58:00
Producing Software	GPL Ghostscript 9.18
Document Lastmod	2017-11-02 08:58:00
Document Title	Notices
Document Creator	Microsoft® Word 2010
Document Author:	jturner

MC551 MODULE INSTALLATION AND
COLLOCATION GUIDELINES FOR
HOST DEVICES Rev.3
FCC ID: PKRNVWMC551S
12/15/2011
1 of 8
Notice: Restricted Proprietary Information
© Copyright Novatel Wireless, Inc. (2011)
The information contained in this document is the exclusive property of Novatel Wireless, Inc. All
rights reserved. Unauthorized reproduction of this manual in any form without the expressed
written approval of Novatel Wireless, Inc. is strictly prohibited. This manual may not, in whole or in
part, be copied, reproduced, translated, or reduced to any electronic or magnetic storage medium
without the written consent of a duly authorized officer of Novatel Wireless Inc.
The information contained in this document is subject to change without notice and should not be
construed as a commitment by Novatel Wireless Inc. unless such commitment is expressly given
in a covering document.
Novatel Wireless Inc. makes no warranties, either expressed or implied, regarding this document,
its merchantability, or its fitness, for any particular purpose.
Printed and produced in United States of America.
12/15/2011
2 of 8
Document Revision History
Rev.
1.0
2.0
Date
August 8, 2011
October 20, 2011
3.0
December 15, 2011
12/15/2011
Brief Description of Change
Initial Draft
Administrative Changes per
result of TCB Review.
Administrative Changes per
FCC Response 12-05-11
Originator
Roman Olmos
Roman Olmos
Approved by
Roman Olmos
3 of 8
Novatel Wireless Inc.
Version 2.0
1.0 Introduction
This document provides OEM installation requirements for the MC551 device
(FCC ID: PKRNVWMC551S). As the grantee, Novatel Wireless is responsible for all
integrations and must be consulted on all regulatory matters involving the MC551.
The document outlines what RF Exposure considerations are required for OEM
installation using the MC551. If the installation of the MC551 is outside of the
provided guidelines, contact Novatel Wireless for further instructions.
When integrating the MC551 into host devices as described in this document
please contact Novatel Wireless at http://www.nvtl.com/support/index.html. Novatel
Wireless must be notified to ensure that the regulatory guidelines provided in this
document are fully understood and complied to.
2.0 Module Installation Guidelines
This document addresses the following installation host configurations and
conditions:
i)
ii)
iii)
iv)
v)
The MC551 must be installed by OEM as a standalone transmitter in final
products where greater than a 2.4cm (24mm) separation distance is provided
between the MC551 transmitting antenna and the end user. Refer to Section
3.0 on OEM Installation Guidelines.
Collocated transmitters that can operate simultaneously with the
MC551module are only allowed if the requirements defined in the Section 4.0
Collocated Installation Guidelines are satisfied.
If the MC551 is in an enclosure, the FCC and Industry Canada IDs must be
permanently affixed on the exterior of the final product..
A label must be applied to the outside of the device with the following
wording:
This device contains FCC ID: PKRNVWMC551S.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
These installation guidelines are not applicable to installations where
the separation distance between the modem and users cannot be
guaranteed to be greater than 2.4cm (24mm).
12/15/2011
4 of 8
Novatel Wireless Inc.
Version 2.0
3.0 Module Installation Guidelines
The MC551 must be installed for use internal to final products where the
separation distance between the user and the modem is greater than 2.4cm
(24mm). Refer to Section 5.0 OEM Integration Requirements section for
measurement guidelines for separation between the transmitting antenna and the
user. The modem must not be collocated with other antennas or transmitters unless
the guidelines within this document are followed. See Section 4.0 Collocated
Installation Guidelines for collocated information.
4.0 Collocated Installation Guidelines
This section applies to all combinations of transmitters and antennas installed
in the final product. The addition or use of the MC551 with other radio transmitters
must be evaluated to ensure that RF Exposure conditions do violate any FCC rules.
It is not recommended that other transmitters be used with the MC551 however
should the installation utilize other transmitting devices care must be taken and
these steps need to be followed. Please contact Novatel Wireless to oversee the
setup of the modem with multi radio configurations.
Collocated transmitters can be operated simultaneously with the MC551, provided
the conditions listed below are met:
i) A list of the FCC IDs must be presented to Novatel Wireless.
ii) A distance of at least 5cm (50mm) must be maintained from other transmitting
devices (such as other USB devices).
iii) Any combination of transmitting antennas must maintain a separation
distance of at least 5cm (50mm) from each other.
iv) Authorization from Novatel Wireless is required before operating two or more
wireless transmitters with the MC551.
The application of the Novatel Wireless FCC ID as stated in section 1) iv) is
conditional based on the guidelines above. All integrations that involve multiple
transmitters must be reviewed and approved by Novatel Wireless. Authorization to
apply the Novatel Wireless FCC ID on the exterior of the host device must be
provided prior to installing and turning these devices on.
12/15/2011
5 of 8
Novatel Wireless Inc.
Version 2.0
5.0 OEM Integration Requirements
For operation of this device by OEM integration into final products, this
transmitter must be installed in the final product with a minimum separation distance
from the user of greater than 2.4cm (24mm). This distance must be maintained to
satisfy FCC equipment certification and RF exposure requirements.
Ensure that the modem hinge is able to maintain the normal operation
position 120°degrees when installed inside the final product. If the hinge is
positioned in an orientation other than that shown the transmitter may shut off.
12/15/2011
6 of 8
Novatel Wireless Inc.
Version 2.0
6.0 Regulatory Statements - Federal Communications
Commission Notice (FCC—United States)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Contact your service provider for help.
Notice to Consumers: Changes or modifications made to this equipment not
expressly approved by Novatel Wireless may void the FCC authorization to operate
this equipment.
This device complies with Part 15 of the FCC Rules and with Industry Canada ICES003.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
The E362 is compliant to the relevant sections of the FCC rules:

FCC CFR47 Part 2 (General Rules and Regulations, RF Exposure
Evaluation)

FCC CFR47 Part 15 (All Radio Frequency Devices)

FCC CFR47 Part 24 (Narrow and wideband PCS modules)

FCC CFR47 Part 22 (Cellular Service)

FCCCFR47 Part 27 (Wireless Communications Services)
12/15/2011
7 of 8
Novatel Wireless Inc.
Version 2.0
7.0 Technical Support Contacts
WWW: http://www.nvtl.com/support/index.html
Email: support@novatelwireless.com
12/15/2011
8 of 8

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Author                          : jturner
Create Date                     : 2011:12:15 14:28:03-08:00
Modify Date                     : 2012:01:11 16:54:15-05:00
Language                        : en-US
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Format                          : application/pdf
Creator                         : jturner
Title                           : Notices
Creator Tool                    : Microsoft® Word 2010
Metadata Date                   : 2012:01:11 16:54:15-05:00
Producer                        : Microsoft® Word 2010
Document ID                     : uuid:e803d343-a8ca-4a00-90da-77500f15197c
Instance ID                     : uuid:3416a139-6ff3-46c3-bd17-e69f37d6a6d4
Page Count                      : 8

EXIF Metadata provided by EXIF.tools