Instant Care 315HALO1 Halo Transmitter User Manual

Download:
Mirror Download [FCC.gov]
Document ID	3653191
Application ID	y+B6ktt5qYAyZcBQIgm0SQ==
Document Description	Users Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	38.16kB (476952 bits)
Date Submitted	2017-11-27 00:00:00
Date Available	2017-11-28 00:00:00
Creation Date	2017-10-12 11:14:06
Producing Software	Microsoft® Word 2010
Document Lastmod	2017-11-24 11:35:17
Document Title	Users Manual
Document Creator	Microsoft® Word 2010
Document Author:	icrep2

Instant Care Halo Transmitter
Model #: HALO315TX-1

Identifying the Parts
1. Emergency Button/ LED

Learning-in the Halo Transmitter
Press the Emergency button, a radio signal will be transmitted to the Control
Panel. Please refer to the learn-in procedure of your Control Panel for further instruction.

Operation
 To dial Emergency Line:
Press once on the Emergency button, the GREEN LED will illuminate for 2 seconds and transmit
the message to the Control Panel.
 Sleep Mode:
-The Halo Transmitter ships in “Sleep Mode” to conserve battery life
-Pressing the Emergency Button once will cause the Transmitter to exit Sleep Mode
-To put the Halo Transmitter back into Sleep Mode, hold the Emergency Button for 14 seconds.
The LED will illuminate RED for 2 seconds

Battery & Electrical Specifications
 Frequency: 315 Mhz
 Battery: CR2032, 3V 230mAh
 Battery life: Typical life expectancy of 5 yrs at an average use rate of one activation per day.
 Open Field Range: Approximately 600 ft.
 Low battery status: when the battery voltage is below the threshold, the Halo Transmitter will
indicate a low battery by illuminating the RED LED for 2 seconds when the Emergency button is
pressed. The low battery signal will be transmitted to the Control Panel.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
FCC Caution
To assure continued compliance, any changes or notifications not expressly approved by the party responsible for compliance
may void the user’s authority to operate his equipment. (Example – use only shielded interface cables when connecting to
computer or peripheral devices)
FCC Section 15.105 Information to the user.
NOTE:
This equipment has been tested and found to comply with the limits for a lass B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : No
Has XFA                         : No
Language                        : en-US
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.6-c015 84.159810, 2016/09/10-02:41:30
Format                          : application/pdf
Creator                         : icrep2
Create Date                     : 2017:10:12 11:14:06-07:00
Creator Tool                    : Microsoft® Word 2010
Modify Date                     : 2017:11:24 11:35:17+08:00
Metadata Date                   : 2017:11:24 11:35:17+08:00
Producer                        : Microsoft® Word 2010
Document ID                     : uuid:27ee4585-ce52-48a8-9f2a-0682b6dbab24
Instance ID                     : uuid:cc9968e1-223a-4cea-a51d-77107835c6e5
Page Count                      : 1
Author                          : icrep2

EXIF Metadata provided by EXIF.tools