Intech Electronics CS8045 Bluetooth Car Kit User Manual MCB 8045010 0A User Mamual
In Tech Electronics Ltd Bluetooth Car Kit MCB 8045010 0A User Mamual
Manual
3
2
4
I-2 Function
I-2-1 On/Off (S1)
I-2-2 Volume Up (S2)
I-2-3 Volume Down (S3)
I-2-4 LED
I-2-5 DC Socket
I-2-6 FoldableMicrophone
I-2-7 Speaker
I-2-8 Battery Door
(please refer to Fig.1)
If you press S1, you can:
Switch on and Off
Pair
Answer a new call
Reject a call
Make a new call using voice dialing
Increase the speaker volume
To mute/un-mute the microphone
Redial the last dialed number
Decrease the speaker volume
There are two LED colors (green and red) to indicate the state of this
Car-Kit
Charge your rechargeable battery with a car charger without
loading/unloading any battery
◎
◎
◎
◎
◎
◎
◎
◎
◎
.
a recharging power socket.
You can adjust this microphone to an appropriate angle to receive a
quality voice.
.
It serves as
I-2-9 Visor Clip
Clip the hands-free ar it under your car's sun visorCK .
II. How to Use
II-1 Charge the Batteries
II-2 Turn on the Hands-free Car Kit
(.. )
(.)
e g Nokia 3650 or equivalent models
please refer to Fig 2
Before you use for the first time, please charge the batteries for 6 hours.
After the first time, you can fully charge your low batteries in 3 hours.
If the Hands-free Car Kit is powered off,
. A low tone followed by a high tone will indicate the hands-free
Car Kit has turned on. At the same time, Green LED will flash for a
second. And then, green LED will keep on flashing every 3 seconds.
Thank you for buying the Abe BT 77V, Hands-free Car Kit.Bluetooth
.Use only rechargeable batteries
press and hold S1 for 4
seconds
Warning:
Car charger
Fig.2
1
I. Profile and Its Function…………………………………………………………………………1
I-1 Profile………………………………………………………………………………………1
I-2 Function……………………………………………………………………………………2
II. How to Use! ………………………………………………………………………………………3
II-1 Charge the Batteries……………………………………………………………………3
II-2 Turn on the Hands-free Car Kit………………………………………………………3
II-3 Pair the Hands-free Car Kit with Your Mobile Phone…………………4
II-4 Establish Link………………………………………………………..………5
II-5 Clip the Hands-free Car Kit under Your Sun Visor …………………………………5
II- Answer an Incoming Call………………………………………………………………
II- Transfer Calls between This Hands-free Car Kit and Your Phone…..6
II-8 Make a New Call by Using Voice Dialing……………………………………………6
II- 9 Mute the Microphone……………………………………………………………….…7
II-10 End a Call……………………………………………………………………….…………7
II-11 Reject a Call……………………………………………………………………..………7
II-12 Redial Last Dialed Number……………………………………………………………7
II-13 Adjust the Speaker Volume…………………………………………………….………7
II-14 Recharge the Low Batteries…………………………………………………..………8
II-15 Turn off the Hands-free Car Kit…………………………………………………………8
III Maintenance and Safe Use…………………………………………………………….………9
IV Package Contents………………………………………………………………….……………9
FCC Interference statement …………………………………………………………………………12
Bluetooth
Bluetooth
Bluetooth7
6 6
TM
R
BT 77V
Bluetooth Hands-free Car Kit
http://www.abe-hk.com
Table of Content
I Profile and Its Function.
I-1 Profile (Fig.1)
1
5
2. Volume Up (S2)
3. Volume Down (S3)
1 On/Off ( S1).
4. LED
5. DC Socket
6. Foldable Microphone
8. Battery Door
7. Speaker
9. Visor Clip
3
24
7
9
8
6
Fig. 1
User Manual
II-3 Pair the Hands-free Car kit with Your Mobile Phone
II-3-1 Put the hands-free Car Kit in pairing mode
II-3-2 Put your mobile phone in pairing mode
II-3-3 Pair the hands-free Car Kit with your mobile phone
Bluetooth
Bluetooth
Bluetooth
Make sure if pairing does not occur as expected, turn off the
hands-free Car Kit and your phone, then wait for 10 seconds.
Turn on them again and repeat from Step 3-1 to Step3-3
II-3-2-1 Follow the operation manual of your mobile
phone to start the pairing process. Typically, this has to be done
by going to a setup or connect menu and then selecting the options
to discover devices. may take several
seconds to establish a connection.
II-3-2-2 Your phone's display will indicate that it has found the new
device “BT 77V” and asks if you want to pair it. You should confirm
this. The phone's display would demand a passkey or PIN, then
you can enter a sequence of “0000”.
The green LED of hands-free Car Kit will flash every 3 seconds
indicating successful pairing. Usually the phone will also ask
whether you want to change the Car Kit's name. We recommend
you should approve the name of “BT 77V” and do not change it.
Bluetooth
Bluetooth Bluetooth
When the hands-free Car kit is powered off, press and hold S1 for 8
seconds. In the first 4 seconds, a low tone followed by a high tone
will indicate the hands-free Car Kit has turned on. At the same
time, Green LED will flash for a second. In the 2nd 4 seconds, a
high tone will occur. Then the red and green LEDs will flash
alternatively, which indicates the hands-free Car Kit has entered
into the paring mode.
.
Notice:
Notice:
Make Sure the batteries are fully charged.
II-4 Establish Link
II-5 Clip the Hands-free Car Kit onto Your Sun Visor
Bluetooth
After pairing, the mobile phone will show “connect”, then please select
“YES” to establish the link. Now you are ready to make and answer calls on
the hands-free Car Kit.
(Please refer to Fig. 3)
For other phones, please follow their operation manuals to establish
the link!
Notice:
7
6
II-6 Answer an Incoming Call
II- Transfer Calls between This Hands-free Car Kit and Your
Phone
7
7
II-8 Make a New Call by Using Voice Dialing
II-8-1 When using a mobile phone:
II-8-2 When using a mobile phone without built-in and
requiring a dongle:
When an incoming call is present, the hands-free Car Kit will ring. Press
S1 and you can answer the call. The green LED will continue to flash once
a second while the call is in session.
When you are in session, calls can be transferred from your
phone to the hands-free Car Kit and vice versa.
V- -1 From phone to the Car Kit
Press S1 once, the call will be transferred to the Car Kit.
V- -2 From Car Kit to the Phone
Please follow the operation manual of your phone.
II-8-1-1 Press S1 on the hands-free Car Kit shortly.
II-8-1-2 Put through the call
After the beep tone on the hands-free Car Kit, you can make a voice
dial by saying the name of the person on the hands-free Car Kit. The
call will be connected in a few seconds.
II-8-2-1Press S1 on the hands-free Car Kit shortly
II-8-2-2 Put through the call
After the beep tone on the hands-free Car Kit, you can make a voice dial
and the call will be connected in a few seconds.
7 Bluetooth
Bluetooth
Bluetooth
Bluetooth
Bluetooth
Bluetooth
Bluetooth
Make sure that the voice dialing function is probably set up in
the mobile phone and it is within the range of the hands-free Car Kit.
Make sure that the voice dialing function is probably set up in
the Mobile phone and it is within the range of the hands-free ar it.
Notice:
Notice:
CK
II-9 Mute the Microphone
II-9-1 To mute a microphone during an active call
II-9-2 To un-mute a call
II-10 End a Call
II-11 Reject a Call
II-12 Redial Last Dialed Number
II-13 Adjust the Speaker Volume
When the microphone is muted, press S2 for about 2 seconds. Then the
mute function will end and the periodic beep tone will stop.
While a call is in session on the hands-free Car Kit, press S1 and you will
disconnect the call. After the call is disconnected, the green LED will
flash normally.
When the hands-free Car Kit is ringing, press S1 until you hear a long beep
tone.
To redial the last dialed number, press S3 for 2 seconds. Short low tones
will indicate an attempt to redial.
While a call is in session, pressing and releasing S2 will increase the
speaker volume, and pressing and releasing S3 will decrease the speaker
volume.
Press S2for about 2 seconds and a beep tone will indicate the microphone
is muted. A periodic beep tone will be heard while the mute function is
active.
5
Fig. 3
CS8045
811
12
1310
9
II-1 Recharge the Low Batter
II-14-1 During recharging
II-14-2 Fully charge
II-15 Turn off the Hands-free Car Kit
III. Maintenance and Safe Use
(please refer to Fig.2)
The LED of this Car Kit will flash red instead of green when the battery
are low. There will also be a short beep every 2 minutes. Please
connect the charger cable to the Car Kit.
The LED shows a steady red light if the Car Kit is off,
and the red light will dim once every second while the Car Kit is on.
When the batteries are fully charged, the red and green LED will be
exchanged.
A steady green LED represents the Car Kit is off and fully charged.
And a green LED dims once every 3 seconds represents the Car Kit is
on and fully charged.
When the hands-free Car Kit is on, press and hold S1 for 3 seconds. A
high tone followed by a low tone will indicate that the Car Kit is
powered off. Red LED will turn on for a second. At last LED will turn
off when the Car Kit is powered off.
Use dry cloth to clean hands-free Car Kit!
Recycle the batteries after their life time!
Do not expose the Car Kit to liquid or moisture!
Do not expose the Car Kit to fire or open flames!
When the battery level is too low, the hands-free ar it will
automatically power off. It cannot be powered on again unless the
batteries are charged after 5 minutes.
◎
◎
◎
◎
4ies
CKNotice:
IV Package Contents.
3AA
BatteriesRechargeable
x
Provided
Provided
Accessories
1 X Car Charger
Status
Disclaimer:
Talk time and stand-by time of the Car Kit will vary depending on mobile phone
model being used.
Note:
BQB, CE and FCC approved
The word mark and logos are owned by the SIG, Inc. and any use of such
marks by In-Tech Electronics Ltd. is under license. Other trademarks and trade names are
those of their respective owners.
Bluetooth
Bluetooth Bluetooth
Federal Communication Commission Interference Statement
-
-
-
-
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
.Use only rechargeable batteriesWarning: