Intech Electronics CS8078 Bluetooth USB Dongle V2.0+EDR User Manual User s Manual

In Tech Electronics Ltd Bluetooth USB Dongle V2.0+EDR User s Manual

Manual

1
CS8078 User Manual
Installation steps
Step 1: Plug the Bluetooth USB Dongle into the computer USB Port.
Step 2: Insert the Installation software CD-ROM into the CD-ROM drive of your
computer.
Step 3:Install the program.If the installation program does not start automatically,
Please double click setup.exe file manually.Then you can follow up the
Instructions to finish the software installation.
Step 4:Restart the computer to make sure that the installed Bluetooth device takes
Effect.
2
Step 5:When the computer has been restarted,start the Bluesoleil application by
Clicking {Start ->Programs->IVT Bluesoleil->Bluesoleil}.
Step 6: Make sure the Bluetooth Device is detected.After it is detected,you can
then use the profiles provide by the application.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
3
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating instructions
for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

Navigation menu