Intermec Technologies 1007CP01 Mobile Computer User Manual

Intermec Technologies Corporation Mobile Computer CK3UM

a href="https://usermanual.wiki/Intermec-Technologies" itemprop="url"> Intermec Technologies >

Contents

user manual 2

CK3R/CK3X Mobile Computer Compliance Insert Models 1007CP01, 1007CP02, 1007CP02L, 1007CP02-NI    ME04 Complies with IDA Standards DA 102905  For Users in English-Speaking Regions (en) Intermec Model 1007CP02 is available certified for use in typical commercial environments as well as an optional version, Model 1007CP02- NI, certified for use in Division 2 hazardous locations in the United  States and Canada. This document addresses both use environments. The additional precautions for safe use of the Division 2 rated version are at the end of this document. Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future reference.  Users of this product are cautioned  to use accessories and peripherals approved by Intermec Technologies Corporation. The use of accessories other  than those recommended,  or changes to this product that are not approved  by Intermec  Technologies Corporation, may void the compliance  of this product and may result in the loss of the user’s authority to operate the equipment.  Battery,  Charger, and Power Supply Information  Caution: For use with Intermec  battery pack Models AB17, AB18, 1001AB01, or 1001AB02 only. See battery instructions. For power supply, use PhiHong  model PSA10F-050Q-R (Intermec P/N 851-099-001). No user-serviceable parts. Charge only in or with Intermec model AC20, AD20, AD21, AD22, or AA23 with AE23 charger; or with Intermec base 1002UU01, 1002UU04 or 1002UU05 using Intermec adapter  1002UD02 or 1002UD05. Use of incorrect charger may present a risk of fire or explosion. Promptly dispose of used battery pack according to the instructions.  Caution: The battery pack used with this product may ignite, create a chemical burn hazard, explode, or release toxic materials if mistreated. Do not incinerate,  disassemble, or heat above 100 °C (212 °F). Do not short circuit; may cause burns.  Keep away from children.  Battery Recycling Information    Li-ion    Li-ion  This product contains  or uses a lithium-ion (Li-ion) main  battery. When the battery reaches the end of its useful life, the spent battery should  be disposed of by a qualified recycler or hazardous  materials handler.  Do not mix this battery with the solid waste stream. Contact  your Intermec  Technologies Service Center for recycling or disposal information.  802.11 Radio Precaution Statement Caution: Users are responsible for configuring the channels of operation that comply with their country  regulatory standards.  A Wireless Network Administrator should review the operating  restrictions  detailed within the Access Point installation manual.  Radiation  Exposure Statement  Warning: This equipment complies with International Commission  on Non-Ionizing  Radiation Protection  (ICNIRP), IEEE C95.1, Federal Communications Commission  Office of Engineering  and  Technology  (OET) Bulletin 65, Canada RSS-102, and European Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation.  For CK3R (Model 1007CP01): If a body worn accessory is not purchased  from Intermec, the accessory must  contain  no metal and provide a 1.0 cm (0.39 in) space between the device and the body. For CK3X (Model 1007CP02 & 1007CP02L): If a body worn accessory is not purchased  from Intermec, the accessory must contain  no metal and  provide a 1.0 cm (0.39 in) space between the device and the body. Use of antennas  and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits established for this equipment. To find RF exposure information, go to www.intermec.com  > Products > Computers > Handheld Computers  > CK3 > Manuals tab, and then scroll down to Regulatory Information.  U.S.A. and Canada Laser Compliance and Precaution The 1007CP01, 1007CP02, 1007CP02L, and  1007CP02-NI are registered with the CDRH as a Class II LASER Product  (21 CFR Subchapter J, Part 1040). This product has a maximum output of 1 mW at 630-680 nm.  Caution: There are no user serviceable parts inside the 1007CP01, 1007CP02, 1007CP02L, or 1007CP02-NI. Use of controls or adjustments, or performance of procedures other than those specified herein, may result in hazardous  laser light exposure of up to 1 mW at 630-680 nm.  Note: There are no controls  or adjustments provided for routine operation or maintenance of the 1007CP01, 1007CP02, 1007CP02L, or 1007CP02-NI.      1
Download:
Mirror Download [FCC.gov]
Document ID1756833
Application IDY9rm7N27heJVyjtIzZOLlg==
Document Descriptionuser manual 2
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize36.24kB (452977 bits)
Date Submitted2012-07-31 00:00:00
Date Available2013-01-27 00:00:00
Creation Date2012-07-25 14:18:16
Producing SoftwareAdobe PDF Library 10.0
Document Lastmod2012-07-25 14:18:21
Document Title933-287-001.fm
Document CreatorAcrobat PDFMaker 10.1 for Word
Document Author: tdavis
FCC ID Filing: EHA-1007CP01

Navigation menu