Intermec Technologies 2011B 2011B radio in 700C User Manual Mobile

Intermec Technologies Corporation 2011B radio in 700C Mobile

Contents

User Manual

578-100-083   Revision C Page 1 of  2*578-100-083C*  *578-100-083C*Compliance Statement InsertDevice Name:  Pen Notepad Computer Model Number:  Model 700C (740, 750, & 760 Configurations)The responsible party for the compliance of this device is: Intermec Technologies Corporation6001 36th Avenue WestEverett, WA  98203  USA(425) 348-2600CAUTION:  See users guide instructions for handling, charging, and replacing batteries.  Failure to follow those instructions can result inpersonal injury, fire, or battery explosion.This product conforms to the following approvals.   The user(s) of this product are cautioned to use accessories and peripherals approved byIntermec Technologies Corporation.  The use of accessories other than those recommended, or changes to this product that are not approved byIntermec Technologies Corporation, may void the compliance of this product and may result in the loss of the users authority to operate theequipment.FCC Digital Emissions ComplianceThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed toprovide reasonable protection against harmful interference in a residential installation.  This equipment generates, uses and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructions, may cause harmful interference to radio communications.  However, there is no guarantee that interference will notoccur in a particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the radio or television receiving antenna.• Increase the separation between the computer equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the radio or television receiver is connected.• Consult the dealer or an experienced radio television technician for help.Canadian Digital Apparatus ComplianceThis Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.WARNING! RF (Radio Frequency) Exposure Regulations for United States and Canada.RF safety requirements mandate the use of Intermec approved accessories.  This device can only be co-located with transmitters approved for theIntermec 700.  Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyondthe government limits established for this equipment.  A 20-cm (8-inch) passing distance must be maintained from any body part of the user ornear by persons and the antennas of the Intermec 700.LASER COMPLIANCE AND PRECAUTIONThe 700C is registered with the CDRH as a Class II Laser Product (CFR 21 Subpart J).  This product has a maximum output of 1.0 mW at 630-680 nm.WarningThere are no user serviceable parts inside the 700C.  Use of controls or adjustments, or performance of procedures other thanthose specified herein, may result in hazardous laser light exposure of up to 1 mW at 630-680 nm.AvertissementAucune des pièces internes du modèle 700C ne peut être réparée par l’utilisateur.L’utilisation d’appareils de contrôle et ajustement ainsi que l’exécution de procédures d’utilisation autres que celles qui sontindiquées dans la présente publication peuvent entraîner une exposition dangereuse à la lumière laser pouvant atteindrejusqu’à 1 mW à 630-680 nm.Note:  There are no controls or adjustments provided for routine operation or maintenance of the 700C.Remarque:  Aucun appareil de contrôle ou d’ajustement n’est fourni pour les opérations de routine ou de maintenance del’appareil 700C.The label shown below is attached on the underside of the 700C devices containing a laser scanner.

Navigation menu