Intermec Technologies AR4 RFID Reader User Manual 30001

Intermec Technologies Corporation RFID Reader 30001

Contents

user manual 30001

AR 4 C ompliance
lnsert
Fe
ht.r-".
Worldwide Headquarters
6001
36th Avenue West
E verett,Washington
98203
u.s.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
O 2007 lntermec T echnologie5
C orporation. All rights reserved.
AR 4
C ompliance
Insert
A
A
C aution: This marking indicates that the user should read all included do.o-"ot"ion before us e..
C aution: For use with Intermec Model 751G only. F or power supply, use
only Intermec model 851-O65-0Of
(P /N 851-065-005) ot ltE 23. No user-s erviceable
parts.
Us ers of this product are cautioned to use acces sories
and peripherals approved by Intermec Technologies C orporation. T he use
of access ories
other than those recommended, or changes to this product that are not approved by Intermec Technologies C orporation, may void the
compliance of this product and may res ult in the loss of the us ert authority to operate the equipment.
FC ( Digital
E missions
(ompliance
The AR Z has been tested and found to comply with the limits for a C l;ss B digital device, pursuant to P art l5 of the F C C R ules. These limits
are des igned to provide reasonable protection against harmful interference in a residential installation. This eq"ipment_generates , uses,
and
can radLte radio frequency en.rgy ind, if not installed and us ed in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment offand on, the user is encouraged
to try to correct the interference by one or more of the following measures:
. R eorient or relocate the radio or television receiving antenna.
. Increase the separation between the computer equipment and receiver.
. Connecr the equipmenr into an outlet on a circuit different from that to which the radio or television receiver is connected.
. Consult the deder or an experienced radio television technician for help.
S pecifit
Absorytion
R ate
(S AR )
R adio
Wave E xposure and
S pecific Absorption
R ate
(S AR )
Information
for Model AR 4
(onfiguratiom
with R F ID
(ontactless
S mart
(ard
This product
is categorically exempr
from
routine S AR evaluation.
The FC C excludes
P art
15.225 devices
from routine
S AR
evduation.
There are
no R F
exposure test
requirements specified
for P art
15.225 devices
in 47 C F R C hapter
l, S ection
2.1093.
| ffi || lllll
lllll llll llll ll
lllll lllll llll
llll ll lllll lllll lll
I llll
P /N
933-l2l-001
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.

Navigation menu