Intermec Technologies RM91501X04 RF Tag Reader User Manual RM915Manual

Intermec Technologies Corporation RF Tag Reader RM915Manual

User Manual

ROGERS LABS, INC. Intermec Technologies Corporation
4405 W. 259th Terrace MODEL: ITRM91501X04
Louisburg, KS 66053 Test #: 0200205 FCCID#: EHA-RM91501X04
Phone/Fax: (913) 837-3214 Test to: FCC Parts 2 and 15 Page 1 of 1
RM915Manual.doc 2/12/2002
Compliance Statement Insert
Device Name: RF Identification Radio Module Model Number: ITRM91501X04
FCC ID: EHA-RM91501X04
The responsible party for the compliance of this device is: Intermec Technologies Corporation
6001 36th Avenue West
Everett, WA 98203 USA
(425) 348-2600
This product conforms to the following approvals. The user(s) of this product are cautioned to use accessories and peripherals
approved by Intermec Technologies Corporation. The use of accessories other than those recommended or changes to this
product that are not approved by Intermec Technologies Corporation may void the compliance of this product and may result in
the loss of the users authority to operate the equipment.
This device complies with part 15 of the FCC and Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Digital Emissions Compliance
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and , if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment is a residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
Canadian Digital Apparatus Compliance
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.
WARNING: per the FCC and Canadian RF (radio frequency) exposure requirements,
(1) Antennas must be supplied and installed as recommended by Intermec Technologies to ensure compliance to RF exposure
requirements. The antennas approved for use are Intermec part numbers 05488-01 and 805-576-002. Correct antenna
mounting is fully described within the Intermec ITRM91501X04 Users Guide.
(2) When installing and using Intermec approved remote antennas associated the RFID tag reader, a 20-cm (8-inch) passing
distance must be maintained from any body part of the user or near by persons and the remote antenna. The antenna must
not be touched during transmitter operation.
(3) Cables attached to the remote antennas must have a minimum length as provided from Intermec to insure the proper losses
to control RF exposure.
(4) RF safety requirements mandate this device cannot be co-located with other transmitters.
WARNING CANADA USERS: To prevent radio interference to the licensed service, this device is intended to be operated
indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is
subject to licensing. The end user is responsible to obtain the license.

Navigation menu