Intermec Technologies UAPRFID-24 User Manual Manual Supplement

Intermec Technologies Corporation Manual Supplement

Contents

Revised Manual Supplement

P/N 06XXXX-001Important 2100 Information!(For 900 MHz and 2.4 GHz RFID Modules)ContentsFor Users in the United States and Canada ...................................................................................2
22100 Manual SupplementFor Users in the United States and CanadaPlace this supplement in your manual.This device complies with Part 15 of the FCC Rules and with RSS-210 ofIndustry Canada. Operation is subject to the following two conditions: (1) Thisdevice may not cause harmful interference, and (2) This device must accept anyinterference received, including interference that can cause undesiredoperation.Federal Communications Commission ComplianceThis equipment is intended for operation in a commercial environment, incompliance with the requirements for a Class A digital device, pursuant to Part15 of the FCC Rules, and it must not be used in a residential environment;however, it has also been tested and found to comply with the more stringentrequirements for a Class B device, pursuant to Part 15 of the FCC Rules. Itgenerates, uses, and can radiate radio frequency energy. If not installed andused in accordance with the instruction manual, it may cause interference toradio communications. If this equipment causes interference, the user will berequired to correct the interference at the user’s own expense.Note: In order to maintain compliance with FCC Rules, the input/output (I/O) cablesthat interconnect between the device and any peripheral must be as specified byIntermec.Installation Warning:FCC regulations limit exposure to radiofrequency (RF) radiation. To complywith these regulations, this device must be installed in such a way that theoperators of this device will not be closer than 7 cm (2.75 inches) from the coveron the antenna assembly under normal operation conditions. While the deviceis on, the operator’s body and parts of the body such as eyes, hands, or head,must be 7 cm (2.75 inches) or farther from the cover of the antenna assembly.The installer should also protect him/herself from RF exposure by notoperating the device while they are closer than the distance mentioned above.FCC regulations also require that the antenna assembly of this device beinstalled in accordance with the installation procedures in this manual to allowthe operator to comply with this limit.Operator Warning:FCC regulations limit exposure to radiofrequency (RF) radiation. To complywith these regulations, the operators of this device must maintain adistance ofat least 7 cm (2.75 inches) from the cover on the antenna assembly undernormal operation conditions. While the device is on, the operator’s body andparts of the body such as eyes, hands, or head, must be 7 cm (2.75 inches) orfarther from the cover of the antenna assembly.
32100 Manual SupplementFor Users in the United States and Canada (cont.)Industry Canada ComplianceThis Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.This device requires a radio license, unless it is used totally inside a building.(The user must obtain this license.)Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur lematériel brouilleur du Canada.Cet appareil exige une license radio à moins d’être entièrement installé dans unbâtiment. (L’utilisateur doit obtenir cette license.)Safety Agency ApprovalsThis device is UL Listed and CSA Certified.CautionChanges or modifications not expressly approved by Intermec could void theuser’s authority to operate this equipment.P/N 06XXXX-001

Navigation menu