Itron 100WC AMR transceiver device for utility meters User Manual

Itron Inc AMR transceiver device for utility meters Users Manual 1

a href="https://usermanual.wiki/Itron" itemprop="url"> Itron >

Contents

Users Manual 1

    Water Solutions 100W and 100WP Datalogging ERT Module Installation Guide  TDC-0909-004
  Identification 100W and 100WP Datalogging ERT Module Installation Guide  11/14/2011   TDC-0909-004  Copyright ©  2010 - 2011 Itron, Inc. All rights reserved.  Confidentiality Notice The information contained herein is proprietary and confidential and provided subject to the condition that (i) it is held in confidence except to the extent required otherwise by law and (ii) it is used only for the purposes described herein. Any third party given access to this information is similarly bound in writing.  Compliance Statement This device complies with Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Operation is subject to the following two conditions:       • This device may not cause harmful interference.       • This device must accept any interference that may cause undesirable operation.   This device must be permanently mounted such that it retains a distance of 20 centimeters (7.9 inches) from all persons in order to comply with FCC RF exposure lev els.   This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:   Reorient or relocate the receiving antenna.   Increase the separation between the equipment and receiver.   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.   Consult the dealer or an experienced radio or TV technician for help.    Compliance Statement   This equipment complies with policies RSS-210 and RSS-GEN of the Industry Canada rules.   Operation is subject to the following two conditions:       (1) this device may not cause interference, and       (2) this device must accept any interference, including interference that may cause undesired operation of the device.   Déclaration de conformité Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :  (1) l'appareil ne doit pas produire de brouillage, et  (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.   Compliance Statement Canada Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.   Déclaration de Conformité  Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.   Trademark Notice Itron is a registered trademark of Itron, Inc. All other product names and logos in this documentation are used for identification purposes only and may be trademarks or registered trademarks of their respective companies.   Warning  To prevent ignition of flammable or combustible atmospheres, disconnect power before servicing.  Warning  Follow these procedures to avoid injury to yourself or others: •  The lithium battery may cause a fire or chemical burn if it is not disposed of properly. •   Do not recharge, disassemble, heat above 100° Celsius (212° Fahrenheit), crush, expose to      water, or incinerate the lithium battery. Fire, explosion, and severe burn hazard. •   Keep the lithium battery away from children. •  Replace the lithium battery only with batteries meeting Itron specifications. Any other battery      may cause a fire or explosion.  Warning  ELECTROMAGNETIC COMPATIBILITY   Use only approved accessories with this equipment. Unapproved modifications or operation beyond or in conflict with these instructions for use may void authorization by the authorities to operate the equipment.   Warning  This unit cannot be modified and is not repairable. Attempts to modify or repair this device will void the warranty.
Download:
Mirror Download [FCC.gov]
Document ID1589610
Application ID0QiCBUJHyr9FGuuVx7zBKw==
Document DescriptionUsers Manual 1
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeYes
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize184.8kB (2310018 bits)
Date Submitted2011-11-29 00:00:00
Date Available2011-11-29 00:00:00
Creation Date2011-11-17 07:10:08
Producing SoftwareMicrosoft® Office Word 2007
Document Lastmod2011-11-17 07:11:52
Document TitleUsers Manual 1
Document CreatorMicrosoft® Office Word 2007
FCC ID Filing: EWQ100WC

Navigation menu