JBT Smart Lighting 875050 Bluetooth Remote Control User Manual

Shenzhen JBT Smart Lighting Co.,LTD Bluetooth Remote Control

User Manual

Bluetooth Remote control
Functionrequirements:
1.Keysteppingadjustbrightness:lever10,5%100%(accordingtothe
oldmodel),theusercanadjustthebuttonwhenitspecifythecolor
temperatureorthecolor;
2.TheorderofRGBcolorchange:Theoriginalothercolormixingorderis
unchanged,MoveR,G,Btothefirstthreepositions,R,G,Bneedto
adjustbrightnessincludinglever5(5%25%50%75%100%),the
mixingcolordon’tneedtoadjust;
3.Keysteppingadjustbrightness:lever10,100%5%(accordingtothe
oldmodel),theusercanadjustthebuttonwhenitspecifythecolor
temperatureorthecolor;
4.Thebuttonofcolortemperatureconverse:Lever5(2700K3000K
4100K5000K6500K)(accordingtotheoldmodel);
5.Switch:onlypressthisbuttontoturnonthelightandthendoother
operations;
1. thebuttonofbrightnessbrighten
2. TheGradientbuttonofRGB
3. Thebuttonofbrightnessdim
4.Thebuttonofcolortemperature
converse
5. Switch
6.Productmatching:longpresstheON/OFFbuttonandthebuttonof
colortemperaturechangefor3seconds;
7.Reset:longpresstheON/OFFbuttonfor10seconds;
8.AdjustmentofProductcancelstheoperationoflongpresstoreduce
powerconsumption
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be u
sed in portable exposure condition without restriction

Navigation menu