JJPlus WCTC301 BLE Module User Manual WCTC301 QIG

JJPlus Corporation BLE Module WCTC301 QIG

User Manual

Federal Communication Commission Interference Statement  This  device  complies  with  Part  15  of  the  FCC  Rules.  Operation  is  subject  to  the following two conditions: (1) This device may not cause harmful interference, and (2) this  device  must  accept  any  interference  received,  including  interference  that  may cause undesired operation.  This  equipment  has been  tested  and  found  to  comply  with the  limits  for  a  Class  B digital  device,  pursuant to  Part  15  of  the  FCC  Rules.    These  limits are designed  to provide  reasonable  protection  against  harmful  interference  in  a  residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference  to  radio  communications.    However,  there  is  no  guarantee  that interference will not occur in a particular installation.    If this equipment does cause harmful  interference  to  radio  or  television  reception,  which  can  be  determined  by turning  the  equipment  off  and  on,  the  user  is  encouraged  to  try  to  correct  the interference by one of the following measures:   Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help.  FCC Caution:    Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.  This  transmitter  must  not  be  co-located  or  operating  in  conjunction  with  any other antenna or transmitter.
Radiation Exposure Statement: This  equipment  complies  with  FCC  radiation  exposure  limits  set  forth  for  an uncontrolled  environment.  This  equipment  should  be  installed  and  operated  with minimum distance 20cm between the radiator & your body.  This device is intended only for OEM integrators under the following conditions: The  transmitter  module  may  not  be  co-located  with  any  other  transmitter  or antenna. The co-transmitting with other radio will need a separate evaluation. As  long  as  this  condition  is  met,  further  transmitter  test  will  not  be  required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed  IMPORTANT  NOTE:  In  the  event  that  this  condition  cannot  be  met  (for  example certain laptop configurations or co-location with another transmitter), then the FCC authorization  is  no  longer  considered  valid  and  the  FCC  ID  cannot  be  used  on  the final  product.  In  these  circumstances,  the  OEM  integrator  will  be  responsible  for re-evaluating  the  end  product  (including  the  transmitter)  and  obtaining  a  separate FCC authorization.  End Product Labeling The final end product must be labeled in a visible area with the following: “Contains FCC  ID:  W23-WCTC301”.  The  grantee's  FCC  ID  can  be  used  only  when  all  FCC compliance requirements are met.  Manual Information To the End User The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this RF module in the user’s manual of the end product which integrates this module. The end user manual shall include all required regulatory information/warning as show in this manual.

Navigation menu