JSW Pacific CCD-405S Wireless Mini Camera User Manual
JSW Pacific Corporation Wireless Mini Camera Users Manual
Users Manual
Important!
Please read this booklet carefully
before installing or using these units.
DANGER-HIGHVOLTAGE-These units
should ONLYbe opened by an authorized
technician ifservice is required.
Safety Precautions
For correct and safe operation of this
system, it is essential that installers, end-
users and service technicians should follow
all safety procedures outlined in this
manual. Specific Warning and Caution
statements (and/or symbols) are marked on
the unitswhere needed.
Warning and, Caution Statements
"WARNING"indicates a situation where
failure to followproper procedures can
cause personal injury.
"CAUTION"indicates a situation where
failure to followproper procedures can
cause damage to the equipment.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio fTequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation, If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
.Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
. Consult the dealer or an experienced radiorrV technician for help.
FCC Caution :To assure continued compliance, any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate this equipment.
(Example. use only shielded interface cables when connecting to computer or peripheral devices).
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
-"--.
