JVC KENWOOD 409300 800 MHz Digital Mobile Transceiver User Manual Safety Instructions

JVC KENWOOD Corporation 800 MHz Digital Mobile Transceiver Users Manual Safety Instructions

Contents

Users Manual Safety Instructions

Download: JVC KENWOOD 409300 800 MHz Digital Mobile Transceiver User Manual Safety Instructions
Mirror Download [FCC.gov]JVC KENWOOD 409300 800 MHz Digital Mobile Transceiver User Manual Safety Instructions
Document ID1380367
Application IDUYcETHTd5uaz91VwD9Qn/Q==
Document DescriptionUsers Manual Safety Instructions
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize3.72kB (46539 bits)
Date Submitted2010-11-23 00:00:00
Date Available2010-11-23 00:00:00
Creation Date2017-11-07 07:21:00
Producing SoftwareGPL Ghostscript 9.18
Document Lastmod2017-11-07 07:21:00
Document TitleUsers Manual Safety Instructions
Document CreatorAdobe InDesign CS2_J (4.0.5)

MANDATORY SAFETY INSTRUCTIONS TO INSTALLERS AND USERS
• Use only manufacturer or dealer supplied antennas.
• Antenna Minimum Safe Distance: 60 cm (2 feet), 50% duty Cycle.
• Antenna Gain: 0 dBd referenced to a dipole.
The Federal Communications Commission has adopted a safety standard for
human exposure to RF (Radio Frequency) energy which is below the OSHA
(Occupational Safety and Health Act) limits.
• Antenna Mounting: The antenna supplied by the manufacturer or radio dealer
must not be mounted at a location such that during radio transmission, any
person or persons can come closer than the above indicated minimum safe
distance to the antenna, i.e. 60 cm (2 feet) , 50% duty Cycle.
• To comply with current FCC RF Exposure limits, the antenna must be
installed at or exceeding the minimum safe distance shown above, and in
accordance with the requirements of the antenna manufacturer or supplier.
• Vehicle installation: The antenna can be mounted at the center of a vehicle
metal roof or trunk lid, if the minimum safe distance is observed.
• Base Station Installation: The antenna should be fixed-mounted on an
outdoor permanent structure. RF Exposure compliance must be addressed
at the time of installation.
Antenna substitution: Do not substitute any antenna for the one supplied or
recommended by the manufacturer or radio dealer.
You may be exposing person or persons to excess radio frequency radiation. You
may contact your radio dealer or the manufacturer for further instructions.
Maintain a separation distance from the antenna to person(s) of at least 60 cm (2 feet),
50% duty Cycle.
“This transmitter is authorized to operate with a maximum duty factor of 50%,
in typical push-to-talk mode, for satisfying FCC RF exposure compliance
requirements.”
You, as the qualified end-user of this radio device must control the exposure
conditions of bystanders to ensure the minimum separation distance (above) is
maintained between the antenna and nearby persons for satisfying RF Exposure
compliance. The operation of this transmitter must satisfy the requirements of
Occupational/Controlled Exposure Environment, for work-related use, transmit
only when person(s) are at least the minimum distance from the properly
installed, externally mounted antenna. Transmit only when people outside the
vehicle are at least the recommended minimum lateral distance away from the
antenna/vehicle.
B59-2633-00

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Encryption                      : Standard V4.4 (128-bit)
User Access                     : Print, Extract, Print high-res
Create Date                     : 2010:07:23 11:06:52+09:00
Creator                         : Adobe InDesign CS2_J (4.0.5)
Modify Date                     : 2010:11:23 11:20:02-05:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Instance ID                     : uuid:94797a19-efd5-4848-9405-22cce1dff74d
Document ID                     : adobe:docid:indd:ea0c36e4-97d2-11df-8b6c-9c7564ecb615
Rendition Class                 : proof:pdf
Derived From Instance ID        : 250ab988-745b-11de-ae7f-fd4a4c32cb2c
Derived From Document ID        : adobe:docid:indd:250ab984-745b-11de-ae7f-fd4a4c32cb2c
Metadata Date                   : 2010:11:23 11:20:02-05:00
Creator Tool                    : Adobe InDesign CS2_J (4.0.5)
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Image                 : (Binary data 9420 bytes, use -b option to extract)
Format                          : application/pdf
Producer                        : Adobe PDF Library 7.0
Trapped                         : False
Page Count                      : 1
EXIF Metadata provided by EXIF.tools
FCC ID Filing: K44409300

Navigation menu