Jablotron RC87 Wireless wrist button- Component of alarm system User Manual Exhibit 7 Instruction manual RC87

Download:
Mirror Download [FCC.gov]
Document ID	883024
Application ID	JyRWiwz+t+/Qw1998HNHvA==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	3.88kB (48521 bits)
Date Submitted	2007-12-21 00:00:00
Date Available	2007-12-21 00:00:00
Creation Date	2007-10-31 12:57:24
Producing Software	AFPL Ghostscript 8.53
Document Lastmod	2007-10-31 12:57:24
Document Title	Exhibit 7 Instruction manual RC87
Document Creator	FreePDF XP 3.05 - http://shbox.de
Document Author:	eschlemmer

The RC-87 wireless wrist button
The RC-87 is a component of Jablotron’s Oasis 80 alarm system. It
allows users to trigger panic alarms or to control appliances remotely.
It is especially designed for personal calls for help. The batterypowered wireless button communicates via OASIS radio protocol.
The button can be worn on your wrist like a watch or it can hang
around your neck (an appropriate strap is supplied in the package).
Caution: When hanging around the neck, the strap must be
equipped with a mechanical release which disconnects the strap
whenever the loading force exceeds 40N.
Testing the panic button
The signals received by the control panel from the RC-87 can be
checked and measured. See the control panel manual for details.
Controlling electrical appliances
The button can be used with an Oasis control panel for triggering panic
alarms. Take the following steps to enroll the button:
The RC-87 can also be used with other Jablotron products which
communicate via Oasis radio protocol, e.g. the JA-80L wireless siren,
or relay receiving modules series UC-8x and AC-8x (see the manuals
of these particular products for details).
The RC-87 transmits the same kind of signal as transmitted when a
pair of buttons is pressed simultaneously on an RC-80 keyfob.
The RC-87 can be enrolled to several receivers at once, e.g. alarm
triggering can also cause lights to be turned on.
1.
Battery replacement
Enrolling to an Oasis control panel
Enter enrollment mode on the control panel by keying in “1” in
Service mode (the desired device address can be chosen by the
arrow keys).
2.
Hold the button until you see the button’s LED flash once.
3.
The button will enroll to the chosen position.
4.
Exit enrollment mode by pressing “#”.
The button unit monitors its battery voltage and if too low, a report is
sent to the control panel to inform the installer or user. A critical
voltage level is also indicated by an LED flashing fast 3 times every 5
minutes. The battery should be replaced as soon as possible. As with
configuration, the button can be opened by unscrewing the 4 screws
from the bottom part. We recommend battery replacement be done by
a service technician.
Expired batteries should not be thrown into the garbage, but disposed
of according to local regulations.
The control panel’s natural reaction to the button is a Panic alarm. A
different reaction can be programmed if desired.
The wrist button can be enroled by inserting the battery (step 2).
Technical specifications
Functionality
By factory default, the button reacts to pressing with beeps and
flashes. This way it is signalled that the time is getting close for alarm
triggering. If you re-press the button within 5 seconds, the prealarm condition will be cancelled. If no cancellation occurs, an alarm
signal will be sent after 5 seconds. This feature allows the user to
cancel accidental button pressing.
The button can be reconfigured to another function as follows:
1.
Open the button unit (release 4 screws from below) and pull out
the electronics.
2.
Disconnect the battery from the holder (it can be pulled out using
a thin tool). Wait for 15 seconds.
3.
Press and hold the button with one hand and insert the battery
with your other hand. Keep the button pressed until beeps are
heard (after 2 seconds approximately). The number of beeps (1, 2
or 3) indicates the mode which has been set, see below.
Voltage
lithium battery type CR 2032 (3.0 V)
Typical battery lifetimeapprox. 3 years (for 1 daily activation
maximum)
Communication band
868 MHz, Oasis protocol
Communication range
approx. 50 m (open area)
Environment
external protected
Housing
IP-44
Operational temperature
-25 to +50 °C
Can be operated according to
ERC REC 70-03, FCC Part 15
Complies with
ETSI EN 300220, EN 50130-4, EN 55022,
EN 60950-1, EN 50134-2, ANSI C63.4
FCC ID VL6RC87
Jablotron Ltd. hereby declares that the RC-87 is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC and complies with part 15 of
the FCC rules. Operation is subject the the following two
conditions: 1. This device may not cause harmful interference,
and 2. this device must accept any interference received,
including interference that may cause undesired operation..
The original of the conformity assessment can be found at
www.jablotron.com, Technical Support section Changes or
modifications no expressly approved by Jablotron could void the
user´s authority to operate the equipment
1 beep
The button will beep and flash 5 seconds after being
pressed (this mode allows the cancelling of accidental
pressing).
2 beeps
Respond to a single press instantly by triggering an
alarm and sounding a single beep.
3 beeps
Respond to a single press instantly and silently by
triggering an alarm.
Choose the desired function by repeating steps 2 and 3, then
reassemble the button. This configuration will not be affected by
normal battery replacement (reconfiguration is only possible in the
above way).
Note: Although this product does not contain any harmful materials
we suggest you return the product to the dealer or directly to the
producer after use. See www.jablotron.com for details.
46
Pod Skalkou 33
466 01 Jablonec nad Nisou
Czech Republic
Tel.: +420 483 559 999
fax: +420 483 559 993
Internet: www.jablotron.cz
42
The RC-87 wireless wrist button
MKT 51000_PTS_FCC

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Page Count                      : 1
Producer                        : AFPL Ghostscript 8.53
Create Date                     : 2007:10:31 12:57:24
Modify Date                     : 2007:10:31 12:57:24
Title                           : Exhibit 7 Instruction manual RC87
Creator                         : FreePDF XP 3.05 - http://shbox.de
Author                          : eschlemmer

EXIF Metadata provided by EXIF.tools