Jakks Pacific RC24060T27 RC Car User Manual

Jakks Pacific (HK) Ltd. RC Car

User Manual

Download: Jakks Pacific RC24060T27 RC Car User Manual
Mirror Download [FCC.gov]Jakks Pacific RC24060T27 RC Car User Manual
Document ID338318
Application ID6ta8iFtHUqbGnJejDbiKQQ==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize62.2kB (777444 bits)
Date Submitted2003-07-08 00:00:00
Date Available2003-07-08 00:00:00
Creation Date2003-07-08 10:24:55
Document Lastmod2003-07-08 15:42:05
Document TitleUser Manual
Document CreatorHP 9100C Digital Sender
Document Author: ITS ELECTRIC TOY

STEP 1: BATFERV INSTALLATION
-Fladid Control Handset
1 Switch the power to "OFF".
2 Unscrew the battery compartment cover located on the
back of the handset with a Phillips screwdriver and remove.
(see Fig. 1)
3 Insert 9V Alkaline batteries (not included) in the
proper direction as indicated inside the battery
compartment. (see Fig. 1)
4. Replace the battery cover & tighten screw securely.
5. Switch the power to “ON".
Figure 1 Figure 2
External Charger
i. Unscrew the battery compartment cover with a Phillips
screwdriver & remove. (see Fig. 2)
2. Insert 3 AAA (1 EV) Alkaline batteries (not included) in the
proper direction as indicaied inside the battery
compartment. (see Fig. 2)
3. Replace the battery cover a. tighten screw securely.
STEP 2: CHARGING CAR BATTERY
1. Place the car on the charging pass inside or the helmet
controller.
NOTE: irie up the holes on the bottom oi the car with the pegs
oi the charger. Once on the charging base, the car will fully
change n approximately 45 seconds. Repeat when the cars
charge stuliy drained.
2. To provide maximum speed and duration fully charge the
vehitmle DO NOT PLACE A FULLV CHARGED CAFl BACK
ON THE CHAFIGING BASE, THIS MAY DAMAGE THE
PRODUCT!
NOTE- The Charging indicator on the Charger will light up only
when tie racer is charging.
3. Remove your CAR from the Helmet Charger and place it on
the ground for racing.
1:54 R/E EBA/TRDL
INSTRUETIUNE
STEP 3: RACING YOUR CAR
1. Switch the Remote Control Handset to "ON'
2. Extend the Antenna. (seei Fig 4)
3. Push the FOFIWAFID, BACKWARD LEFT and RIGHT
buttons to race your CAR in any directionl (see Fig 5. 6)
4. Alter approximately 2 minutes, your CAFi will begin to lose
its power. Simply ioliow the stops outlined in the "Charging
Your CAFi’ section to rechargeyour GAR and race again!
Race the 27 MHz Nascar ‘Agalnsrthe 49 MHz racers for
awesome competitive racing action!
FORWARD
REVERSE LEFT RIGHT
Figuieo
THE NASCAR TUNEQUP: STEERING
ADJ USTMENT
1. Adjust your CAH'sfsteering by rotating the Steering Knob bit
by bit. (see Fig. 7)
2. Aiter you have made an adjustment, place your CAR on the
ground and take It tor a spinl
3. Simply repeat these simple steps until you get the best
steering action for your CAR.
ADJUST THE
STEERING
new. 5
item no. 24060
TROUBLE SHOOTING
.. , . . , , WEENTHE REM , ECON RO’L ANDSET AND THE RACER:
~ Make sureyou have urned ON the RemoteContrcls ’ _ . ., , .. , ,. g. ,
Make sure‘ruou'r CAT-tracer is ully charged. ‘ ‘
Checkmatthe.batteriesare insened properly. ,
Replace the old batteries with new alkaline batte es,
Moye the remote control handsetrclcser to your CAR to determine'the bestcommunication between the Remote‘Handset andthe
~ Racer. (The operating rengeis approximately 6 toe’teet.) »‘ i 3 ' ' . S " . ' ~ . ' . ‘. ~ .
~ Dcnol'operated gthunderstorms. . i , . a . ‘ ’ I, : . ‘ i ,
- Avoid water when racing your CAR In addition. do not submerge your Racer, Charging Unit or Handset in water.
' whenyour vehicle starts to lose powe it may experience loss of pertormance ability, Ii thishappens, simply recharge your CAR
again. ' , . . , ., . .
SAFE BATTERY PRECAUTIONS ‘ NOTES: . , ~ : -
’~ Do not disposethe batteries in'lire; batteries may leak cr_ ,, ' , vTh‘is’ eouip’menthas been tested and tound to comply With
‘ explode. , ,, ‘ ' ~ ' limits lora'Class B digital device, pursuant to Pan 15 of the
- Different types ofbatteries or new and used batteries are FCC Rules”, These limits are designed rovide reasonable
not to be mixed. protection against harmful interference in residential
- Only batteries of the same or equivalent type as installation. This equipment generates, uses and can radiate
recommended are to be used. , radio trequenw energy and. it notinstalled and used in
. The supply terminals are not to be short-circuited. accordance With the instruction, may cause harmful
~ Non-rechargeable batteries are not to be recharged. ' . interference to radio communications. However, these is no
~ Rechargeable batteries are only to be charged under adult guarantee that interference will not occur in a particular
supervision. , ' installation. if this equipment does cause harmful interference
- When not ‘in use tor an extended time, remove batteries to to radio or teIeVisicn reception, which can be determined by
prevent possible leakage. , ~ turning the equipment oft and on, the user is encourage to try
-~ Batteries are lobe inserted with the correct polarity. . , to correct the interterence by one or more of the following
‘ Exhausted batteries are to be removed from the toy. . ’ measures: , ., ‘ . " '
A Batteries should be replaced by adult. . ~ Fieorient or relocate the receiving antenna.
' , - Increase the separation between the equipment and
. . . — . , ~ receiver. , . ~
I Mentosgéfiy (1-H INTERFERENCE OF SURROUNDING , , . - Connectthe equipment into an outlet on a circuit dilterent
ELECTRONIC EQUIPMENT MAY AFFECT OPERATING ' ‘ 'erm that to which the receiver is connected, ‘
.. ‘ - Consult the dealer or an experienced rediofTV technician
FERFOHMANCE, , for help , 7
This devrce complies with Fan 15 ofthc FCC Rules Operation is subject to the
Following two conditions‘ (1) This device may not cause Itam'ifitl interference;
CAUTION: ' ~ ~ .
- Do not use rechargeable batteriestor the Remote Control. ~ i
Handset and/or the External Charger..,~ .
~ Not suitable iorchildren unders years, , , , l interference that may cause undsired operation
~ May contain small parts.
‘ and (1) This device must accept any interference received, including
For 27 MHZ
Waming: Changes or modifications to this unit not expressly approved by the pany Field Strength . 54.1 dBuV/m at 3 m
responsible for compliance could void the usei‘s authority to operate the equipment.
For 49 MHz
PLEASE KEEP THIS INSTRUCTlON SHEET SlNCE IT CONTAINS lMPOFITANT lNFOFIMATlON. Field Strength 71 l dBixV/m 6&3 m
Printed in China

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2003:07:08 10:24:55
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : 
Modify Date                     : 2003:07:08 15:42:05+08:00
Page Count                      : 2
EXIF Metadata provided by EXIF.tools
FCC ID Filing: OTARC24060T27

Navigation menu