Jakks Pacific RC74123R49 SHADOW HAWK User Manual XPVback page
Jakks Pacific (HK) Ltd. SHADOW HAWK XPVback page
Contents
- 1. USERS MANUAL 1
- 2. USERS MANUAL 2
USERS MANUAL 2
IIIIIIN- EIIIIIIIIIIY OPERATED FIODUII NaI refammendedi art hildfen under 8 years of (age. As with aI electric products, pretauiians shauid be observed urlng handing and use Ia reduce the risk of elefiiit shack, IfansIaImer Electric Rating Output : 6V DC iSOOmA Iapat : i20V AC 60 Hz 24W WARNING: ADULT SUPERVISION REQUIRED. SEE SAFETY INSTRUCTIONS BELOW. QUICKTIPS ANDTROUBLESHOOTING 1 Check area for possible radio interference Large buildings, electrical wires, CB radios, and/or other RfC vehicles may cause radio interference and affect flight of va® 2 0 SHADOW HAWK“ vehicle. Avoid these ObyBCIS for maximum performance. . TAPE on the vehicle is for added structural strength DO NOT REMOVE . Check weather conditions. va® 2.0 SHADOW HAWK“ vehicle performs best on mild. sunny days with little or no breeze. ll raining, snowing, excessively wrndy, ortemperature is below 32°Ff0°C or above f22°Ff50°C, va® 2 0 SHADOW HAWKw vehicle wIiI not perform properly. Check flying area for large obstacles causing aircurrents such as buildings and trees Relocate as necessary Check batteries lf xPV<°> 2.0 SHADOW HAWKw vehicle exhibits diminished or erratic performance, replace controller batteries or recharge xPV® Battery Pack as necessary Check that xPW 2.0 SHADOW HAWK” controller antenna is extended and affixed upward Check that xpvfi 2 0 SHADOW HAWK'M vehicle antenna is positioned straight and behind tail wing . Check that va® 2.0 SHADOW HAWK” vehicle is able to fly straight and level, and if not, it may require weight decals for balance 9 Check xPV® 2 o SHADOW HAWRW vehicle for debris, din, or water damage, and clean as necessary wrth dry cloth to After a hard landing, the ON/OFF swrtch may swrtch to the OFF position. Just swrtch back ON to start again. if vaa vehicle comes in 2 frequencies- 27 MHz and 49 MHz Make certain that only one wa 2 0 SHADOW HAWKw vehicle at a time with the same radio frequency is powered “ON". Do not operate while otherxPV® 2.0 SHADOW HAWKw vehicles with the same radio frequency are in operation nearby CARING FOR YOUR XPVE 2.0 SHADOW HAWKW' VEHICLE NOTE va® 2.0 SHADOW HAWKW includes a First Aid Vehicle replair Kll (includes tape strips and suppon rods for repairst. Please see instruction in the First Aid Vehicle replair Kll for additional tips and repair materials . Before becoming an expen pilot some mishaps in flying and landing may cause some damage to the body ofthe va® 2.0 SHADOW HAWKw vehicle It is recommended that the user should attempt small flights to adyust to the feel ofthe controller before flying the xPV® 2 o SHADOW HAWK'M vehicle beyond ones abilities . using clear tape on any cracks or rips on the vafi' 2.0 SHADOW HAWK“ vehicle body should allow for extended use Common Clear tape or cello tape works great . Don't use more than needed The added weight wrll affect performance. I_I PEI FIRST All! (omrtrorr kcutehoiu cursors-arm tieif upe IMPORTANT SAFETY INSTRUCTIONS AND WARNINGS WARNINC: ONLv ADULTS SHOULD INSTALL OR CHANGE BATTERIES! WARNINC: READ BEFORE INSTALLING on USING BATTERIES! Failure to read and follow these instructions may result in fire, chemical burns, personal injury and/or property damage if batteries are improperly charged or used. ALKALINE BATTERY ADDITIONAL SAFETY INFORMATION Replace all batteries at the same time once exhausted. NEVER mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries. NEVER mix old and new batteries. NEVER mix different brands of batteries. NEVER use rechargeable batteries, as product performance may be diminished. For longer file, only use alkaline batteries LITHIUM-ION POLYMER (LIPO) BATTERY PACK SAFETY INFORMATION WARNING! Battery Pack contains potentially volatile Lithium-ion Polymer batteries! WARNING! ONLv ADULTS SHOULD CHARGE BATTERY PACKAFTER READING ALL INSTRUCTIONS ANDWARNINGS. The user assumes all risks associated wrth use and charging of Lithiumrlcn Polymer batteries. If you do not agree with these conditions, return the Eanew Pack and Charger prior to use Technical Specifications Type: Lithium-ion Poiymer (LlPo or Ll-PCIy) Capacity 650 mAh Voltage 7.4V (two ceiISI Charge time so minutes a approximately 90% charged; 00 minutes a roar/s charged. Warnings and Cautions WARNING Handle Battery Pack and Battery Charger with extreme carei Only charge Battery Pack with the compatible Battery Charger from Battery Pack Manufactureri NEVER cut or remove Baflery Pack WileSI NEVER disassemble, modify, or solder Battery PackI NEVER leave Battery Pack unattended at any time while being chargedl NEVER handle Battery Pack while wearing metalilc Objects Such as a rlrfg, watch, or braceiefl NEVER alIOw Battery Pack Internal electrolyte Contents (0 geI Irl eyes 01 Skin! NEVER immerse Battery Pack in water, seawater or other liquids. NEVER handle Or recharge Battery Pack Until it has COOIEd to surrounding temperature NEVER charge Battery Pack on or near combustible materials including paper, plastic. wood, carpet, vinyl, leather, wood, or automobiles. NEVER overcharge Battery Pack. NEVER leave Battery Pack near heat source such as fire or oven NEVER Connect Battery Pack to art electricai DutieI NEVER use or recharge Battery Pack if it appears damaged. cracked, becomes discolored or deformed, gives off an odor, or Othertfvlse appears abnormal. NEVER strike or throw Battery Pack against a hard surface NEVER puncture Dr CuI Bzflery Pack Storage and Transportation ALWAVS store Battery Pack Ir! a secure, dry, ventilated location ALWAYS store Battery Pack where it cannot be handled by children. NEVER allow Battery Pack to come into contact wrth water or other liquid NEVER leave Battery Pack near flames, stoves, fireplaces, or other high-temperature locations NEVER expose Battery Pack to direct sunlight for extended periods NEVER transport or store Banew Pack where it can come into contact wrth metal objects Recommended Temperature Ranges for Battery Storage. 40°F /4°C and 30°F f 27°C Charging: 50°F / 10°C to Ifa°F / 45°C. Usage- Recommended temperature range during use- 32°F f 0°C to t22°F / 50°C Transporting in a vehicle 20°F/ 77°C and 150“FISS°C. Charging and/or operating of Battery Pack outside of its specified range can reduce banew performance and cause the battery to leak, overheat, or explode Battery Pack Disposal Battery Pack should be properly disposed of or recycled according to local, state, and federal regulations and only after being cooled to surrounding temperatures To dispose or recycle, insulate the output wrres wrth tape, puncture a plastic garbage bag, insert Battery Pack into the garbage bag, immerse garbage bag containing Battery Pack into salt water for several hours, and dispose or recycle accordingly Wear rubber gloves during procedure. JAKKS Pacific, Inc. is not responsible in any way for any bo ' y injury(s) and/or property damage that may occur from any contrary use in any way of Battery Pack and/or Battery Charger offered and/or distributed by JAKKS Pacific, Inc. AvotD CONTACT thH BATTERV CHEMICALS. lf user comes in contact with any battery‘s internal chemicals, take the followrng recommended safety actions and SEEK IMMEDIATE MEDICAL ATTENTION: ~ Eye Rinse eyes with clean running water for at least I5 minutes ~ Skin: Wash thoroughly for at least 15 minutes. - Ingestion“ Drink fluids to induce vomiting - Clothing Remove contaminated shoes and clothing SAFETY INFORMATION FOR ALL BATTERIES ALWAVS insert batteries into the correct polarity positions (4 to +) NEVER reverse the positive H) and negative (-J terminals ALWAYS safely dispose of batteries NEVER dispose of the batteries in fire or heat, as they may explode or leak. NEVER ShDrIrclrcuII batteries by directly connecting the positive (+) and negative (7) terminal wrth metal obrects such as wrre Or tools NEVER leave batteries in device for long periods (a week or more) of non-use, as this may negatively affect future performance NEVER charge non-rechargeable batteries ADDITIONAL INFORMATION FOR ALL BATTERY PRODUCTS This device complies wrth Pan is of the FCC Rules Operation is subtecl to the followrng two conditions- It This devrce may not cause harmful interference 2) This device must accept any interference received, including interference that may cause undesired operation Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part is of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates. uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions. may cause harmful interference to radio communications However. there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or televrsicn reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the followrng measures: » Reorient or relocate the receivrng antenna. » Increase the separation between the equipment and receiver » Connect the equipmenl into an outlet on a circuit different from that to which the receiver is needed » Consult the dealer or an experienced radio/TV technician for help wt a mom tAltlts Pacific Inc., fflalihu, CA 90155 u.s.A.AII rights reserved. All other rymttols, milk), Ingm Ind dulgm(Cnilectlveiy"1rxd=mlrkx")Ire muefrtlm of Ind proprietary totheir retpectivc runner: arid used under licence by tAfttcs PICiIlC, Iric MADE IN clflffA content: may vary in co/Ie. color. shape and necnmtnn from imaged shnwn on package or in advertising. oueattons or comments? ww.lzkkspa:mf:.corfl, concumercttrakkstret, or t-m-m-zm in North America. Visit www.XPI/. cam for additional information, instructions, and cool video!
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No XMP Toolkit : 3.1.1-111 Format : application/pdf Title : XPVback_page Creator Tool : Adobe Illustrator CS2 Create Date : 2007:06:07 18:58:52+08:00 Modify Date : 2007:06:07 18:58:52+08:00 Metadata Date : 2007:06:07 18:58:52+08:00 Thumbnail Width : 256 Thumbnail Height : 136 Thumbnail Format : JPEG Thumbnail Image : (Binary data 13533 bytes, use -b option to extract) Document ID : uuid:6117ABD2E514DC119BA194ED76788C46 Instance ID : uuid:689555bf-0aef-4ffd-91bd-6b6de63602a0 Derived From Instance ID : uuid:6017ABD2E514DC119BA194ED76788C46 Derived From Document ID : uuid:5F17ABD2E514DC119BA194ED76788C46 Producer : Adobe PDF library 7.77 Page Count : 1 Creator : Adobe Illustrator CS2EXIF Metadata provided by EXIF.tools