Japan Radio NKE2254 Marine Radar User Manual
Japan Radio Co Ltd. Marine Radar Users Manual
a href="https://usermanual.wiki/Japan-Radio" itemprop="url">
Japan Radio >
Contents
- 1. Users Manual 1
- 2. Users Manual 2
- 3. Users Manual 3
- 4. Users Manual 4
- 5. Users Manual
Users Manual 3
![4 4.1 Use of Navigation Tools yyyyTo change parallel index line intervals Procedures 1 Put the cursor on near the end of line, and press the [ENT] key. When the cursor is moved there, it will turn into " " and PI will be displayed at the upper right of the cursor. The parallel index lines become operable when the [ENT] key is pressed. 2 Move the cursor to the interval to be set. The parallel index lines interval will change as the cursor moves. If Individual is selected for Operation Mode, the parallel index lines move. 3 Press the [ENT] key. The parallel index lines will be fixed. To change the end points of parallel index lines If Individual is selected for Operation Mode, the length of parallel index lines can be changed. Procedures 1 Put the cursor on the end point of parallel index lines, and press the [ENT] key. When the cursor is moved there, it will turn into " " and PI will be displayed at the upper right of the cursor. The parallel index lines become operable when the [ENT] key is pressed. 2 Move the cursor to the position to be set. The position of the end point will change as the cursor moves. 3 Press the [ENT] key. The parallel index lines will be fixed. 4-16](https://usermanual.wiki/Japan-Radio/NKE2254.Users-Manual-3/User-Guide-993476-Page-1.png)
![4.2 MEASUREMENT OF RANGE AND BEARING 4.2.1 Measurement with Cursor Position (Cursor) Procedures 1 Make sure of the target echoes on the radar display. 2 Move the cursor to the target. The bearing and range of the target will be shown in the Cursor bearing / range (upper right of the display on page 2-3). The range is a distance from the own ship's position. To set a cursor bearing numeric value mode Determine whether to display a cursor bearing in true or relative bearing mode. Procedures 1 Put the cursor on the Cursor bearing numeric value indication true / relative switching (upper right of the display ④ on page 2-19), and press the [ENT] key. The selected mode is switched as shown below each time the [ENT] key is pressed. T ⇒ R ⇒ T T :Cursor bearing is displayed in true bearing mode. R :Cursor bearing is displayed in relative bearing mode. 4-17](https://usermanual.wiki/Japan-Radio/NKE2254.Users-Manual-3/User-Guide-993476-Page-2.png)