Jasco 45146 Remote keypad User Manual KP J01 ui

Jasco Products Company Remote keypad KP J01 ui

User manual

Download: Jasco 45146 Remote keypad User Manual KP J01 ui
Mirror Download [FCC.gov]Jasco 45146 Remote keypad User Manual KP J01 ui
Document ID1241776
Application ID9bZbi+jzzqWJ+Of/kPoOog==
Document DescriptionUser manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize1.62kB (20288 bits)
Date Submitted2010-02-15 00:00:00
Date Available2010-02-25 00:00:00
Creation Date2010-01-27 17:59:27
Producing SoftwareAcrobat Distiller 7.0.5 (Windows)
Document Lastmod2010-01-28 09:31:49
Document TitleMicrosoft Word - KP-J01_ui.doc
Document CreatorAcrobat PDFMaker 7.0.7 for Word
Document Author: Joe Ng

Keypad Transmitter Model : 45146
1. INTRODUCTION
The transmitter allows you to operate the receiver. It is a wall mount type transmitter to
allow to access easily.
2. LEARN TRANSMITTER TO THE CONTROL PANEL
In order for the transmitter to communicate with the control panel properly, the
transmitter must be programmed to the control panel. Follow the brief instructions below
or refer to the detail instructions from the User’s Instructions to program the transmitter
to the control panel.
To program the transmitter to control panel:
1. Slide the mode switch to ‘ON” position in the control panel.
2. Press and hold the ‘Learn’ button in the control panel. The ‘ON’ LED will begin to
flash and it will continuous beeps.
3. Enter the password [1 2 3 4] on the transmitter.
4. If a connection has been made, you will hear a long tone from the control panel and
the ‘ON’ LED will stop flashing.
3. OPERATION
Enter the password [1 2 3 4], this will activate the “learned” control panel. Or press the
PANIC button on the transmitter to activate the “learn” control panel.
4. BATTERY
The remote control operates on a 3-volt lithium battery that is installed at the factory.
These batteries do not need to be replaced if used under normal condition. There are no
servicing parts inside the unit, please do not attempt to open the case. Warranty void if
case is opened.
Recommendation: Test your transmitter periodically to ensure that all the batteries are
working.
5. WARRANTY
If, within one year from date of purchase, this product should become defective (except
battery), due to faulty workmanship or materials, it will be repaired or replaced, without
charge. Proof of purchase is required.
6. FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired
operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
7. CUSTOMER SERVICE
If you would like to order Skylink’s products or have difficulty getting them to work,
please :
1. visit our FAQ section at www.skylinkhome.com, or
2. email us at support@skylinkhome.com, or
3. call our toll free at 1-800-304-1187 from Monday to Friday, 9am to 5pm EST. Fax
(800) 286-1320.
SKYLINK TECHNOLOGIES INC.,
17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3
Email: support@skylinkhome.com
Website: http://www.skylinkhome.com
© 2010 Skylink Group

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Page Count                      : 2
Page Layout                     : OneColumn
XMP Toolkit                     : XMP toolkit 2.9.1-13, framework 1.6
About                           : uuid:7d707a5a-7004-484f-b214-be49acc4ddf5
Producer                        : Acrobat Distiller 7.0.5 (Windows)
Source Modified                 : D:20100127095910
Headline                        : 
Creator Tool                    : Acrobat PDFMaker 7.0.7 for Word
Modify Date                     : 2010:01:28 09:31:49+08:00
Create Date                     : 2010:01:27 17:59:27+08:00
Metadata Date                   : 2010:01:28 09:31:49+08:00
Document ID                     : uuid:403ccd43-0e08-496c-974e-1628142e834d
Instance ID                     : uuid:afd9b933-6879-4558-9caa-5a3aeea36aae
Version ID                      : 8
Format                          : application/pdf
Title                           : Microsoft Word - KP-J01_ui.doc
Creator                         : Joe Ng
Subject                         : 
Tagged PDF                      : Yes
Author                          : Joe Ng
EXIF Metadata provided by EXIF.tools
FCC ID Filing: QOB45146

Navigation menu