JiangSu HuiTong Group JSHT-2K14-RC RF Control Transmitter User Manual 15 YKF355 UserMan

JiangSu HuiTong Group Co.,Ltd RF Control Transmitter 15 YKF355 UserMan

15_YKF355 UserMan

RF Control Transmitter
RF
Control
Transmitter
User Manual
YKF355-005
Remote control key introduction
Appearance
Key introduction on TV side Note1:
The Rew key transmits 2 different
IR commands de
p
endin
g
on the
pg
duration of the key press.
If the REW key is pressed:
- For less than 1.0s (short key
p
ress
),
u
p
on ke
y
release
,
the RC
p),p y ,
transmits the Rew command;
- For longer than 1.0s (long key
press), the RC transmits the Previous
command. Durin
g
the first 1.0s of
g
key-press, no code is transmitted. At
1.1s of the key being pressed, the RC
starts to transmit the Previous
command until the ke
y
is released.
y
Note 2:
The FFWD key transmits 2 different
IR commands depending on the duration
of the key press
of
the
key
press
.
If the FFWD key is pressed:
- For less than 1.0s (short key press),
upon key release, the RC transmits the
FFWD
command;
FFWD
command;
- For longer than 1.0s (long key press),
the RC transmits the Next command.
During the first 1.0s of key-press, no code
.
.
pressed, the RC starts to transmit the
Next command until the key is released.
Key introduction on TV side (1)(2)(3)
Voice
The remote control also have voice function:
() f ?
microphone
(
1
)
How to launch the voice
f
unction
?
You may press "Voice" to start the voice.
(2) How to shut down the voice function?
()Y k ( tth i k )
(
a
)
Y
ou may press any
k
ey
(
excep
t
th
e vo
i
ce
k
ey
)
to stop the voice function;
(b) Shake the remote can also stop the voice
function. start button
(3) When you using the voice function ,please make
sure that the TV side shouid be facing up.
(4) Th di t b t th i h d
(4)
Th
e
di
s
t
ance
b
e
t
ween
th
e m
i
crop
h
one an
d
your
mouth should be 20-50cm.
(5) Press the voice key once ,can only use the
ftifbt11bt th ik
f
unc
ti
on
f
or a
b
ou
t
11
s,
b
u
t
you may press
th
e vo
i
ce
k
ey
again(within the 11s) to get another 11s for voice
function.
(6) Wh i i f ti th i t ill
(6)
Wh
en you are us
i
ng vo
i
ce
f
unc
ti
on,
th
e po
i
n
t
er w
ill
be useless.
This device complies Part 15 of the FCC RF
Rules.
Operation is subject to the following two
—Reorient or relocate the receiving antenna.
—Increase the separation between the
Operation
is
subject
to
the
following
two
conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
equipment and receiver.
—Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
(2)
this
device
must
accept
any
interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to
Consult the dealer or an experienced
radio/TV technician for help.
FCC Radiation Exposure Statement This
This
equipment
has
been
tested
and
found
to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
device complies with FCC radiation exposure
limits set forth for an uncontrolled environment
and it also complies with Part 15 of the FCC RF
Rules. This equipment must not be co-located
against
harmful
interference
in
a
residential
installation. This equipment generates uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions may cause harmful interference to
or operating in conjunction with any other
antenna or transmitter.
Caution!
instructions
,
may
cause
harmful
interference
to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
Caution!
Any changes or modifications not expressly
approved by the party responsible for
compliance could void the user's authority to
operate the equipment
cause
harmful
interference
to
radio
or
television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
operate
the
equipment
.
the
following
measures:

Navigation menu