Jingwah Information Technology W105 Tablet PC User Manual
Shenzhen Jingwah Information Technology Co., Ltd. Tablet PC
User manual
USER MANUAL P1000 Preface Thank you for buying this MID. Please read and retain all the operating instructions before operating the unit. 1. Avoid the unit being dropped. Avoid the display been shake seriously, or the display will be damaged or unusual. 2. Do not use metal object to touch the device to prevent it from short circuit. 3. Please backup your data in case your important data is lost, especially before you upgrade the firmware. 4. Do not disassemble. Do not wipe the surface of the unit by alcohol, thinner or benzene. 5. Do not disconnect the unit while it is formatting or uploading/downloading, or the procedures may lead to errors. 6. Avoid water or foreign objects enter the unit. 7. Do not use the unit in places that are extremely hot, cold, dusty, or humid. 8. Specifications are subject to change and improvement without notice. II.Introduction of cover0 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Loudspeaker Front Camera Power on/off Volume +,Volume Micro USB interface Earphone Jack TF-CARD interface Mic HDMI interface Back Camera Reset II. Operation Instruction 1. Basic Operation 1.1. Power on/Power off Power on Press and hold the power switch for 5 seconds; the unit displays the start-up logo and enters the working mode. Power off Press and hold the power switch for 5 seconds to turn the unit off. Sleep While the device is at working status, press the power switch, it enters the sleeping mode, and the screen will be off then. Press the power switch again, it shift to the normal mode. You may use this function when you don’t’ use the device temporary to save power. 1.2. Charging When the device prompts low battery, please charge it by provided charger. Note: To improve the longevity of the battery, you may charge for another 15 minutes after it prompts the battery is full. 1.3. Main menu icon in the main interface, the main menu is Click the appeared. It including the system setting, music playback, video playback, web browser and other applications you installed in the main menu. 2. Settings Click “Settings” in the main interface to enter the setting interface. Click the corresponding setting items to operate. 2.1ˊDate and Time Setting Click “Date & time” in the setting interface to set the date and time. You may set the date, time zone, time, time format and date format etc. in the menu. 2.2. Brightness Select “Display” in the setting interface. Click “Brightness” to enter, and slide the bar to adjust the brightness. 2.3. Screen Timeout Adjust the delay before the screen automatically turns off. Select “Display” in the setting interface. Click “Sleep” to enter, and click the time you want. Note: The setting of screen timeout is unavailable while playing video. 3. Wi-Fi connection Click “Settings” in the main interface.Click Wi-Fi to turn on the WIFI, it lists the open network it searched. Click the name of the network; it pops up the setting window. You may connect it to WIFI according to the prompts. You need to input the user name and password if networks are encrypted. 3.1 Bluetooth Turn on the BluetoothˈClick Bluetooth setting to set and manage Blutooth Devices access.Click “SEARCH FOR DEVICES”,it lists the open devices.Click the name of the devices;it pops up the setting window.choose the device ,pairing it,then you can transfer pictures,movies,music etc with it. 4. Install, Uninstall and Run applications 4.1 Install There are many ways to install applications under Android. We introduce installation by Market here. Select the APK file you want and enter the application installation interface. Click “Install” to install the application automatically. After installation, it prompts “Open” and “Finish”. Click “Open” to open the application. Click “Finish” to exit. 4.2 Uninstall You may use the corresponding third party software management tool or the installed application management software of the device to install applications. Select “Setting/Apps” to select the installed applications and check the attribute of it or uninstall it. 5. Connect to internet 5.1. After connecting with WIFI, open the browser and input the web address, you can browse the web then. icon to enter the bookmark to view the browse 5.2. Click the history. Click the web page you want to open it. 6. Audio and video playback 6.1. Audio playbackClick the “MUSIC” in the main menu to enter the audio playback interface. It lists the audio files in the device, and you may click the file name to play it. in the audio playing interface, click the icons to play/pause/ increase volume/ decrease volume/ FF/ REW…. 6.2. Video Playback Click the “Gallery” in the main menu to enter the video playback interface. It lists the video files in the device, and you may click the file name to play it. in the video playing interface, touch the screen to pop-up the operation icons and click the icons to play/pause/ increase volume/ decrease volume/ skip to next file/skip to previous file…. 7. Picture viewing Click “Gallery” in the main menu to enter the picture folder list. Select and click the folder you want to enter, it displays the . click the thumbnail of the picture to view it. Touch the screen to pop-up the operation icons while viewing the picture, you may zoom in/zoom out/ skip to next picture/skip to previous picture/ rotate/ delete the picture… 8. Camera Click “Camera” in the main interface. 8.1 Camera If the cursor is at Click position, the device is at Camera mode. to take picture. Click to set the scene mode, Picture size, Picture quality, and colour effect. Click to set white balance. 8.2 DV position, the device is at DV mode. If the cursor is at Click to take video. Click to set the colour effect or restore to default settings. 9. Connect with external device 9.1. Connect with PC Connect the device with the PC via the USB cable. The PC appears two new disk symbols after connected successfully. One is the TF card, and the other is the built-in flash. 9.2. Applications For convenient usage, we installed some third party software in the MID. For detailed operation methods, please check the corresponding instruction. Some of the software may be able to be used in some area because of network service. IV. Troubleshooting 1. What if the device is abnormal during operation? Answer: 1) Reboot the device to see if it works OK. 2) Charge the device by the charger to activate the battery. Make sure it has power before you operate it. 3) It is suggested to upgrade the OS of the device by professional. 2. Why the standby time is so short sometimes? Answer: the use time of the battery is all depend on the temperature and use instance. If the temperature is too high or too low, the use time of the battery might be effected. It is suggest using the device in normal temperature. The using time is also affected by increased volume and frequently operation. VI. Specifications Item Display Touch panel OS Input method Capacity P1000 1024X600 Capacitive touch screen Android 5.0 Soft keypad 4GB -32GB(Take the object as the standard) External Capacity Audio Video E-book Wireless network Language OTG Temperature Power supply Battery TF-CARD, up to 32GB MP3,WMA,FLAC,APP,OGG,etc. MPEG4,asp,divx,WMV,H.264,etc. Support Support WIFI Multi-language Support -20°C to 60ι AC 100~240V 50/60 Hz; DC 5V/2A poly-lithium battery MEANING OF THE DUSTBIN SYMBOL Protect our environment: do not dispose of electrical equipment in your domestic waste. Please return any electrical equipment that you will no longer use to the collection points provided for their disposal. These simple steps can help to avoid the potential effects that incorrect waste disposal can cause on the environment and human health. This will contribute to recycling and other forms of re-use of electrical and electronic equipment. Information concerning where the equipment can be disposed of can be obtained from your local authorities. FCC Warning Statement Changes or modifications not expressly approved by the party responsible for Changes or modifications not expressly approved by the party responsible for c compliance could void your authority to operate the equipment. ompliance could void the user’s authority to operate the equipment. This equipment been andtofound to with comply with for thealimits This equipment hashas been testedtested and found comply the limits Class for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are B digital device, pursuant to Part 15 ofprotection the FCC Rules. These limits are designe designed to provide reasonable against harmful interference in a residential installation. This equipment generates, uses and can radiate radio d to provideenergy reasonable against harmful interference in a residential frequency andprotection if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. nstallation. This equipment generates uses and can radiate radio frequency ener However, there is no guarantee that interference will not occur in a particular installation. If this equipment cause harmful interference to radio or gy and, if not installed and used in does accordance with the instructions, may cause television reception, which can be determined by turning the equipment off and harmful interference to radio communications. there is nobyguarantee on, the user is encouraged to try correct However, the interference one or more of the following measures: interference will not occur in a particular installation. If this equipment does -hat Reorient the receiving antenna. - cause Increase theinterference separationtobetween the equipment receiver. harmful radio or television reception,and which can be deter - Connect the equipment into and outlet on a circuit different from that to which the receiver is connected. mined by turning the equipment off and on, the user is encouraged to try to corr - Consult the dealer or an experienced radio/TV technician for help. ect the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. MADE IN CHINA
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : Yes Author : Administrator Create Date : 2015:09:25 11:13:29+08:00 Modify Date : 2015:09:25 11:13:29+08:00 XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00 Producer : Acrobat Distiller 9.0.0 (Windows) Creator Tool : PScript5.dll Version 5.2 Format : application/pdf Title : Microsoft Word - W105G EN manual 带HDMI MTK8127 ANDROID5.0.doc Creator : Administrator Document ID : uuid:8545449f-9ded-4115-b474-be41160a2cd0 Instance ID : uuid:0cc2c354-6f6a-4d9b-a8dd-eeb2da66b8bd Page Count : 8EXIF Metadata provided by EXIF.tools