Joysway Hobby JH80002 Radio control speed boat User Manual

Download:
Mirror Download [FCC.gov]
Document ID	1457177
Application ID	FPxX9+ZXoRozjZxKFMNE1w==
Document Description	Users manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	131.9kB (1648790 bits)
Date Submitted	2011-04-29 00:00:00
Date Available	2011-04-29 00:00:00
Creation Date	2011-04-28 15:52:57
Producing Software	Acrobat Distiller 7.0.5 (Windows)
Document Lastmod	2011-04-28 16:10:16
Document Title	Users Manual
Document Creator	PScript5.dll Version 5.2.2
Document Author:	vivian

INSTRUCTION MANUAL
THESE INSTRUCTIONS SHOULD BE READ BY A SUPERVISING ADULT
OFFSHORE LITE WARRIOR 2.4GHz RTR
ITEM NO. 8206
(CONTENTS OF SET
”Offshore Lite Warrior Racing Boat 5) Boat Stand
2) Transmitter 5) 9V Dry battery (for Transmitter)
3) 7.2V Power Pack 7) 2.5mm Allen Key (for Turn Fins)
4) AC Fast Charger (for Power Pack) 2.0mm Allen Key (for Grub Screws)
CROSSVHEAD SCREWDRIVER , ch
(N07 INCLUDED]
ATTENTION:
Before racing your model boat, carefully check SlIltOrle tube for guarantee good water cooling system; AVOld
water inlet on the bottom of hull become deformed, otherwise, water COOIlflg system failure, this may lead to
ESC burned out and motor defected
IMPORTANT
The Offshore the Warrlor is designed for use in fresh water only, It |s not deslgned for use |n salt water!
The Offshore L‘lte Warrior ls not |ntended for persons under 14 years of age, unless closely superwsed by an adult.
Offshore Lite Warrior RTR Mini EP Racing Boat
INSTALLING THE 9V DRY BATTERY IN YOUR TRANSMITTER
Always use a fresh 9V battery in the
transmitter.
1) Ensure transmitter’ON/OFF’switch is in the
’OFF'position.
2) Remove battery cover screw.
3) Remove battery cover by pressing down on
the embossed arrow and sliding the cover as
indicated.
4) lnsert 9V battery, noting correct location
(polarity + or -).
5) Slide battery cover back into place.
6) Re-fit battery cover screw.
NOTE 1:The Offshore Lite Warrior is supplied
with a start-up 9V dry cell battery. Once this
battery is depleted, please replace it with
another dry cell 9V battery (alkaline recommended)
orfully charged 9V rechargeable battery. Remove
9V battery from the transmitter ifyou do not intend
to use it for a period oftlme.
NOTE 2: When the transmitter battery (dry cell
or rechargeable) is at the end of its life, it should
be disposed of at an approved battery recycling
centreDO NOT DISPOSEOF IT IN HOUSEHOLD
WASTE!
CHARGING THE 7.2V POWER PACK
1) Plug the supplied charger into a mains outlet
socket.
2) Connect 7.2V Power Pack to charger as
indicated. Do not force the connectors
together — they only attach one way!
3) The 71V Power Pack wrll charge from flat
in just about 2 hours.
4) Power pack getting warm means finish
charging. Do not overcharge. Do not leave
7.2V Power Pack and charger unattended when charging.
- The 7.2V Power Pack is not supplied pre—charged and you must charge it fully before using your Offshore Lite
Warrior for the first time.
- The 7.2V Power Pack and charger will get warm whilst chargingThis is normal. Do not charge on, or near to,
a material/surface that is flammable or one that can be damaged by heat.
' The 7.2V Power Pack can be recharged many times before it needs replacing. When the 7.2V Power Pack no
longer holds a charge (is dead), it should be properly recycled.
DO NOT DISPOSE OF IT IN HOUSEHOLD WASTE!
NOTE 1: The Offshore Lite Warrior will typically run for around 8 minutes on a fully charged 7.2V Power Pack. As
soon as you notice a drop off in speed you should bring the model back to shore or control may be lost.
NOTE 2: If you want to run your Offshore Lite Warriorfor extended periods, you can purchase additional 7.2V
Power Packs. Details are given at the end ofthese Instructions. However, continuous running of the model Will
generate high heat levels,which will lead to premature wear ofthe motor.0nce your power pack is exhausted,
we recommend that you let the model cool down for 5~‘l 0 minutes before installing a fresh power pack.
2 Offshore Lite Warrior RTR Mini EP Racing Boat
INSTALLING THE 7.2V POWER PACK IN THE OFFSHORE LITE WARRIOR
(Model should be placed on its supplied
boat stand)
1) Remove the Offshore Lite Warrior's upper deck
by lossing the screw at its rear section.
2) Remove the clear plastic cover.
3) insert the my Power Pack into the left side of
the hull. The connector of power pack heads
towards the front of boat.Tie the power pack
with provided magic belt insidethe hull.
4) Attach the 72V Power Pack's connector to the
matching connector in the Offshore Lite Warrior.
Do not force them together — they only attach
one way!
5) Replace the clear plastic cover and
reposition the upper deck.
TRANSMITTER/RECEIVER BINDING
The binding process effectively ties the transmitter and receiver together, Under normal circumstances, both
items are supplied like this from the factory. If, however, you find that your transmitter and receiver are not
boundlreceiver's red LED is on), you should do the following:
1) Switch "ON" the transmitter.
2) Switch "ON" the receiver by Attaching the 7.2V power pack's connector to the matching connector in the
Offshore Lite Warrior boat.
3) Press down the "BIND" button on the receiver, the receiver's green LED will be on to indicate that binding has
been successful and the receiver Will now accept commands from the transmitter.
Note 1: During binding process, transmitter and receivershould be no more than one meterapart and no other
similar devices should be within 10 meters.
Note 2: if the green light flashing, showing the binding failure, please do again as above indication
HOW TO CONTROL/OPERATE YOUR OFFSHORE LITE WARRIOR
1) Forward Throttle Trigger
Vour Offshore Lite Warrior can be driven
forward by pulling the throttle trigger. Release
the trigger and the Offshore Lite WarriorWiII stop.
2) Left/Right Steering Wheel
The steering wheel controls the Offshore Lite
Warrior’s left and right movement. Turn the
wheel to the left to steer to the left, Turn the
wheel to the right to steer to the right. Release
the wheel to go straight.
Rating Tip; The Offshore Lite Warrior is an oval
racer, designed for clockwise racing, and will be
less responsive to steering inputs at high speed,
particularly left turns. Decrease your speed to
allow tighter turning.
3 Offshore Lite Warrior RTR Mini EP Racing Boat
TURN FINS
The Offshore Lite Warrior features adjustable turn
fins to aid in turning. These can be adjusted using
the included Allen key. The optimum angle of
adjustment is 45 degrees to the hull.
DRIVING YOUR OFFSHORE LITE WARRIOR
1) Switch ’0N’the transmitter, Check that the transmitters red LED glows brightly.
2) Check that the turn fins are adjusted correctly.
3) Switch ‘ON’the Offshore Lite Warrior (connect the 7.2V Power Pack).
4) Check that the propeller and the rudder respond to transmitter inputs before placing the Offshore Lite Warrior
on the water.
AFTER USE
1) When you have finished using your Offshore Lite Warrior, you should first switch ‘OFF' the model (disconnect
the 7.2V Power Pack), then switch 'OFF’ your transmitter.
2) Remove all batteries from the transmitterand model.
3) Leave the Offshore Lite Warrior's upper deck and clear plastic cover offto allow moisture to evaporate. Ideally,
place the model in this way in a warm and dry place, like an airing cupboard, until you are sure it is dry and
then store it away.
NOTE: Ifthe Offshore Lite Warrior begins to bob when running, it may have taken on an excessive amount of
water. In this case, you should immediately return to shore, remove the upper deck and clear plastic cover and
drain the water from the hull.
IF THE OFFSHORE LITE WARRIOR DOES NOT RUN IN A STRAIGHT LINE
lfyour Offshore Lite Warrior does not run in a
straight line when not being steered, you can adjust
it by using the steering trim located on the upper
right hand side of the transmitter.
1) Run your Offshore Lite Warrior on calm water
when adjusting the steering. Ifyour model runs
to the right when not being steered, turn the
trim control knob a little to the left, re—centre
the model and see ifthis has corrected the
problem. Keep making small adjustments in
this way until the model runs straight.
Turn the trim knob to the right to correct if
your model steers to the left without being
steered in the same way as detailed above.
2) You can also adjust the Offshore Lite Warrior's throttle response using the Throttle Trim, located under the
Steering Trim on the transmitter,
If, when you connect the 7.2V Power Pack, the Offshore Lite Warrior’s propeller starts turning without
transmitter input, you can adjust it backto neutral (stopped) by turning the Throttle Trim knob to the left.
You should adjust this trim so that the propeller starts to turn as soon as you depress the transmitter's
trigger, but the propeller stops turning immediately the trigger is released.
4 Offshore Lite Warrior RTR Mini EP Racing Boat
CAUTION!
Please observe the following warnings.
DURING OPERATION
- The transmitter's range will vary depending on your surroundings and battery strengthDo not operate
Offshore Lite Warrior too far away or control will be lost.
G Ensure that all batteries are correctly installed and that the 7.2V Power Pack is fully charged.
G Do not operate your Offshore Lite Warrior in areas with strong currents, in salt water or areas of water with
large waves.
G Do not touch moving parts during operation, especially the propeller.
G Do not let your Offshore Lite Warrior run aground,as this can cause damage.
G If you lose control of your Offshore Lite Warrior, never wade into deep water or water with strong currents to
retrieve it, First, hold the transmitter as high as you can to try to re-establish control. If this does not work,
find another way to move closer to the model, but do not endanger yourself in the process!
STORING YOUR OFFSHORE LITE WARRIOR SAFELY
G Always remove all batteries before storing your Offshore Lite Warrior.
- Never store your Offshore Lite Warrior near naked flames, in high temperatures (including radiators) or in
direct sunlight.
G Never store your Offshore Lite Warrior near water,outdoors or in the rain.
- Ideally, store your Offshore Lite Warrior and transmitter in the box in which they were supplied,
CARE WITH RECHARGEABLE BATTERIES (THE POWER PACK)
Care must be taken when handling rechargeable batteries (the Power Pack) to avoid the possibility of inyury
and/or damage to property. Do not short circuit, disassemble or incinerate rechargeable batteries. It is very
dangerous to disregard these warnings.
GENERAL INFORMATION FOR THE SAFE OPERATION OF YOUR OFFSHORE LITE WARRIOR
Please follow these simple rules to ensure safe operation and gain the maximum enjoyment from your
model.
- Avoid overloading your model. Never run it in areas where its movement Will be restricted, e,g.areas where
there is pond weed, etc.,as this can over stress the motor.
G Ensure nothing prevents the smooth running of moving parts.
- Do not run your model in confined spaces.
G Never run your model in a public space where it might upset orendanger people orwildlife.
G Immediately switch’OFF'your model and transmitter ifyou see lightning or hearthunder.
Never use your model in the rain.
Do not dismantleortamperin any way with this R/C vehicle and its transmitter.The manufacturerand distributor
will accept no responsibility, expressed or implied, for accidents or injuries caused as a result of disassembly,
modification and/or usage against the Instructions for this product.
Tampering or modification will also invalidate the guarantee.
5 Offshore Lite Warrior RTR Mini EP Racing Boat
TROUBLE SHOOTING
Check using the chart below before returning your Offshore Lite Warrior for repalr as many problems can
be easily solved.
PROBLEM REMEDY
Model will not move No battery in transmitter/model Install batteries
Battery installation is incorrect Install batteries correctly
Weak battery in transmitter Install a fresh battery
Weak batteries in model Recharge 7.2V Power Pack
No control of model Weak battery |n transmitter Install a fresh battery
Limited radio range Weak battery in transmitter Install afresh battery
SPARE PARTS
ITEM No ITEM NAME
82001 Offshore Lite Warrior Deck/Cover
82002 480 Motor w/ Water Cooling Jacket
82003 Aluminum Alloy Coupler w/3 screws
82004 Flex shaft
82005 P1 .4'D33mm/3 Propeller(Pk2)
82006 Rudder Set
82001 Stainless Steel Turn fins set
82011 7.2V1100mAh Ni-Mh Power Pack
32012 2.4GHz RX,ESC,Servo Set
FCC WARNING Changes or modlflcatlons not
c E ‘l expressly approved by the party responsible
1622 for compliance could avold the user's authority
Nl—MH to operate the equipment.
6 Offshore Lite Warrior RTR Mini EP Racing Boat

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
XMP Toolkit                     : 3.1-701
Producer                        : Acrobat Distiller 7.0.5 (Windows)
Creator Tool                    : PScript5.dll Version 5.2.2
Modify Date                     : 2011:04:28 16:10:16+08:00
Create Date                     : 2011:04:28 15:52:57+08:00
Metadata Date                   : 2011:04:28 16:10:16+08:00
Format                          : application/pdf
Title                           : <322E3447D2A3BFD8B4ACCBB5C3F7CAE92E6169>
Creator                         : vivian
Document ID                     : uuid:add32206-57a5-45da-96d8-f7913050589b
Instance ID                     : uuid:2b9de7ea-b519-4f92-9d7b-954af2b8904a
Page Count                      : 6
Author                          : vivian

EXIF Metadata provided by EXIF.tools