KAB Enterprise TR-001 Transmitter User Manual

Kab Enterprise Co., Ltd. Transmitter

user manual

MODEL TR-001 OUTDOOR REMOTE CONTROLLERFCC FCC FCC FCC ID : XXXTR-001ID : XXXTR-001ID : XXXTR-001ID : XXXTR-001FEDERAL COMMUNICATIONS COMMISSIONThis device complies with Part 15 of the FCC rules. Operation is subject to thefollowing two conditions : (1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that maycause undesired operation.NOTE This equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If thisequipment does cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user is encouraged to tryto correct the interference by one or more of the following measures :- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.- Shielded interface cables must be used in order to comply with emission limits.- Change or modifications not expressly approved by the party responsible forcompliance could void the user’s authority to operate the equipment.- Consult the dealer or an experienced radio/TV technician for help.SPECIFICATIONSFrequency --- 315MHzTransmitter Power Input --- DC 12V BatteryReceiver Power Input --- AC 125V Electrical OutletReceiver Power Output --- 15 Amps / 125 Volts / 1875 WattsINSTALLATION1. Mount the receiver on wall near grounded electrical outlet. Nail or screw head mustextend at least 3/16” out from wall. Hang the receiver from slot on back of unit ontonail or screw. Plug the power supply cord of the receiver into outlet. Then plugdevice cord into the receptacle at bottom of the receiver.2. Install battery into the transmitter.OPERATION1. Press ON button on the transmitter to turn the receiver ON.2. Press OFF button on the transmitter to turn the receiver OFF.

Navigation menu