KAONMEDIA VM1510 STB User Manual

KAONMEDIA Co., Ltd. STB

User Manual

ENG_3Front Panel Power indicator ( )The indicator light turns red when the power turns on. Remote control signal sensor ( ) Do not block IR receiver, so that you can use the remote CHChannel Up/Down (up and down key) VOL Volume Up/Down (up and down key) POWERSwitch the receiver power “ON” or “OFF”.control properly. Lock indicator ( )InstallationQUICK START GuideDIGICEL VM1510Please read this installation guide carefully before you use this product and ENG_1 2_ENGDigicel is not responsible for problems caused by misuse of equipment.   PrecautionPlace your product on a stable surface.  Do not drop or hit your product. This may cause a malfunction or injury. Do not leave your product in too high or low temperature for a long time. Doing so may cause an explosion or an electric shock. Safety information4_ENGInstallation S/PDIF HDMI Connect a digital amplifer output. Connect your decoder to an HDTV set with an HDMI cable ETHERNET Connect the LAN cable to Ethernet port. USB Connect the USB memory device to USB port DC 12V IN To connect your decoder to the main power supply. LOOP OUT Used to connect an antenna signal from the receiver to either the antenna input jack on your television or to another receiver. CVBS Video connection port to the TV or other equipment. AUDIO Audio connection port to the TV or other equipment. ANT INDC 12V Power connection Rear Panel2_ENGDigicel is not responsible for problems caused by misuse of equipment.   PrecautionPlace your product on a stable surface.  Do not drop or hit your product. This may cause a malfunction or injury. Do not leave your product in too high or low temperature for a long time. Doing so may cause an explosion or an electric shock. Safety information2 31 4 5 6 7 981 2 3 4 5 6FCC STATEMENTCaution : Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Indoor use only.3305-00550_MANUAL_DIGICEL_QUICK GUIDE_ENG_���.indd 1 2014-11-24 �� 1:29:06This appliance and its antenna must not be co-located or operation in conjunction with any other antenna or transmitter. A minimum separation distance of 20 ㎝ must be maintained between the antenna and the person for this appliance to satisfy the RF exposure requirements
ENG_5Audio systemOptical cableTVTVHDMI cableRCA cableUSB memory deviceChipsetBroadcom / BCM7584Flash Memory 4MB NOR, 512MB NANDProgram DRAM 512MB DDR3USB / IP (Automatic/manual)F/W Upgrade Wi-Fi Embedded support 2T2R (802.11a/b/g/n, 2.4/5Ghz Selectable Band)CodecVideo - MPEG-2, MPEG-4/H.264/AVC - Dual 1080i decode or 1080p60 decode- Power (On: Red)- IR Indicator (On: Yellow)- Lock Indicator (On: Green)Audio USB 2.0 HDMI 1.3 RJ45S/PDIF (Optical) CVBS, Cable in & LoopSize(W*H*D) 200mmx40mmx140mm- AC-3 (Dolby Digital), Dolby Digital Plus - MPEG-1 layers 1,2 and 3 (MP3)Front Input Connectors & LED5 Keys (CH+, CH-,Vol+, Vol -, Power) 3 LEDs Rear Output ConnectorsPhysicalSpecicationENG_6 STAND BYTo switch between operation and stand by mode.To select shortcuts in menu or tv list, info banner. OKTo conrm your choice. VOLUME UP/DOWNTo increase or decrease the volume. CHANNEL UP/DOWNTo change channel up and down. BACKPress to go on step back. PlayUsed for playing les. FFUsed for fast forward. Pre FileTo play the pre le in pvr. ASPECT Next FileTo play the next le in pvr. AUDIOTo select the sound mode. (Mono, Left, Right, Stereo) SUB-TTo enable or disable subtitle or change the channel list mode. EXITTo return the normal viewing mode from a menu. OPTTo set the video output. Switch to TP/Satellite in Search Setup. RecordSaves the current channel to the external HDD. PauseUsed for pausing les. StopUsed for stopping record or play. REWUsed for rewinding. Red button Green button Yellow button Blue button MUTETo enable or disable audio. NUMERIC BUTTONSTo select the channel and enter the channel edit and PIN code. TV PIP GUIDEActivate the program guide (EPG) in the window. MENUTo display the Main Menu on the screen or return to the previous menu. i Displays the information box in the normal viewing mode. Up/DownTo move up or down on the menu. Left/RightTo move left or right on the menu.DATE : 2014.08.29RCU301Print DATADigicel1212 13745113968152218283123192625202914162124273010171 STAND BYTo switch between operation and stand by mode.10 Up/DownTo move up or down on the menu.11 Left/RightTo move left or right on the menu.To increase or decrease the volume.12 OKTo conrm your choice.13 VOLUME UP/DOWNTo increase or decrease the volume. 14 CHANNEL UP/DOWNTo change channel up and down.15 EXITTo return the normal viewing mode from a menu. 16 BACKPress to go on step back.To select shortcuts in menu or tv list, info banner.17 OPTTo set the video output. Switch to TP/Satellite in Search Setup.18 Red button 19 Green button 20 Yellow button21 Blue button2 MUTETo enable or disable audio.3 NUMERIC BUTTONSTo select the channel and enter the channel edit and PIN code.4 TV/RADIOTo switch between TV and Radio.5 TEXTTo see the teletext by OSD.6 MEDIATo see the recorded lelist.7 GUIDEActivate the program guide (EPG) in the window.8 MENUTo display the Main Menu on the screen or return to the previous menu.9 i Displays the information box in the normal viewing mode.Using the remote controlENG_73305-00550_MANUAL_DIGICEL_QUICK GUIDE_ENG_���.indd 2 2014-11-24 �� 1:29:08

Navigation menu