KIDZTECH TOYS 89051-27MTX 1/26 R/C Cars User Manual 1 26 IM

RC Vehicle (Vehicle) x 1

RC Transmitter (Transmitter) x 1

Antenna for RC Transmitter x 1

Instruction Manual x 1

Battery Precaution

1. Alkaline batteries are recommended to be used

2. Only batteries of the same or equivalent type as recommended are to be used

3. Do not mix alkaline, standard or rechargeable batteries

10. Exhausted batteries are to be removed from the product

11. The supply terminals are not to be short-circuited

12. Dispose of batteries properly. Do not dispose the batteries in fire – it may cause them to explode or leak causing injury or damage

13. Battery installation and removal must only be done by adult

How to Play

1. Switch ON the Vehicle

2. Use the Forward / Backward joystick (Fig.3) to drive the Vehicle forward and backward

3. Use the Left / Right joystick (Fig.3) to control the Vehicle turning left or right

4. If the vehicle does not run in straight line, adjust the wheel alignment lever on the vehicle chassis (Fig. 1)

5. Play on smooth surface to have the optimum performance

4. Switch OFF the power when not in use to prevent damage of Vehicle and Transmitter due to leakage of electrolyte from batteries

5. Remove all batteries from the Vehicle and Transmitter when not in use for long period

6. Keep fingers, hair and loose clothing away from wheels

7. The operating range can be affected by a variety of factors

a) Low Voltage of batteries in Transmitter or Vehicle

b) Interference from other items that emit radio frequency signals

8. Outdoor usage is recommended in order to get optimum control range

9. Recommend to play the vehicle on a clean and smooth surface

10. Clean the battery compartment to make sure it is free from dust to prevent poor contact of batteries

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to

comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna

- Increase the separation between the equipment and receiver

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

The product is in conformity with the requirement of EU Directive 1999/5/EC

Environmental notes:

The whole product also does not belong to household waste at the end of the product life.

You can return it at collection points for the recycling of electronic and electronical instruments

The symbol on the item, instruction manual, hangtag or packing is showing this clearly.

Materials should be recycled according to their respective markings.

Recycling of old devices or other re-use of materials contained therein represents an important contribution to environmental protection.

Please ask at your local community for the correct collection point.

Please retain this sheet and address for future use, as they contain important information.

Disposal of batteries

3 x AA

For Vehicle

( Not Included )

1 x 9V

For Transmitter

( Not Included )

Battery Requirement

1. Vehicle: 3 x 1.5V ”AA” batteries

2. Transmitter: 1 x 9V battery

1. Switch OFF the power

2. Unscrew the screw on the battery cover

3. Open the battery cover

4. Install 1 new 9V battery with correct polarity (+/-) as shown inside the battery

compartment

5. Close the battery cover

2. Unscrew the screw on the battery cover

3. Open the battery cover

4. Install 3 new 1.5V “AA” batteries with correct polarities (+/-)

as shown inside the battery compartment

5. Close the battery cover

6. Tighten the screw on the battery cover