KINGSTAR VCB60015BT Wireless Speaker User Manual SP 0551 IM Release
Shenzhen Kingstar Industrial Co., Ltd. Wireless Speaker SP 0551 IM Release
KINGSTAR >
User Manual
enter the alarm setting mode,then press the button one time,the number will change.
40
Vivitar VCB60015BT
1. Long press the switch key, the product is turned on.
2. The middle button is to adjust the time, consecutive press 2 times,
enter the clock adjustment mode, then press the button one time,the number will change.
Consecutive press twice, enter the minute adjustment mode, then press the button
one time,the number will change.
3. The button on the right is used to set the alarm clock. Consecutive press 2 times,
Set the alarm that you want.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which
can be determined by turning the equipment off and on, the user is
encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party
responsible for compliance
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may
cause undesired operation.