KYE SYSTEMS GMZL7 Traveler 9000 (GM-100017-V2) User Manual 01 TRA 9000 ENG R B
KYE Systems Corp Traveler 9000 (GM-100017-V2) 01 TRA 9000 ENG R B
Users Manual
Traveler 9000 (GM-100017-V2)English
1
Hardware Installation
1. You can connect the receiver to a USB port of a PC.
2. Install one AAA battery in the mouse.
3. Make sure that you have switched on the power switch underneath the
mouse.
4. This product has two storage locations, inside the slot just one storage
location.
Factory Settings
1. Left Button: Provides traditional mouse functions like click, double click
and drag.
2. Magic-Roller: Press the “Magic-Roller” to surf the Internet and Windows
documents.
3. Right Button: Provides traditional mouse click functions.
Warning: (Troubleshooting)
1. Do not use the wireless optical/laser mouse on a desk which is made of
glass or mirror.
2. The connection of the wireless device is factory preset, so when you plug
the USB receiver into any USB port, the connection between the micro
receiver and the mouse will be established automatically.
3. In case your PC did not install the hardware successfully, remove the micro
receiver from the USB port and go Human Interface Devices under
Device Manager to remove the mouse then plug in the micro receiver to a
USB port again.
4. If you feel the mouse does not move smooth as usual, it is possible the
batteries have lost their charge so you need to replace them. Remember to
put the batteries in the correct direction.
Traveler 9000 (GM-100017-V2)English
2
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, according to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try correct the interference by one or more of the following measures:
1. Reorient the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into and outlet on a circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the instruction
manual.
CAUSION: Any changes or modifications not expressly approved by the party responsible
for compliance could void your authority to operate the equipment.