Kaba Simplex 7000/7100 Changing The Code KAA1158 7000 7100

User Manual: Kaba Simplex 7000/7100 Changing the Code - KAA1158 Simplex 7100 Mechanical Lock - Kaba Access & Data Systems

Open the PDF directly: View PDF .
Page Count: 2

Changing the Code/Combination

Simplex 7000/7100

7000/7100 Series FAQ

Changing the Code/Combination

Note: If your lock is opening on every turn of the knob or lever, except upon entering a code, this may

be a ZERO CODE. Before attempting to remove the lock from the door, refer to the troubleshooting

procedures outlined at bottom of this document for a zero code symptom/solution.

Important: The following steps must be performed while the door is be

open.

The factory pre-set combination is 2 and 4 pressed simultaneously and re-

leased, then press 3 and release.

Read the instructions through once before attempting to change

the combination.

1. Turn the outside thumbturn to the left (counterclockwise) until it stops

then return it to the right (clockwise) slowly to the horizontal position

and release.

2. Enter the existing combination.

3. Insert a Phillips-head screwdriver into the central piece of the combina-

tion change assembly (see gure 1). Gently turn the screwdriver to the

right (clockwise) until it stops. A slight click should be felt. Do not force.

4. Remove the screwdriver from the combination change assembly.

Important: When removing the screwdriver, the central piece must return to its

initial position, if not, set it back to its original position using the screwdriver

(see Figure 1). If the central piece of the combination change assembly does not

return to its original position, the combination will be cancelled and the lock will

jam.

5. Turn the outside thumbturn to the left (counterclockwise) until it stops

and return it slowly to the right (clockwise) to the horizontal position

and release.

This clears the existing code (see gure 2).

6. Select a new combination and write it down. Some or all of the buttons

may be used for your new code, pressed individually or simultaneously.

Each button may be used only once. We do not recommend the use of a

one-button combination.

KAA1158 0108

7. With the door open, enter your new combination. Depress each button fully and release

it. You must feel a click each time you press a button to know that the button was

fully depressed.

8. Turn the outside thumbturn to the right (clockwise) until it stops; the latch/bolt

should retract.

9. For automatic relocking latches, release the outside thumbturn and the latch should return

to its initial extended position.

For manual relocking deadbolts, turn the outside thumbturn to the left (counterclockwise)

until it stops; the bolt should extend.

Keep the door open and test the operation of the lock 2–3 times to make sure your combination was

set correctly.

Note:

• Donotuseexcessiveforceatanytime.

• Ifawrongcombinationisenteredwhileoperatingthelock,turntheoutsidethumbturntothe

left (counterclockwise) to the top position and release (see Figure 2). This will clear any

previously depressed buttons. Enter in the correct combination.

Troubleshooting

Symptom/problem: Turning outside thumbturn clockwise always retracts latch without depressing

any buttons.

Cause: Lock is in zero combination.

Solution: Follow the procedure for setting a new combination except omit step 2.