Kaba Simplex EE1000 Changing The Code KAA1162

User Manual: Kaba Simplex EE1000 Changing the Code - KAA1162 Simplex EE1000 Mechanical Lock- Kaba Access & Data Systems

Open the PDF directly: View PDF .
Page Count: 2

Changing the Code/Combination

Simplex EE1000

EE1000 Series FAQ

Changing the Code/Combination

The door must be open.

The combination for the outside and inside locks must be changed indepen-

dently. Follow the same procedure for the outside and inside.

1. Use the torx anti-tamper tool bit provided to remove the tamper proof

screw from the top of the pushbutton housing (see gure 1).

2. Turn the knob clockwise to the stop position, then release.

3. Enter the existing combination. On new installations, enter the

factory-set combination: depress buttons 2 and 4 simultaneously

(release) , then depress button 3 (release). You should feel a click as each

button is depressed.

4. Insert the pick provided through the screw hole and depress the slide

inside—you will feel a slight click. Remove the pick (see gure 2).

5. Turn the knob clockwise all the way until it stops, then release.

6. Select a new combination, write it down, then enter the new

combination—press buttons carefully (a slight click should be felt as

each button is depressed) (see gure 3).

Note: You can use one button or all ve for a combination, but each button can

only be used once. You can press two or more buttons simultaneously as a step

in the combination.

7. Turn the knob clockwise once, all the way, until it stops, hold in position

and make sure the latch is retracted. Release the knob. Turn the knob

clockwise again to the stop position. At this point, the latch should not

retract unless you enter the new combination (see gure 4).

8. Replace the tamper proof screw in the top of the lock unit.

9. Repeat steps 1-8 for other side of door.

Note: If your lock is opening on every turn of the knob or lever, except upon entering a code, this may

be a ZERO CODE. Before attempting to remove the lock from the door, refer to the troubleshooting

procedures outlined at bottom of this document for a zero code symptom/solution.

KAA1162 0108

Troubleshooting

Symptom/problem: Turning outside or inside knob always retracts latch without depressing any

buttons.

Cause: Lock is in zero combination.

Solution: Follow the procedure for changing a combination (Step 14 on page 26 of your manual)

except omit step 3 (do not enter the existing combination).