Kangtai Electric 022 90022 (Remote control transmitter) User Manual 98157yingwen

Kangtai Electric Co.,ltd 90022 (Remote control transmitter) 98157yingwen

Contents

user manual 98157+90022-REV1

Wireless Doorbell ManualModel No.: Receiver：98157USA,98190USA Transmitter：90022Brief Introduction: It's applicable for home, office, factory, hotel and reception hall, making you not miss any visitor. Device Installation/UninstallationA. Device Installation/Uninstallation Plug the receiver in the mains and the device will be ready.Function DetailB1. Pairinga. After the receiver has been plugged in the mains and a sound of DingDong isheard, it means that the receiver has entered into the pairing mode, which will last for about 30 seconds; then press the button of the transmitter, when a sound of DingDong is heard, it means that the pairing process has been successfully made.b. 30 seconds after the receiver being plugged in the mains, make a simple pressthe "L" on the back panel and when a sound of DingDong is heard, it means the doorbell has entered into the pairing mode.B2. Melody Selection Every simple press on the "M" button on the back panel will lead to a melody shift in turn for the receiver. There are totally 16 melodies for selection.B3. Remove Pairing Memory When the doorbell is in the pairing mode, press the button inside the housing of the transmitter, and when a double "DingDong" is heard, it means the pairing memory has been successfully deleted.Techincal DataWorking Frequency: 433.92Mhz; Power Supply: 120V AC 60HzWorking Range: ≥ 40m in open area; Working Temperature: 0 ℃~ 35℃ ;Transportation and Storage Temperature: 0℃ ~ 50℃DingDongDingDongDingDongMelody SelectionDeleteCaution:This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:—Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.—Consult the dealer or an experienced radio/TV technician for help.(Receiver); CR2032 3VDC(Transmitter)Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

Navigation menu