Kenmore 11096428800 User Manual DRYER FEATURE SHEET Manuals And Guides 98070538

KENMORE Residential Dryer Manual 98070538 KENMORE Residential Dryer Owner's Manual, KENMORE Residential Dryer installation guides

User Manual: Kenmore 11096428800 11096428800 KENMORE DRYER FEATURE SHEET - Manuals and Guides View the owners manual for your KENMORE DRYER FEATURE SHEET #11096428800. Home:Laundry & Garment Care Parts:Kenmore Parts:Kenmore DRYER FEATURE SHEET Manual

Open the PDF directly: View PDF PDF.
Page Count: 4

_-_ D D DRYER OPERATING INSTRUCTIONS
m
I
OPERATING STATUS
KEYS
I
imml
I
_lJl LINT SCREEN
B SAFETY DOOR
SWITCH
_ ERFONM,_ICE
GUIDE LABEL
_MODEL NO. PLATE
ll]l YCLESELECTOR
CONTROL
BSTART
CONTROL
r r,
If you need SERVICE or PARTS for your Kenmore dryer:
Be ready to give your Sears Service Department the model number, serial number and date of
purchase. Write in below. The plate Uwith model and serial numbers is located behind the
dryer door. IM I
MODEL NO. SERIAL NO. DATE OF PURCHASE
i
ELECTRIC
MODEL 64281
GAS
MODEL 74281
How to dry a load of laundry
t_ Clean lint screen before each load. (_ Set Cycle Selector Control Ill.
Put laundry into dryer and shut _ Push the Start Controlll[I to start
the door. _ your dryer.
[_ Remove load when dry.
II I|
I::I mvNt fm r"a_
Ill Cycle Selector Control
Use this control to select the proper drying method for the type of
items in the load. The control can be set for Timed Drying or Air.
You can turn the control at any time to make drying time longer
or shorter or you can turn the control to an OFF position to shut
the dryer off.
El Start Control
Use this control to start the dryer. Be sure the door is closed.
Opening the door stops the dryer. It will not start again until you
close the door and push the START control. Be sure the Cycle
Selector Control is on a dry setting.
OPERATING STATUS KEYS
Color coordinated keys indicate in which portion of the cycle the
dryer is operating.
Partlqo. 3392332Rev. A
Ill CYCLE SELECTOR CONTROL
NORMAL Cycle
Use this cycle to get up to 120 minutes of drying time at high heat followed
by a5minute (approx.) cooldown.
• Set the Cycle Selector Control to the amount of time you want in the
Normal Cycle.
• Push the StartControl.
PERMANENT PRESS Cycle
Use this cycle to get up to 50 minutes of drying time at high heat followed
by a 10 minute (approx.) cooldown.
• Set the Cycle Selector Control to the amount of time you want in the
Permanent Press Cycle.
• Push the StartControl.
AIR DRY Cycle
Use this cycle to get up to 30 minutes of drying time in room temperature
air. Use this setting for items that will not tolerate heat, such as plastics,
foam rubber, etc. and for airing and fluffing items such as pillows.
•Do not dry these items with heat.
•Set the Cycle Selector Control for the number of minutes you want in the
Air Dry Cycle.
•Push the Start Control.
Cooldown
Approximately five or ten minutes before the end of the drying cycle,
clothes are tumbled without heat to help reduce wrinkles and make clothes
more comfortable to handle.
FEATURES
Ik']lLint Screen
Keep the lint screen clean. A lint-clogged screen will slow down the flow
of air. This makes drying time longer and wastes energy. Clean the lint
screen before each load as follows:
!. With dryer off, remove the screen by pulling straight up.
2. Roll the dry lint off the screen. Do not wet the screen or lint; wet lint is
hard to remove.
3. Replace the cleaned lint screen.
Fire Hazard.
Do not use your dryer while _e lint screen is removed.
It could cause overheating and possible damage to fabrics and dryer
parts or create a fire hazard. Lint screen must be pushed firmly into
place.
NOTE: If lint screen gets clogged by detergent or fabric softener build-up,
remove and clean it with a nylon brush, hot water and liquid detergent.
Dry and replace screen.
I! Safety Door Switch
For safety, the switch shuts off dryer when door is opened. Dryer will not
start until door is closed and START is pushed. Be sure the Cycle Selector
Control is on a dry setting.
IB Performance Guide Label
Located inside the dryer door. Gives information on what to do if dryer
does no.t perform normally.
NOTE:. If dryer drum is stained, clean it with a damp cloth and mild
detergent.
Model No. Plate
Shows model and serial numbers. Have these ready if you ever call for
service.
For more detailed drying times, rules for safe operation, fabric care,
maintenance and installation information, refer to the LAUNDRY
GUIDE and INSTALLATION INSTRUCTIONS you received with
your dryer.
Part No. 3392332 Rev. A Printed in U.S.A.

Navigation menu