Kenwood USA 29473120 UHF-FM Hand Held Transceiver User Manual Radio Frequency Safety Information

Download:
Mirror Download [FCC.gov]
Document ID	134751
Application ID	Sz0NyFTTUn34AF0ZT80q+A==
Document Description	Radio Frequency Safety Information
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	5.73kB (71638 bits)
Date Submitted	2001-01-31 00:00:00
Date Available	2001-02-20 00:00:00
Creation Date	2001-01-31 13:10:52
Producing Software	Acrobat PDFWriter 4.05 for Windows NT
Document Lastmod	2001-01-31 13:11:41
Document Title	Radio Frequency Safety Information
Document Creator	Adobe Acrobat PDF Link - 32
Document Author:	Celia

RADIO FREQUENCY SAFETY |NFORMATION
This KENWOOD transceiver has been tested and complies with the standards
listed below, in regards to Radio Frequency (RF) energy and electromagnetic
energy (EME) generated by the transceiver,
° FCC RF exposure limits for Occupational Use Only
0 FCC OET Bulletin 65 Edition 97-01 Supplement C
° American National Standards institute (C95.1 -— 1992)
~ American National Standards institute (095.3 — 1992)
This KENWOOD transceiver generates RF EME while transmitting. The transceiver has been designed
for and is classified as Occupational Use Only. This means you can use the transceiver only if you are
aware of the hazards of operating a transceiver and are familiar in ways to minimize these hazards. This
transceiver is not intended for use by the general public in uncontrolled environments.
The following list provides you with the information required to ensure you are
aware of RF exposure and of how to operate this transceiver so that the FCC RF
exposure limitations are not exceeded.
- While transmitting (holding the PTT switch), always keep the antenna at least
3 cm (1 3/16 inches) from your body, as well as from any bystanders.
° Do not transmit for more than 50% of the total transceiver use time; transmitting
over 50% of the total use time may exceed the limits in accordance to the FCC
RF exposure requirements. Nominal transceiver operation is 5% transmission
time, 5% reception time, and 90% stand-by time.
~ Use only the specified antenna for this transceiver; this may be either the
antenna provided with the transceiver or another antenna authorized by the
manufacturer.
° Use only KENWOOD authorized accessories (antennas, battery packs, belt
clips, etc).
To ensure that your expsure to RF EME is within the FCC limits for occupational use, you must observe
and adhere to the above points.
Electromagnetic Interference Compatibility
Electronic devices are susceptible to electromagnetic interference (EMl) if they are
not adequately shielded or designed for electromagnetic compatibility. Because this
transceiver generates RF energy, it can cause interference to such equipment.
0 Turn OFF your transceiver where signs are posted to do so. Hospitals and
health care facilities use equipment that is sensitive to electromagnetic radiation.
0 Turn OFF your transceiver while on board an aircraft when so instructed. Use of the
transceiver must be in accordance with airline regulations and/or crew instructions.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : Adobe Acrobat PDF Link - 32
Create Date                     : 2001:01:31 13:10:52
Author                          : Celia
Producer                        : Acrobat PDFWriter 4.05 for Windows NT
Modify Date                     : 2001:01:31 13:11:41-07:00
Page Count                      : 1

EXIF Metadata provided by EXIF.tools