Kenwood USA 322601 UHF FM Portable Transceiver User Manual B59 2546 00 TK 3102G indd

Kenwood USA Corporation UHF FM Portable Transceiver B59 2546 00 TK 3102G indd

Contents

Instruction manual RF Safety

Radio FRequency eneRgy SaFety inFoRmationThis Kenwood transceiver has been tested and complies with the standards listed below, in regards to Radio Frequency (RF) energy and electromagnetic energy (EME) generated by the transceiver.•  FCC RF exposure limits for Occupational Use Only.  RF Exposure limits adopted by the FCC are generally based on recommendations from the National Council on Radiation Protection and Measurements, & the American National Standards Institute.•  FCC OET Bulletin 65 Edition 97-01 Supplement C•  American National Standards Institute (C95.1 – 1992)•  American National Standards Institute (C95.3 – 1992)This Kenwood transceiver generates RF EME while transmitting.  RF EME (Radio Frequency Electric & Magnetic Energy) has the potential to cause slight thermal, or heating effects to any part of your body less than the recommended distance from this radio transmitter’s antenna.  RF energy exposure is determined primarily by the distance to and the power of the transmitting device.  In general, RF exposure is minimized when the lowest possible power is used or transmission time is kept to the minimum required for consistent communications, and the greatest distance possible from the antenna to the body is maintained.  The transceiver has been designed for and is classied for Occupational Use Only.  Occupational/ controlled exposure limits are applicable to situations in which persons are exposed to RF energy as a consequence of their employment, and such persons have been made aware of the potential for exposure and can exercise control over their exposure.  This means you can use the transceiver only if you are aware of the potential hazards of operating a transceiver and are familiar in ways to minimize these hazards.  This transceiver is not intended for use by the general public in uncontrolled environments.  Uncontrolled environment exposure limits are applicable to situations in which the general public may be exposed to RF energy, or in which the persons who are exposed as a consequence of their employment may not be fully aware of the potential for exposure or cannot exercise control over their exposure.The following list provides you with the information required to ensure that you are aware of RF exposure and of how to operate this transceiver so that the FCC RF exposure limitations are not exceeded.•  While transmitting (holding the PTT switch or speaking with VOX enabled), always keep the antenna and the radio at least 3 cm (1 3/16 inches) from your body or face, as well as from any bystanders.  A LED on the top of the radio shows red when the transmitter is operating in both PTT and VOX modes.•  Do not transmit for more than 50% of the total transceiver use time; transmitting over 50% of the total use time may exceed the limits in accordance to the FCC RF exposure requirements.  Nominal transceiver operation is 5% transmission time, 5% reception time, and 90% stand-by time.•  Use only the specied antenna for this transceiver; this may be either the antenna provided with the transceiver or another antenna authorized by Kenwood.Use only Kenwood authorized accessories (antennas, battery packs, belt clips, Speaker/ Mics or headsets etc.): When worn on the body, always place the radio in a Kenwood recommended clip or carrying case meant for this product. The use of other than recommended or approved body- worn accessories may result in RF exposure levels which exceed the FCC’s occupational/ controlled environment RF exposure limits.To ensure that your exposure to RF EME is within the FCC limits for occupational use, you must observe and adhere to the above points.Electromagnetic Interference CompatibilityElectronic devices are susceptible to electromagnetic interference (EMI) if they are not adequately shielded or designed for electromagnetic compatibility.  Because this transceiver generates RF energy, it can cause interference to such equipment.•  Turn OFF your transceiver where signs are posted to do so.  Hospitals and health care facilities use equipment that is sensitive to electromagnetic radiation.•  Turn OFF your transceiver while on board an aircraft when so instructed.  Use of the transceiver must be in accordance with airline regulations and/or crew instructions. B59-2546-00

Navigation menu