Kenwood USA 33063110 800 MHz APCO P25 Transceiver User Manual Safety Information Statement
Kenwood USA Corporation 800 MHz APCO P25 Transceiver Safety Information Statement
Contents
- 1. Instruction Manual
- 2. Safety Information Statement
- 3. Mandatory Safety Instructions
Safety Information Statement
RADIO FREQUENCY SAFETY INFORMATION _———___————-—_— This KENWOOD transceiver has been tested and complies with the standards listed below, in regards to Radio Frequency (RF) energy and electromagnetic energy (EME) generated by the transceiver. ~ FCC RF exposure limits tor Occupational Use Only FCC OET Bulletin 65 Edition 97-01 Supplement C American National Standards Institute (095.1 — 1992) American National Standards Institute (095.3 — 1992) This KENWOOD transceiver generates RF EME while transmitting. The transceiver has been designed for and is classified as Occupational Use Only. This means you can use the transceiver only if you are aware of the hazards oi operating a transce'wer and are familiar in ways to minimize these hazards. This transceiver is not intended for use by the general public in uncontrolled environments. The following list provides you with the information required to ensure you are aware of RF exposure and of how to operate this transceiver so that the FCC RF exposure limitations are not excee ed. 0 While transmitting (holding the PTT switch), always keep the antenna at least 1,2 an (1/2 in. ) from your body, as well as from any bystanders. - Do not transmit for more than 50% of me total transceiver use time; transmitting over 50% of the total use time may exceed the limits In accordance to the FCC FtF exposure requirements Nominal transceiver operation Is 5% transmission time, 5% reception time, and 90% stand-by time. 0 Use only the specified antenna for this transceiver; this may be either the antenna provided with the transceiver or another antenna authorized by the manufacturer. - Use only KENWOOD authorized accessories (antennas, battery packs, belt clips, etc): To ensure that your exposure to RF EME is within the FCC limits for occupational use, you must observe and adhere to the above points. Electromagnetic Interference Compatibility Electronic devices are susceptible to electromagnetic interference (EMI) it they are not adequately shielded or designed for electromagnetic compatibility. Because this transceiver generates FtF energy, it can cause interference to such equipment. - Turn OFF your transceiver where signs are posted to do so. Hospitals and health care facilities use equipment that is sensitive to electromagnetic radiation. - Turn OFF yourtransceiver while on board an aircraft when so instructed. Use of the transceiver must be in accordance with ainine regulations and/or crew instructions. 859-2269-00
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.2 Linearized : No Create Date : 2002:03:11 10:52:27 Producer : Xerox Document Center 440 Modify Date : 2002:03:11 10:56:01-07:00 Page Count : 1EXIF Metadata provided by EXIF.tools