Kenwood USA TKR-820N-3 User Manual 73060

Download:
Mirror Download [FCC.gov]
Document ID	73060
Application ID	GNme9C8qhjQ1qbwEmUlb6A==
Document Description	8
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	9.45kB (118065 bits)
Date Submitted	1999-12-02 00:00:00
Date Available	1998-11-06 00:00:00
Creation Date	2001-05-08 10:56:59
Producing Software	Acrobat Distiller 4.0 for Windows
Document Lastmod	2001-05-08 10:57:03
Document Title	73060.pdf
Document Author:	VicodinES /CB /TNN

an cator, Press this switch lor
repeater operation and the indicator light Leave
out the switch for lull duplex transceiver operation.
®MONI (monitor) swnch and indicator:
Defeats signaling decoder in the full duplex
transceiver mode, allowing the operator to check
lor traffic on the channel before transmitting. The
indicator lights when the MONl switch is pressed.
® Microphone Input Receptacle
® CHANNEL indicator (Multi channel version only)
Lights when the radio is turned UN. and indicates
operaring channel number.
®CHANNEL selector (Multi channel version only)
Roatary control knob for channel selection.
Rear panel
TKR~720
0 (Mum channel vevsion only)
(D Accessory connector
®TX antenna connector
(33 RX/Duplexer antenna connector
© DC input connector (Multi channel version only)
TKR-BZIJ .
©®®
(D Accessory connector
® TX/Duplexer'antenna connector
6) RX antenna connector
® 00 input connector (Multi channel version only)
. REPEATER OPERATION
Switch on the unit by pressan the POWER switch.
Press the REPEAT switch to turn the Indicator ON. The
unit transmits and translers message trom stations in
your own system automatically.
The TX light will light during transmission. You Will be
able to bear messages being translerred by turning the
VOL control clockwise if necessary
(Multi channel version only)
I TRANSCEIVER OPERATION
RECEIVE
Switch the unit ON by pressing the POWER switch ON.
Next, leave out the REPEAT switchito turn the REPEAT
immtor OFF. and adios! the volume and squelch
controls for the desired listening level.
NOTE
If your radio is programmed With {IT or DOT
signaling. there will be virtually no noise coming
trom the speaker even at full volume settin. You
will hear transmissions being made by other ra ios lN
YOUR SYSTEM ONLY!
It your radio is NOT PROGRAMMED with [IT or DOT
you Will hear ALL TRANSMISSIONS being made by
any stations using the channel. or if no one is using
the channel the radio will remain quiet.
To adjust the volume, depress the MONI switch. which
deleats the QT system (it so programmed), and allows
you to hear all activity on the channel. Set the volume
control for a comfortable listening level. and again
depress the MONI switch, allowing it to return to the
OFF position tor normal operation.
With the MONI switch in the OFF position. at system
programmed radios will ignore transmissions from
stations other than those in your system
Radios not programmed with QT wril
transmissions occurring on the channel,
from stations outside your own system.
At the first reception at a message “from your
dispatcher or another vehicle in your fleet, you may
wish to make a minor adjustment of your volume
control.
TRANSMIT
Calling another
verysimple:
First, listen for a lew seconds to make certain the
channel is not being used. The monitor switch may be
depressed to check for activity on the channel.
Squeeze the TRANSMIT switch and speak in your
normal speaking voice, FCC regulations require that
you identify the station you are calling. and your
station.
The TX light will light during transmission. When you
are through speaking, release the TRANSMIT switch.
and you are automatically back in the receive mode.
receive all
even those
station on your KEMWOOD radio is
I MICROPHONE
Plug the KENWOOD KMC-9 optional Microphone into
the Microphone Input Receptacle on the lront panel.
LOCK switch
MONlTDR swnch
TRANSMIT ancn
VHF REPEATEFIIUHF REPEATEFi
TKR-720/ 820
INSTRUCTION MANUAL
FCCWARNING
This equi ment generates or uses radio frequency
energy. C anges or modifications to this equipment
may ‘ cause harmtul interference unless the
modifications are expressly approved In the
instruction manual. The user could lose the authority
to operate this equipment it an unauthorized
change or modiiication is made.
WARNING
To prevent the or shock hazard, do not expose this
appliance to rain or moisture.
I BEFORE OPERATION
GOVERNMENT LAW PROHIBITS THE OPERATION OF
RADIO TRANSMITTERS WITHIN THE
TERRITORIES UNDER GOVERNMENT CONTROL
ILLEGAL OPERATION IS PUNISHABLE BV FINE OR
IMPRISONMENT OR BOTH.
REFER SERVICE TO A OUALIFIED LICENSED OR
CERTIFIED TECHNICIAN ONLV.
1. Please read this instruction manual carefully before
, placing your Repeater in service.
2. SAVE THIS INSTRUCTION MANUAL.
wnnmnc .
To prevent electric shock, tire and other iniury,
please note the iollowings: '
1. To ensure good ventilation, do not put anything
on top oi the cabinet.
2.To avoid risk oi electric shock, under no
circumstances should the unit be opened.
3." an abnormal smell or smoke is detected.
immediately turn the power off and pull out the
power pug. Contact the KENWOOD service
station or your dealer.
I INSTALLATION
Please consult your dealer tor installation of the
Repeater and antenna.
CAUTION
Do not place the unit, where it will be exposed to
direct sunlight or close to heating appliance. _
Do not place the unltrin areas 0 excessive dust, high
“tarnlEdliy or on unstablesurfaces, . 1
The following installation instructions are tor use by
your KENWOOD service tacility only.
l I\i:| V
I KENWOOD CORPORATION
FCC ID: AIHTKR—BZON—B
2.1033ic)(3) MANUAL
QPRINTED iN JAPAN eszooas-roix. MthCl
93l|21|1095765432| aziizioss7ssa
Carelully unpack the repeater. it is recommended that
you identity the items listed and check them on before
discarding the packing material. it any damage has
occurred to the equipment during shipment, file a
claim with the carrier immediately.
Equipment
Repeater ................... 1 ea.
Fuse (3A) (tor 120V) FOG-302405 . . . . 1 ea.
or
Fuse (LEA) (tor 220V) , . . . F05—1623A05 . . . 1 ea.
Fuse(10A) (tor TKR-820 Muiti channel version only)
F51-0016-05 . . . . 1 ea.
Fuse(15A) (for TKR-720 Multi channel version only)
F51-0017-05 . . . . 1 ea.
Coax. Cable (TKR—SZO only) E31-3391-05 . . . . 1 ea.
Power cable Ass’y (Muiti channel version only)
E30-2076-15 . . 1 ea.
Duplexer Bracket iTKR-BZO only)
J21-424B-04 . . . 2 ea.
Machine screw (TKR-BZI) only)
NOE-070405 10 ea.
Warranty card (U.S.A. only) ........... 1 copy
Instruction manual ...... 2-0066-x 1 sheet
I CONTROLS and FUNCTIONS
From Banal @ IMutti channel version only)
® (Mum channel mum only)
® POWER switch: Press to turn the unit 0M.
® SPEAKER: Front mounted tor best sound quality.
©PfiWER indicator: Lights when the unit is turned
0 .
® BUSY indicator: ON when channel is in use.
©TX indicator: Glows during transmit.
® TAKE OVER switch and indicator:
(with dealer optional We controller)
Press this switch when you will take over control
lrom the remote controller. it so equipped.
(D VOL control: Turn to about the 12 o‘clock position.
®SQL (Squelch) control: Squelch is activated when the
control is rotated clockwise. Further rotation sets
thr I aim" ‘ Jose noti decennine
re aer trigger level.

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.3
Linearized                      : Yes
Create Date                     : 2001:05:08 10:56:59
Producer                        : Acrobat Distiller 4.0 for Windows
Author                          : VicodinES /CB /TNN
Title                           : 73060.pdf
Modify Date                     : 2001:05:08 10:57:03-04:00
Page Count                      : 2

EXIF Metadata provided by EXIF.tools