Kenwood Trk 750 Owner S Manual TKR 750_850

If not then USA_LMR%5CTKR-750-850_B62-1327-20 Manual: ://inform3.kenwoodusa.com/Manuals/USA_LMR%5CTKR-750-850_B62-1327-20

TRK-750 to the manual 304c8857-4e36-03d4-d184-0672cd7fdd00

: Kenwood Kenwood-Trk-750-Owner-S-Manual kenwood-trk-750-owner-s-manual kenwood pdf

Open the PDF directly: View PDF .
Page Count: 2

Download
Open PDF In Browser	View PDF

VHF FM REPEATER/ UHF FM REPEATER

TKR-750/ TKR-850
INSTRUCTION MANUAL
THANK YOU!

KENWOOD CORPORATION
© B62-1327-20 (K,E)
09 08 07 06 05 04 03 02

NOTICES TO THE USER

We are grateful you purchased this KENWOOD repeater.
We believe this easy-to-program repeater will be highly
effective in your communications system, and will keep
personnel operating at peak efficiency.
KENWOOD incorporates the latest in advanced technology into all of our products. As a result, we feel strongly
that you will be pleased with the quality and features of
this product.

FEATURES

FCC WARNING

This equipment generates or uses radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
◆

GOVERNMENT LAW PROHIBITS THE OPERATION OF
UNLICENSED RADIO TRANSMITTERS WITHIN THE
TERRITORIES UNDER GOVERNMENT CONTROL.
◆ ILLEGAL OPERATION IS PUNISHABLE BY FINE OR
IMPRISONMENT OR BOTH.
◆ REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.

•

You can easily program channel data using the KPG-66D
software on a PC.

•

You can recall 1 of 16 preset channels using either a PF key
or the external control line.

UNPACKING AND CHECKING EQUIPMENT

•

The firmware can be written to the Flash memory through
an external source.

Note: The following unpacking information is for use by your KENWOOD
dealer, an authorized KENWOOD service facility, or the factory.

•

QT/DQT signalling can be programmed on each channel. It
simultaneously decodes up to 16 different QT/DQT tones.

•

The interface port can be used with external equipment,
such as a repeater controller.

•

The repeater has multi-mode capability.
Wide: 30 kHz/
Wide: 25 kHz/

•

Narrow: 15 kHz
Narrow: 12.5 kHz

(TKR-750; K type only)
(TKR-750/ TKR-850)

You can adjust the following functions from a PC:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•

Squelch
RX audio signal output (RA)
RX detector signal output (RD)
RX frequency
RF output power
Maximum deviation
TX audio input (TA)
Signalling deviation (TD)
DQT balance
QT deviation
DQT deviation
Test tone deviation
CW ID deviation
Repeat gain
TX frequency

Carefully unpack the repeater. We recommend that you
identify the items listed in the following table before
discarding the packing material. If any items are missing
or have been damaged during shipment, file a claim with
the carrier immediately.
Item
Hardware fixture
Front glass
Filter
Cushion
Cushion
Foot
Foot
Grommet
Handle
Screws
DC cord
Connector cable
Fuse
Warranty card (K type only)
Instruction manual

Part Number Quantity
J21-8402-X4
1
B10-2635-X4
1
B11-1259-X4
1
G13-1801-X4
4
G13-1802-X4
4
J02-0475-X5
2
J02-0492-X4
2
J59-0302-X5
2
K01-0418-X5
1
N35-3006-45
5
E30-3427-X5
1
E31-3228-X5
1
F05-1537-X5
1
—
1
B62-1327-XX
1

PRECAUTIONS

INSTALLATION

•

Do not expose the unit to rain or moisture; to prevent fire or
electric shock.

•

Do not open the unit under any circumstances; to avoid risk
of electric shock.

To install the handles onto the front panel of the repeater,
align the handles with the holes on the front panel, then
secure the handles using the supplied screws.

•

Do not expose the unit to long periods of direct sunlight, nor
place it close to heating appliances.

•

Do not place the unit in excessively dusty and/or humid
areas, nor on unstable surfaces.

•

If you detect an abnormal odor or smoke coming from the
unit, disconnect the power from the unit immediately.
Contact your KENWOOD service center or dealer.

Please consult your dealer for installing the repeater and
antenna.

MICROPHONE
Connect an optional KMC-30 (E type only), KMC-27A,
KMC-27B, or KMC-9C KENWOOD microphone to the
MIC jack on the front panel.

CONTROLS AND FUNCTIONS
q

■ Front Panel

q Speaker
w CH/STATUS Display
Two, 7-segment digits display the channel number
or status.
e VOLUME control
Rotate to adjust the volume.
t Power indicator
Lights green when power is applied from the DC
13.6V jack (DC 13.2V jack on E type versions).
Lights red when power is applied from the BACK
UP battery terminal.
q w

e r t

o iu y
y MIC jack
Connect a microphone to this 8-pin modular jack.
u Programmable Function keys
Press these keys to activate their programmable
functions.
i BUSY indicator
Lights green while a signal is being received.

r DC SOURCE switch

■ Rear Panel

w

o TX indicator
Lights red while transmitting.

e r

* The K type model is
shown in this diagram.

u
yt
q TX OUT jack
Connect a TX antenna or a duplexer to this receptacle.

r RX IN jack
Connect a RX antenna or a duplexer to this BNC
receptacle.

w CONTROL I/O jack
Connect an external programming device or repeater controller to this DB-25 interface.

t DC 13.6V (K type) / DC 13.2V (E type) jack
Connect a 13.6 V (K type) or 13.2 V (E type) DC
power supply to this jack.

e FUSE
Insert 15 A blade fuses into these fuse holders.

y BACKUP battery terminal

REPEATER OPERATION
Note: Please consult your dealer for programming the repeater.

When power is applied to the unit, the Power indicator
lights:
•

Green when using the main DC jack.

•

Red when using the Backup terminal.

Rotate the VOLUME control to adjust the volume.
The BUSY indicator lights green while receiving a signal
and the TX indicator lights red while transmitting.

u TEST/SPKR jack
Test input/output jack. Connect an external
speaker to this jack.

TRANSCEIVER OPERATION
■ Receive
Adjust the volume to your desired level. You may need
to readjust the volume when you receive a message
from your dispatcher or another member in your fleet.
• The BUSY indicator lights green while a signal is
being received.
■ Transmit
1 Listen to the channel before transmitting, to make
sure it is not being used.
2 Press the microphone PTT switch, then speak in
your normal speaking voice.
• FCC regulations require that you identify the
station you are calling as well as your own
station (your assigned call sign).
• The TX indicator lights red while transmitting.
3 When you finish speaking, release the PTT switch.



---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
Encryption                      : Standard V1.2 (40-bit)
User Access                     : Print, Copy, Annotate, Fill forms, Extract, Assemble, Print high-res
Create Date                     : 2004:10:27 05:07:08Z
Modify Date                     : 2004:11:19 11:08:07+09:00
Subject                         : Instruction Manual
Keywords                        : B62-1327-20_English
Page Count                      : 2
Creation Date                   : 2004:10:27 05:07:08Z
Mod Date                        : 2004:11:19 11:08:07+09:00
Producer                        : Acrobat Distiller 5.0.5 for Macintosh
Author                          : KENWOOD
Metadata Date                   : 2004:11:19 11:08:07+09:00
Creator                         : KENWOOD
Title                           : TKR-750_850
Description                     : Instruction Manual
Page Layout                     : OneColumn

EXIF Metadata provided by EXIF.tools