Keyless Ride KRVAR-002 AM/FM DUAL FUNCTION KEYFOB User Manual Elegant Fax

Users Manual

920 Rockmoor Drive

Georgetown, TX 78628

Phone: 877-619-3136

Fax: 208-475-6230

mike@keylessride.com

USER'S MANUAL INFORMATION

(PRELIMINARY)

The KeylessRide SRW-KRVAR002 is a replacement remote for original equipment and

aftermarket automotive keyless entry systems.

The features and functions associated with each of the six channels of the KeylessRide

remote are dependent on the year, make and model of the vehicle. Such functions include

remote control operation of the vehicle’s lock, unlock, horn, trunk, dome light, rear hatch,

remote start and power side door functions. The functions are activated by pressing the

corresponding button on the remote control. Selection from a variety of appropriately labeled

button pads which correspond to the features of the vehicle shall be used for function

identification.

The remote control may be configured to operate more than one receiver. To toggle between

receivers, press and hold switch 3 and 4 simultaneously for 1 second. The bi-color LED light

on the transmitter will change to a different color mode and momentarily flash 3X indicating

it has toggled to the next receiver. A user may toggle between receivers as often as necessary.

The battery is a single 3-Volt CR1632. Reduced effective range may be indicative of a low

battery condition. Simply replace the current battery with a new CR1632 replacement battery,

paying attention to the polarity marking on the remote control.

Pairing the remote control to a vehicle receiver is dependent on the year, make and model of

the vehicle(s). Programming the remote control to more than one receiver will require

programming it to the first receiver, then toggling (via simultaneously holding switch 3 and 4

for one second) to operate the next receiver and then programming it to the next receiver.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that

may cause undesired operation.

WARNING: Changes or modifications not expressively approved by the party

responsible for compliance could void the user's authority to operate the equipment.

9 2 0 R O C K M O O R D R I V E – G E O R G E T O W N – T X - 78628