Kid Riffic Toys 1846-R49 RC Car User Manual

Kid-Riffic Toys Ltd. RC Car

User Manual

Download: Kid Riffic Toys 1846-R49 RC Car User Manual
Mirror Download [FCC.gov]Kid Riffic Toys 1846-R49 RC Car User Manual
Document ID318003
Application IDDa4qeQHXJbqnbEIIY4D0DQ==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize8.67kB (108413 bits)
Date Submitted2003-04-15 00:00:00
Date Available2003-04-15 00:00:00
Creation Date2003-03-17 14:31:09
Document Lastmod2003-03-17 14:48:42
Document TitleUser Manual
Document CreatorHP 9100C Digital Sender
Document Author: ITS ELECTRIC TOY

OPERATING INSTRUCTIONS
Mini
Radio Control
Go Cart T”
BATTERY INSTALLATION FOR CONTROLLER
1. Unscrew the battery compartment cover of remote controllerwith a screwdriver. (Diagram 1)
2. Install 3 x 1.5V (AA-LRS) alkaline batteries with polarity as shown Inside battery compartment cover.
3. Screw on battery compartment cover.
TO PLAY
1. Screw antenna onto the remote controller.
2 Push the power switch of remote controllerto “ ON " position (Diagram 2).
3. Red LED on the remote controller will turn on to indicate that the unit is ready.
4. Install 4 x 1.5V (AAA—LEM) alkaline batterles Into the charger with polarity as shown
in (Diagram 3). To charge the vehicle, pull the extension plug from the charger and
plug ind) the contact point which is located at the bonom of the vehicle (Diagram 4).
Align the " V ‘ marldng on the plug to the " A ' marking next to the contact point for correct alignment
5. The green LED on the charger will light up when the vehicle Is in charging status. When it
goes out, the vehicle has completed charging . Disconnect the charger with the vehicle once
after the charging completed. Do not store the vehicle with the charger conneded.
6. Turn the steering wheel to adjust the direction ofdriving, (Diagram 5)
7. Pull the trigger to make the vehicle go forward.
8. Push the trigger to make the vehicle go backward.
9. Operate your vehicle in a dry, clean, fiat open area. Avoid sand and water.
10A If vehicle does not respond to remote controller, try to operate the vehicle at a closer range
' ‘ (T he normal operating range is around 2m—5m).
11. Turn the power switch to " OFF “ position when unit is not in use.
WARNING:
Changes or modifications to this unit not
expressly approved by the party responsible
for compliance could void the users authority
to operate the equipment
NOTE:
This equipment has been tested and found to .
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable _
protection against harmful interference in a
residential installation. This equipment -
generates, uses and can radiate radio frequency '
energy and, if not installed and used in '
awordence with the Instructions. may cause
harmful Interference to radio communications.
BATTERY PRECAUTIONS:
Non-rechargeable batteries are not to be recharged
- Rechargeable batteries are to be removed
from the toy before being charged (if removable).
Rechargeable batteries are only to be charged
under adult supervision (it removable}
Different types of batteries or new and used
batteries are not to be mixed.
Only batteries of the same or equiwalent type
as recommended are to be used.
Batteries are to be Inserted with the correct
nuiafitx
Exhausted batteries are to be removed from
the toy.
The supply terminals are not to be short-circuited.
Check and replace batteries periodically to prevent
corrosion
Keep unit away from extreme heat.
- Do not dispose of batteries in fire, batteries may
explode or leak.
However. there is no guarantee that interference will not ocmr in a particular installation,
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment on and on, Ihe user is encouraged to try to
correct the Interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and maelver,
- Connect the equipment into and outlet on a circuit different from that to which the receiver is needed.
— Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules,
Operalion is subject to the following two conditions:
1. This device may not cause interference, and
Z This device must accept any interference, including interference that may cause undesired operation.
Hereby, Kid—Rim Toys Lid. declares that this Micro RIC Go Cert " is In compliance with the essential
requirements and other relevant provisions ofDIrective 1999/5/50,
0 2003 Kid-Rifle Toys Ltd.
All Rights Ruerved.
63430 Olive Blvd”
St. Louis, MO 63132, USA
vwvw.KiD»RiFFiC.com
Toll Free No: 1458-5654 777
MADE IN CHINA
A WARNING:
CHOKIIIG HAZARD - Small parts.
, thlorchiidrerr under 3 rear: ‘
. _ unseat;
arm-m 1
arm-m s

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.2
Linearized                      : No
Creator                         : HP 9100C Digital Sender
Create Date                     : 2003:03:17 14:31:09
Author                          : ITS ELECTRIC TOY
Producer                        : 
Title                           : 
Subject                         : 
Modify Date                     : 2003:03:17 14:48:42+08:00
Page Count                      : 1
EXIF Metadata provided by EXIF.tools
FCC ID Filing: QFU-1846-R49

Navigation menu