Kid Riffic Toys 21802-R49 RC Car User Manual
Kid-Riffic Toys Ltd. RC Car
User manual
OPERATING INSTRUCTIONS BATTERY lNSTALlATiON FOR CONTROLLER 1. Unscrew the battery compartment cover of remote controller with a screwdriver. . 2. Install 3 x "AA“ (1 .5V) alkaline batteries with polarity as shown inside battery compartment. 3. Screw on battery compartment cover. TO PLAY 1. Screw antenna onto the remote controller. 2. Push the power switch of remote controller to 'ON" position. at Red LED on the remote controller will turn on to indicate that the unit is ready. 4 Pull the extension plug of remote controllerto plug in the contact point which is located at the bottom of the vehicle for . charging battery. ed LED on remote controller will turn on when unit is in charging status. 6. Charge for approximate 45 seconds with 2 minutes running. 7. Extend the antenna of controller for having a better reception. 8. Turn the steering wheel clockwise, turn the vehicle wheel right. St Turn the steering wheel counter-clockwise, turn the vehicle wheel left. 10. Pull the trigger to make the vehicle go forward. 1 1 . Push the trigger to make the vehicle go backward. 12. Operate your vehicle in a dry, clean, flat open area Avoid sand and water. 13. if vehicle does not respond to remote controller, try to operate the vehicle at a closer range (The normal operating range is around 2m - 5m). 14. Adjust the driving turning angle by turnlng the white regulator which located at the bottom upper portion of the vehicle. 15.A slot is provided to fasten vehicle on the controller, then with belt clip that player can carry It all around. 16.Turn switch of remote controller to “Ofl‘ position when unit is ( a not in use. MPLIANCE WITH FCC REGULATIONS BATTERY PRECAUTIONs (VALID IN US. ONLY - VALABLE AUX E. - Do not use rechargeable batteries -U. SEULEMENT) - DO not anamptto recharge the This device complies with Part 15 FCC batteries. Flules Operation of this device is sublect - Do not mix old and new batteries to the following two conditions: - Do not mix alkaline, standard (1) This device may not cause harmful (carborrzinc) or rechargeable Interference. (nickel-cadmium) batteries. (2) This device rrmst accept any harmeI - Do not short circuit battery contacts interference that may cause undesired - When not in use, remove batteries operation. to prevent possible leakage. This device generates and uses radio - Exhausted batteries are to he frequency energy and if not used properly removed from the game unit - Do not dispose of batteries in fire. may cause interference to radio and batteries may awlode or leak. television reception, It has been tested and found to comply with the Ilmlts set by the FCC which are designed to provide reasonable protection against such Interference. CAUTION: FCC Regulations state that changes or modifications to this product not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. (VALID FOR CANADA ONLY ~ VALABLE AU CANADA SEULEMENU This device complies with Piss-210 of Industry Canada Operation ls subject to the following two conditions: (1) This device may not cause harmful interference. © 2002 Kld-Fllffio Toys Ltd. All Rights Reserved. Patent Pending BS48C Olive Blvd., SL Louis. Md. 63132, USA - 5-1777 (2) This device must accept any harmful infariersnce that may cause undesired operation. See Point 5 ' Printed in Hong Kong ITEW 21805 Made in China ‘_ OPERATlNG INS-ravenous Warning: changes“ or modifications to this unit not expressly approved by the party reeponsible for compliance could'vnid the user’s authority to operate the equipment. NOTE: 11115 equipment had been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC v Rules. These limits are designed to provide reasonable protection against harmiful Interference -ln a residential installation. This" equipment generates, uses and can radiate radio frequency, may cause harmful interference to radio communiutlone. , ' However, there is no generate that Interference will not occur in a particular installation. if this equipment does cause harmful interference tolradlo or television reception, which cin be determined by tuning the equipment off and on, the user is encouraged to try to correct the Interference by one or more of the following measures: l Reorient or relocate the receiving antenna; 0 increase the separation between the equipment and receiver. 0 Connect the‘ equipment into an outlet on a circuit different from that to which the receiver ls needed. . v - Consult the dealer or an experienced radioITV technician for help. Print in China
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No Modify Date : 2002:07:19 19:47:40+08:00 Create Date : 2002:07:16 19:19:26+08:00 Creator : Acrobat 4.0 Scan Plug-in for Windows Producer : Acrobat 4.0 Scan Plug-in for Windows Page Count : 2EXIF Metadata provided by EXIF.tools